What are the requirements for applying for a Class B driver's license?

1 Answers
KingstonLee
07/30/25 3:50am
Here are the requirements for applying for a Class B driver's license: Age: Must be at least 21 years old and under 50 years old. Height: For large vehicles, the height must be above 1.55 meters. Residence: Must study in the place of residence (within the scope of the household registration location, prefecture-level city), and cannot study in a temporary residence. Driver's license requirements: You can apply directly, or you can upgrade to a B2 license after holding any driver's license for at least 1 year. Violation record requirements: For A1, A2, and B1 licenses, there must be no accidents causing death due to full or primary responsibility, no record of drunk driving (alcohol concentration greater than 80mg), and no record of speeding over 50% or drunk driving (alcohol concentration greater than 20mg and less than 80mg) during the current and the last three consecutive scoring cycles; B2 licenses are not subject to these restrictions.
Was this review help?
14
5
Share
More Forum Discussions

What are the dimensions of the T-Roc?

The T-Roc has a length of 4318mm, a width of 1819mm, and a height of 1582mm, with a wheelbase of 2680mm. Below is some information about the T-Roc: 1. Powertrain: The T-Roc is equipped with the EA211 1.4TSI engine, available in two variants with high and low power outputs, delivering maximum power of 131 horsepower and 150 horsepower respectively. Additionally, the high-end models come with a full-time four-wheel-drive system. 2. Transmission: It offers a DQ200 7-speed dry dual-clutch transmission (for front-wheel-drive models) and a DQ381 7-speed wet dual-clutch transmission (for four-wheel-drive models).
15
2
Share

What to Do When One Side of the Car Falls into a Ditch and Gets Stuck?

Here are the solutions for when one side of the car falls into a ditch and gets stuck: 1. If all wheels fall into the ditch: If road conditions permit, you can use another vehicle to pull the stuck car out; if the road is soft, you can first deflate the tires of the stuck vehicle to increase the contact area between the tires and the ground before proceeding with the rescue. 2. If only one wheel falls into the ditch: You can use a jack to lift this wheel, place a hard object underneath, and then slowly drive forward in a low gear. 3. You can find a fixed point in front of the vehicle to tie a steel rope to secure the car, reducing secondary damage caused by lateral sliding during the rescue.
3
2
Share

Does the Cruze have ISOFIX interfaces?

2012 and later model year Cruze vehicles have ISOFIX interfaces, while pre-2012 models do not. It utilizes a rigid connection fixation system, enhancing safety and stability. Below are detailed explanations about the Cruze's ISOFIX interfaces: 1. The Cruze's child safety seat ISOFIX interfaces are located at the back of the seat. Although there are only two connection points, it employs rigid buckles for hard-link fixation, improving both reliability and connection strength. 2. The drawback is that child seats using this interface tend to be slightly more expensive. Due to the rigid linkage, the child seat and the vehicle body are integrated as one.
19
5
Share

Differences Between Single-Cylinder and Twin-Cylinder Engines

Single-cylinder and twin-cylinder engines mainly differ in the following aspects: 1. Grade: A single-cylinder engine has only one cylinder, featuring a simple structure and lower cost, but with slightly more vibration and noise; a twin-cylinder engine has two cylinders, offering better stability, lower vibration and noise, but at a higher price, making it a grade above the single-cylinder. 2. Power: A single-cylinder engine delivers stronger burst power at low to medium RPMs compared to a twin-cylinder engine of the same displacement, making it better for acceleration during starts and at low speeds. However, twin-cylinder engines can more easily reach higher RPMs, making them suitable for large-displacement motorcycles. 3. Fuel Consumption: A single-cylinder engine is more fuel-efficient than a twin-cylinder engine of the same displacement.
20
3
Share

What are the symptoms of a dirty fuel filter in a car?

When the fuel filter is too dirty, the following conditions may occur: 1. Difficulty starting when the engine is hot: A dirty fuel filter can cause clogging, making it difficult to start the car even when the engine is warm. 2. Reduced car power: A clogged fuel filter can lead to low fuel supply pressure and decreased engine performance. 3. Car shaking while driving: A clogged fuel filter can lower the fuel injection pressure, causing the air-fuel mixture to become lean and resulting in incomplete combustion, which makes the car shake while driving. 3. Idle shaking: When the fuel filter begins to clog, it can cause insufficient fuel pressure, making fuel supply increasingly difficult and leading to car shaking at idle.
10
4
Share

Can People Without a Driver's License Buy a Car?

People without a driver's license can buy a car, but they cannot drive without a license. Here is some information about buying and driving a car without a driver's license: 1. Buying and registering a car without a license: People without a driver's license can not only buy a car but also register it under their name. According to relevant regulations, registering a car requires providing the invoice, certificate of conformity, proof of purchase tax payment, the owner's ID card, and a copy of the compulsory insurance policy at the vehicle management office. 2. Driving without a license is not allowed: According to the "Road Traffic Safety Law of the People's Republic of China," "driving a motor vehicle without a license is punishable by a fine of 200 to 2,000 yuan and may also be subject to detention for up to 15 days."
3
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.