What are the required length and width dimensions for a tractor-trailer parking space?

Why Does the BMW Steering Wheel Suddenly Pull to One Side?

When the car is driving straight but the steering wheel pulls to one side, the first thing to check is whether the hydraulic oil is dirty. Daily steps for owners to check if the car is pulling to one side: Ensure that the tire pressure in all four tires is exactly the same. On a straight and level road, when the car maintains a straight path, the steering wheel should be centered, and the car should not pull to either side; this indicates that the car is functioning normally. If the car does not pull to either side on a straight road but the steering wheel is not aligned properly, this has nothing to do with wheel alignment. Simply adjusting the length of the left and right tie rods on the steering gear can resolve the issue. If the car pulls to one side while driving on a straight road, requiring the driver to turn the steering wheel to one side to correct the deviation, this indicates a problem with the wheel alignment. The function of the car steering wheel: The steering wheel is a wheel-shaped device used to control the direction of cars, ships, airplanes, etc. Its function is to convert the force applied by the driver to the edge of the steering wheel into torque, which is then transmitted to the steering shaft. Initially, cars were controlled using a tiller. However, this design transmitted the intense vibrations from the road to the driver, making it difficult to control the direction. After the engine was moved to the front of the car, the increased weight made it impossible for the driver to continue using the tiller. The steering wheel was thus invented, introducing a gear system between the driver and the wheels that is flexible to operate and effectively isolates the intense vibrations from the road. Moreover, a good steering wheel system can also provide the driver with a close connection to the road.

12

4

Share

What Causes the Gearbox Noise and Jerking in Emgrand GS?

Reasons for gearbox noise and jerking in Emgrand GS: damaged solenoid valve, burnt steel plates and friction plates, and failure to replace transmission fluid regularly. Damaged Solenoid Valve: If the oil pressure solenoid valve is damaged, it can cause the oil pressure to be too low or too high, resulting in a sense of impact or lag when the clutch and brake engage. Similarly, if the shift solenoid valve gets stuck, the effect is more direct and noticeable. It prevents the clutch from quickly disengaging when it should or engaging when it should, leading to power interruption and causing the driver to feel jerking. Burnt Steel Plates and Friction Plates: If the gear shifts from 1st to 2nd and 2nd to 3rd are normal, and other gears also function properly, but there is jerking specifically when shifting from 3rd to 4th, the cause of the issue is quite clear. It is likely due to slippage in the clutch or brake responsible for 4th gear. Of course, solenoid valve failure should first be ruled out, as the solenoid valve can be easily measured and inspected after removing the oil pan. Burnt clutch plates not only cause jerking during gear shifts but also lead to a lack of power in the vehicle. The debris from the worn friction plates can further contaminate the transmission fluid, worsening the condition. Failure to Replace Transmission Fluid Regularly: If the automatic transmission is not maintained for a long time, the performance indicators of the transmission fluid, such as lubricity, viscosity, and thermal stability, will significantly decline. Particularly, the temperature of the automatic transmission fluid can rise if the radiator is too dirty to dissipate heat effectively. When the computer detects high temperatures, it will enter an emergency operation mode, forcing an upshift (locking the gear and driving in a specific gear). This can lead to situations where the vehicle does not accelerate despite pressing the throttle, experiences dragging sensations, or jerking. When the oil temperature exceeds 135°C, it can cause significant damage to components like the friction plates and clutch plates.

1

4

Share

What is the maximum wading depth of the Mercedes-Benz GLC260?

According to official information, the maximum wading depth of the Mercedes-Benz GLC260 is 600mm. Common tire specifications are 235/55R19, with a body length of 4764mm, and it is a 5-door, 5-seat SUV. The maximum wading depth refers to the deepest water level a vehicle can safely pass through. Generally, the maximum wading depth for sedans does not exceed 30 centimeters, while SUVs have a higher maximum wading depth, but it is still best not to exceed 50 centimeters. Among common models, the GAC Trumpchi GS8 has a maximum wading depth of 30 centimeters, the Audi A4 has a maximum wading depth of 32 centimeters, the Volkswagen Sagitar has a maximum wading depth of 30 centimeters, the Land Rover Range Rover has a maximum wading depth of 90 centimeters, the Jeep Compass has a maximum wading depth of 48 centimeters, and the Highlander has a maximum wading depth of 45 centimeters. The maximum wading depth of SUVs is significantly higher than that of sedans. Generally, when a vehicle is wading through water, different measures should be taken by the owner depending on the depth and the vehicle's characteristics, as follows: If the wading depth reaches the height of the exhaust pipe, it is relatively safe. Even if water enters the exhaust pipe, the pressure inside is sufficient to expel the water. As long as the engine is not turned off in the water, water will not flow back into the vehicle. If the wading depth reaches the height of the door frame, it becomes more dangerous. The vehicle's circuits, electronic components, and sensors are mostly concentrated at the bottom of the car, which could lead to circuit disconnection, damaging critical electrical components and preventing the car from starting normally. If the wading depth reaches the height of the intake pipe, it is extremely dangerous. Driving directly into such a water depth could cause the vehicle to stall immediately, resulting in permanent damage to the engine or rendering it unusable.

20

4

Share

Should You Use 92 or 95 Octane Gasoline During the Vehicle Break-in Period?

Whether to use 92 or 95 octane gasoline during the vehicle break-in period should be determined based on the recommendations in the official car owner's manual. In addition to checking the appropriate gasoline grade in the owner's manual, you can also find it on the fuel tank cap, which is usually labeled. Typically, the gasoline grade can also be determined by the engine's compression ratio. Cars with an engine compression ratio between 8.6-9.9 should use 92 octane gasoline, while those with a compression ratio between 10.0-11.5 should use 95 octane gasoline. If the compression ratio is higher, 98 octane gasoline is recommended. However, with the use of some new technologies, the gasoline grade cannot be solely determined by the compression ratio. High compression ratio engines can also be tuned to use lower octane gasoline because, apart from the compression ratio, other factors such as ignition timing, turbocharging technology, and Atkinson cycle technology also play a role. Generally, the higher the gasoline octane number, the higher the octane value and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane. Occasionally using the wrong gasoline grade only requires switching back to the correct grade after the tank is empty. However, long-term use of the wrong gasoline grade can have the following effects: For vehicles recommended to use lower octane gasoline, using higher octane gasoline will not cause damage, but the increase in octane value will change the fuel's ignition point, leading to delayed combustion in the engine. This means the engine's power output and thermal efficiency will decrease, resulting in poorer performance. For vehicles recommended to use higher octane gasoline, using lower octane gasoline can cause engine knocking. Because the octane value is too low, the gasoline's ignition point decreases and it may ignite prematurely during the compression stroke. If combustion occurs before the spark plug ignites, resistance will arise during the upward stroke. This resistance can make the engine run very unstably. If the knocking is mild, it may only increase noise without significant damage to the engine. However, if the knocking is severe, it indicates serious engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in severe cases, cylinder scoring.

9

2

Share

What are the hybrid models available?

Hybrid models include: Toyota Camry, Honda Accord, Spirior, BYD Song, Audi A8, Q5, Toyota Corolla, Levin, Lexus ES, BYD Qin, Geely Borui GE, Honda CR-V, Buick Regal, LaCrosse, Ford Mondeo, Cadillac XT5, Malibu XL, Nissan Murano, Lincoln MKZ, Acura CDX, etc. Hybrid vehicles offer high fuel economy and superior driving performance. Their engines use fuel, but with the assistance of an electric motor during startup and acceleration, fuel consumption can be reduced, resulting in lower fuel costs compared to similarly sized conventional vehicles.

2

1

Share

What are the four wires of a motorcycle ignition switch?

Motorcycle ignition switch has four wires: positive input, positive output, negative power supply, and kill switch wire. The following details these four wires: 1. Red wire: positive input, the thin wire with a fuse coming from the battery. 2. Black wire: positive output controlled by the key, forming a closed circuit with the red wire to supply power to all vehicle electrical components. 3. Green wire: negative power supply. 4. Black/white wire: kill switch wire controlled by the key, forming a closed circuit with the green wire to control the ignition system for engine shutdown.

13

5

Share

What are the required length and width dimensions for a tractor-trailer parking space?

Why Does the BMW Steering Wheel Suddenly Pull to One Side?

What Causes the Gearbox Noise and Jerking in Emgrand GS?

What is the maximum wading depth of the Mercedes-Benz GLC260?

Should You Use 92 or 95 Octane Gasoline During the Vehicle Break-in Period?

What are the hybrid models available?

What are the four wires of a motorcycle ignition switch?

Can You Still Drive with a Bulging Tire?

How to Determine When the Car is Fully Parked in Reverse Parking?

How to Replace the Wiper Blades on the X-Trail?

What is the difference between B2 and B1 driver's licenses?