What are the reasons why used Honda Jade is difficult to sell?

1 Answers
SanDaniela
07/30/25 9:47am
Here are the reasons why used Honda Jade is difficult to sell: 1. Throttle maintenance issues: The throttle body tends to get dirty, manifesting as idle speed shaking every few seconds, with more noticeable symptoms when the AC is on. It's recommended to clean the throttle body with foam cleaner and perform throttle matching after cleaning. 2. Belt oil leakage: The belt tensioner has oil seepage issues, which may affect component performance in the future. 3. Right engine mount problem: Similar to the Civic, this is a common quality issue with the component, characterized by metallic knocking sounds from the front passenger side when going over speed bumps or making sharp right turns during quick starts. 4. LCD screen leakage: The LCD screen is prone to liquid leakage. If this occurs, report for repair immediately without hesitation.
Was this review help?
11
2
Share
More Forum Discussions

Is Cylinder No. 1 the First Cylinder?

In inline engines, the cylinder at the pulley end is generally the first cylinder. Cylinder Adjustment: First, loosen the adjustment screws of each cylinder by 1-2 turns. Rotate the first cylinder to the top dead center of the compression stroke, aligning the '0' mark on the flywheel with the inspection pointer on the engine block. At this point, the intake and exhaust valves of the cylinder are closed, allowing for gap adjustment. The intake and exhaust valve heads are directly located in the combustion chamber, and the entire exhaust valve head is situated in the exhaust passage, thus being exposed to very high temperatures. Methods to Identify Non-Functioning Cylinders: Using a diagnostic computer is more direct and accurate than physical judgment. Older models required shorting pins in the OBD interface and reading codes with a test light, but now there are specialized or universal diagnostic computers available, making computer-based diagnostics convenient and accurate.
16
0
Share

What does it mean to turn off four-wheel drive?

Four-wheel drive being turned off indicates that the current driving conditions do not require four-wheel drive mode, and two-wheel drive is sufficient. Meaning of two-wheel drive: Two-wheel drive means that only two wheels are driven, typically either front-wheel drive or rear-wheel drive, while four-wheel drive means all four wheels can be driven, allowing both the front and rear wheels to drive simultaneously. Four-wheel drive: Four-wheel drive has advantages when driving on poor roads, such as when the front wheels slip, the rear wheels can take over. It is suitable for off-road driving but consumes more fuel. In contrast, two-wheel drive is more suitable for city commuting, offering lower fuel consumption compared to four-wheel drive vehicles, but with inferior off-road performance.
5
4
Share

Can traffic violation points for a car be deducted by someone else?

Driver's license points cannot be deducted by others. Point deduction is a management measure for drivers who violate traffic rules, aiming to reduce traffic violations. Having someone else deduct points goes against the original intent of this management approach, disrupts normal traffic management order, and violates the principle of fairness in the Administrative Penalty Law. Accumulating 12 points: If a motor vehicle driver accumulates 12 points within a scoring cycle, the traffic management department of the public security organ shall confiscate their motor vehicle driver's license. The driver must, within fifteen days, attend a seven-day study session on road traffic safety laws, regulations, and related knowledge at the traffic management department of the public security organ where the driver's license was issued or where the violation occurred. Taking the test promptly after the study session: After attending the study session, the vehicle management office shall administer a test on road traffic safety laws, regulations, and related knowledge to the driver within twenty days.
1
4
Share

Can Diesel Be Used to Clean the Inside of an Engine?

Diesel should not be used to clean the inside of an engine. Methods for cleaning the engine compartment: After the car has cooled down, you can use a brush to remove dust from these components, being careful not to apply too much force to avoid damaging the circuit boards. Then, spray the purchased cleaner onto these parts, taking care not to spray it onto the circuit boards to prevent short circuits. Finally, gently wipe everything with a cloth. Avoid rinsing with water: For new cars, a high-pressure water gun can be used when cleaning the engine compartment. However, for older cars, even though the engine compartment is insulated, there is still a risk of causing a short circuit somewhere.
16
3
Share

Why is the motorcycle power light not working?

Why is the motorcycle power light not working? New headlights may have excessive moisture inside, poor sealing, or damage. Excessive moisture inside the headlight: Due to high humidity inside new headlights, when the headlights are turned on and heat up, then encounter rain or car wash cooling, it is easy for fog to form inside the headlight. Additionally, the headlight housing has breathing holes, and sometimes temperature differences cause internal pressure variations, allowing humid air to enter through these holes. When there is a temperature difference between hot and cold, fogging may occur. Poor sealing or damage to the headlight: If there is obvious moisture inside the headlight cover and it does not dissipate after turning on the lights, it may be due to poor sealing or damage to the headlight. It is recommended to check the installation of the bulb and the headlight cover. If necessary, remove the headlight assembly and inspect the sealing and damage from the outside to the inside.
6
2
Share

Can a seat belt reminder be installed additionally?

Seat belt reminder can be installed additionally. Main functions of seat belts: The primary functions of shoulder belts and lap belts are to cushion the forward or backward inertia of occupants during an accident, keeping them secured to the seat as much as possible. When properly worn, the shoulder belt should cross the chest cavity, and the lap belt should fit snugly against the hip bones. Avoid friction: When using seat belts, be careful not to let them rub against sharp-edged tools to prevent damage. Do not tilt the seat backrest too far, otherwise the seat belt may not extend and retract properly. When the seat is unoccupied, retract the seat belt into the retractor to prevent the buckle from hitting other objects during emergency braking.
15
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.