···
Log in / Register

What are the reasons why the Wuling Hongguang remote key cannot lock the car door?

3 Answers
AlanMarie
08/27/25 6:24am
Wuling Hongguang remote key cannot lock the car door for the following reasons: Insufficient battery power: Insufficient battery power in the remote key may cause the key light to flash, but the door cannot be locked. Low battery power and voltage can lead to unstable circuit performance, resulting in a shortened wireless communication range. In this case, you can try locking the car by getting closer to the vehicle. If necessary, simply replace the battery. Interference from magnetic fields: The remote key operates in two radio frequency forms: short-range infrared remote sensing and short-range wireless radio frequency. Regardless of the form, both the transmitting and receiving circuits are prone to malfunction. Both short-range infrared remote sensing and short-range wireless radio frequency are highly sensitive to high-power radiation interference. Therefore, when using the remote key, it is best to stay away from high-power devices and other communication equipment to prevent strong magnetic fields from affecting communication, which may result in failure to receive signals and lock the car door.
Was this review help?
13
1
Share
LaKhloe
09/09/25 5:17am
I've been driving a Wuling Hongguang for over ten years, and remote locking failures are quite common. At first, it was startling, but then I realized it was due to the remote control battery aging—after two years of use, the power was insufficient, and the signal couldn't be transmitted. Another common issue is when a door isn't closed properly, like the trunk or a door left slightly ajar. The sensor mistakenly thinks it's open and prevents locking. I've also experienced locking failures at gas stations due to interference from nearby Wi-Fi routers or mobile phones, which disrupt the signal receiver's ability to pick up commands. Occasionally, the key button might fail to respond due to worn internal contacts or water damage causing a short circuit. Solutions? First, try replacing the battery—it only costs a few dollars. Also, check if all doors are securely closed and avoid areas with dense electronic devices. If the problem persists, it might be a fault in the vehicle's signal module, requiring a repair shop to diagnose with specialized tools. Don't delay, as it could lead to more serious issues like sudden failure to start. For routine maintenance, inspect the remote and door system every six months to avoid breakdowns on the road.
Was this review help?
1
5
Share
Expand All
RobertRose
10/23/25 6:08am
As someone who enjoys tinkering with automotive electronics, when the remote lock of my Wuling Hongguang fails, I would first open the key to check the circuit board for burn marks or cold solder joints. Often, the issue is due to worn-out micro switches causing button failure. Another possibility is that the receiving antenna on the vehicle is misaligned or blocked by metal objects, leading to poor signal reception. Interference sources are also critical, such as strong magnetic environments or mobile phone base stations disrupting frequency matching. Additionally, consider the possibility of lost key programming—if the battery dies suddenly and remains dead for too long, the system may reset and require reprogramming. Blown fuses or loose wiring connections could also interrupt the circuit. For DIY solutions, purchase a universal remote to test button functionality, then replace the battery or clean the contacts if confirmed. If DIY efforts fail, it's necessary to inspect the vehicle's central locking control module and use professional diagnostic tools to avoid increasing the risk of short circuits. To prolong the key's lifespan and reduce the likelihood of malfunctions, avoid storing it in high-temperature or humid environments.
Was this review help?
13
2
Share
Expand All
More Forum Discussions

Are Brake Pads Different for Front and Rear?

Automobile brake pads are indeed different for the front and rear. Generally, the front brake pads of a car are larger than the rear ones, and the front and rear brake pads cannot be used interchangeably. The front brake pads wear out faster than the rear ones, so they need to be replaced more frequently. The rear brake pads are more durable. Although the front and rear brake pads are made of the same material, the front brake pads are usually more expensive than the rear ones. The replacement interval for front brake pads is typically between 30,000 to 60,000 kilometers, while the rear brake pads should be replaced every 60,000 to 100,000 kilometers. Car owners should inspect the brake pads every 5,000 kilometers. If the brake pads are thinner than 5mm, they should be replaced promptly to avoid affecting vehicle performance. Brake pad maintenance methods include: high-temperature protection to prevent corrosion of the braking system, cleaning oil stains from brake discs, brake drums, and brake pads, ensuring proper heat dissipation of the brake discs, regular replacement of brake fluid, and periodic checks of the thickness of brake pads or brake shoes.
17
3
Share

Can I deduct points the day before my driver's license points are about to expire?

No. 1. If there are unpaid fines, the points will carry over to the next cycle: The cumulative scoring cycle for road traffic safety violations is 12 months, with a maximum of 12 points, calculated from the date the motor vehicle driver's license is first issued. If a motor vehicle driver's points do not reach 12 points within a scoring cycle and the fines have been paid, the points will be cleared; if the points do not reach 12 points but there are still unpaid fines, the points will carry over to the next cycle. 2. Accumulating 12 points requires attending relevant knowledge education: If a motor vehicle driver accumulates 12 points within a scoring cycle, their driver's license will be detained by the public security traffic management department. The motor vehicle driver must report to the traffic management department of the public security authority at the place where the driver's license was issued or where the violation occurred within 15 days to receive seven days of education on road traffic safety laws, regulations, and related knowledge, and must take the subject one exam. 3. Refusal to attend learning results in suspension of the driver's license: If a motor vehicle driver's points reach 12 points and they refuse to attend the learning notified by the traffic management department of the public security authority or take the exam, the traffic management department of the public security authority will announce the suspension of their motor vehicle driver's license.
8
4
Share

How to Remove the Spare Tire of a 2007 Toyota Sienna

The method to remove the spare tire from a 2007 Toyota Sienna is as follows: 1. Open the cover on the outer side of the rear trunk floor. On the right side of the vehicle, you will find a small square cover approximately 7-8 cm in size. Remove this cover to reveal a screw head; 2. Use the tool provided with the vehicle to loosen this screw. The tire is suspended underneath the vehicle, and loosening the screw will allow the tire to descend. Once the screw is loosened, the spare tire can be removed; 3. Before removal, the outer cover of the spare tire must be detached. Below is some relevant information about the Toyota Sienna: 1. In terms of interior configuration, the 3.5L Toyota Sienna model includes additions such as a DVD player, rearview camera, navigation system, xenon headlights, and stainless steel chrome trim. 2. Regarding space, to maximize interior room, the originally mid-mounted engine was moved forward, combined with a lowered chassis, creating an exceptionally large interior space. This design ensures optimal comfort for passengers and maximizes cargo capacity. The Sienna is one of the most feature-rich and luxuriously equipped models in Toyota's MPV lineup.
4
2
Share

What car brand is represented by a white exclamation mark?

The white exclamation mark represents the Ora brand. Introduction to Ora brand: The brand belongs to Great Wall Motors' Haval and is the first independent new energy vehicle brand among China's popular independent automobile enterprises. To better commemorate the world-renowned scientist "Mr. Euler", it was named "Ora", symbolizing Great Wall Motors' Haval's commitment to meticulous craftsmanship and persistent creation of high-end vehicles. The brand was established in 2018. Ora positions itself as the world's most affectionate car brand, aiming to establish correct values in the industry towards female customers. Introduction to Ora brand models: The Ora brand is market and customer-oriented, refusing to be a "fuel-to-electric conversion" or a "policy arbitrage vehicle". After more than a decade of research and development, it has established a pure electric vehicle brand. The models feature an open design, giving customers a refreshing feeling and providing excellent safety and reliability guarantees. The brand's product lineup consists of four models: the compact-level sedans Ora Black Cat and Ora White Cat; the small-level sedan Ora Good Cat; and the compact-level vehicle Ora IQ.
14
3
Share

What does it mean when the Great Wall Wingle 5's particulate filter is self-cleaning?

When the combination instrument displays the message "Self-cleaning in progress, please wait," it indicates that the vehicle has automatically initiated the regeneration procedure. Below is an introduction to the regeneration procedure: Diesel Particulate Filter (DPF): During driving, when the particulate matter captured in the Diesel Particulate Filter (DPF) reaches certain conditions, the vehicle will automatically initiate the regeneration procedure to fully burn the particulate matter, restoring the DPF's ability to continue capturing particles. Notes: To ensure the regeneration procedure is completed smoothly, please follow these driving recommendations until the message disappears: try to maintain a steady speed on roads with good conditions, and keep the engine speed around 2000 RPM. Avoid idling the engine as much as possible. Also, try to avoid stopping or turning off the engine.
8
3
Share

How to Use the Button Gear Shift in Honda URV?

Honda URV's button gear shift has specific operating methods. Below are the gear shifting techniques for Honda URV: Usage of paddle shifters: First, press the brake pedal, shift the gear to "D" position, then push the gear lever towards the passenger side. At this point, you can use the "+" and "-" paddle shifters on the steering wheel to shift up or down. Although manual mode is a bit more cumbersome, it allows precise control over gear shifts at the appropriate RPM and torque. Uphill: Use "D-" to downshift for greater torque, making the power output more robust. If you find the power sufficient, use "D+" to upshift to protect the transmission and engine. If the power is still insufficient, you can switch to S mode (Sport mode). Downhill: It is recommended to use "D+" to upshift, using 3rd gear for gentle slopes and 2nd gear for steep slopes, which can prevent premature wear of the brake pads. 1st gear has too much torque; generally, 2nd or 3rd gear can provide adequate braking effect. Similarly, if the vehicle starts to accelerate downhill, use "D-" to downshift and control the speed.
14
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.