What are the reasons why the Magotan mechanical key cannot open the car door?

1 Answers
Sam
07/29/25 6:59pm
The reasons why the Magotan mechanical key cannot open the car door are as follows: 1. Lock cylinder issue: If the mechanical key cannot open the car door, it is very likely that there is a problem with the car door's lock cylinder. Many car owners are accustomed to using the remote key to open and close the car door, so the keyhole may rust. After all, a keyhole that has not been used for a long time and has not been maintained may rust after exposure to wind and rain. 2. Owner operation issue: It could also be due to an issue with the owner's operation. The most obvious point is that the direction of turning the key is incorrect. When the mechanical key is turned in the wrong direction, the car door will not open. In most cases, the direction to unlock the car door is clockwise, and conversely, the opposite direction is to lock it.
Was this review help?
3
0
Share
More Forum Discussions

What tires are used on the Peugeot 206?

The Peugeot 206 uses Goodyear tires. A major characteristic of this tire brand is its long service life. After installing these tires, when the vehicle's mileage reaches 10,000 kilometers, the tread pattern shows only minimal wear, and the tread does not deform. The Peugeot 206 has a body length of 3873mm, width of 1673mm, height of 1435mm, and a wheelbase of 2443mm. This model is equipped with a 4-cylinder 16-valve engine and a 4-speed automatic transmission. The car features user-friendly storage spaces for occupants, including door compartments, front panel storage, and a glove box in front of the passenger seat.
8
5
Share

What is the original engine oil model of Peugeot 308?

Peugeot 308's original engine oil model is SL-grade 5W30 semi-synthetic oil. SL is the oil grade, and S represents oil for gasoline engines. The letter W in the oil model stands for 'winter,' meaning this oil can be used normally in winter. The number before W indicates the oil's low-temperature fluidity, and the number after W represents the oil's high-temperature viscosity. The Peugeot 308 is a compact car, with its first model equipped with a 120-horsepower 1.6L inline 4-cylinder gasoline engine transplanted from the 207 model, paired with Michelin tires sized 215/55R16.
9
2
Share

What transmission does the Dongfeng Peugeot 308 use?

The Dongfeng Peugeot 308 uses a total of three transmissions, which are a 5-speed manual transmission, a 6-speed automatic transmission (6AT), and a 6-speed dual-clutch transmission. The AT transmission is a mature and widely used technology, also known as a torque converter transmission. This type of transmission connects to the engine via a torque converter. Inside the AT transmission are planetary gears, which are responsible for gear shifting and torque conversion. The AT transmission offers smooth shifting and is known for its reliability and durability. The Peugeot 308 is equipped with three engines: a low-power version of the 1.2-liter turbocharged engine, a high-power version of the 1.2-liter turbocharged engine, and a 1.6-liter naturally aspirated engine.
5
4
Share

What causes the Peugeot 408 to display an engine fault?

There are many reasons why the Peugeot 408 displays an engine fault, possibly due to a malfunction of the sensors on the engine. The engine is surrounded by many sensors, and without these sensors, the engine cannot operate normally. When this situation occurs, the fault code should be read, then the cause and location of the fault should be identified, and finally, the issue should be repaired. The Peugeot 408 is a compact car under the Peugeot brand, equipped with two types of engines: a 1.2-liter turbocharged engine and a 1.6-liter turbocharged engine. The front suspension of this car uses a MacPherson independent suspension, while the rear suspension uses a torsion beam non-independent suspension.
1
0
Share

Where is the cabin air filter located in the 408?

408 cabin air filter is located on the left side of the passenger glove box. The replacement process for the cabin air filter: First, locate the position of the cabin air filter, then pull off the rubber strip, use a flat-head screwdriver to pry open the four plastic clips, and then you can remove the cover plate. Next, the old filter can be taken out and replaced with a new one. There is an arrow indicator on the cabin air filter; the arrow should point downward during installation, and it must not be installed backward. The Peugeot 408 features an innovative 6X safety system, which comprehensively addresses the safety of both the driver and passengers. This system includes the EVA emergency braking assist system, Bosch 8.1 version ABS anti-lock braking system, EBD electronic brake-force distribution, TSC traction control, ESP electronic stability program, and more.
14
5
Share

Is the Peugeot 408 equipped with independent suspension?

The front suspension of the Peugeot 408 is an independent suspension, while the rear suspension is not. The front suspension of this car uses a MacPherson independent suspension, and the rear suspension uses a torsion beam non-independent suspension. The torsion beam suspension is a relatively common type of non-independent suspension. The suspension is used to connect the wheels to the car body, and without it, the car cannot function properly. The MacPherson suspension is a common independent suspension, which is also widely used and has a simple structure. The Peugeot 408 is a compact car launched by Dongfeng Peugeot, equipped with the mainstream engines from DPCA, with displacement options of 2.0L and 1.6L. The launch of the Peugeot 408 has greatly enriched Dongfeng Peugeot's product line in the golden displacement market of 1.6L to 2.0L.
15
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.