What are the reasons why the Baojun 730 won't start?

2 Answers
IsaacRose
07/28/25 6:27pm
Baojun 730 fails to start for the following specific reasons: 1. Battery depletion, the starter begins to turn but the speed is insufficient, i.e., weak, then the starter only clicks without turning. Low temperatures in winter and forgetting to turn off certain electrical devices can cause the vehicle to fail to start, the battery voltage will be below the rated value, and the starter cannot operate normally. 2. Gasoline flow is blocked, there is no oil pressure in the engine fuel supply pipe, the fuel pipeline is dirty for a long time at low temperatures, and water mixed with debris at low temperatures blocks the fuel pipeline, resulting in failure to start. 3. Poor working condition of the ignition system, in cold weather due to low intake air temperature, poor fuel atomization in the cylinder, insufficient ignition energy causes cylinder flooding, i.e., too much fuel accumulates in the cylinder, exceeding the ignition limit concentration and failing to start the car.
Was this review help?
13
3
Share
LeAlaina
08/12/25 12:05am
Having driven for over a decade, with models like the Baojun 730, the most common issue when the car won't start is definitely battery-related—such as an aging battery with insufficient charge or loose connections leading to inadequate current for ignition. Once, my own car had this problem, and it turned out the battery was drained from being parked too long; a jump-start fixed it. If the battery isn't the issue, then check if the starter motor is stuck or burnt out—a classic symptom is turning the key and hearing only a clicking sound with no response. Poor contact at the battery's negative terminal or a blown fuse are also frequent culprits, and in summer heat, circuits are prone to oxidation. Regularly check the battery voltage, testing it every three months or so to avoid last-minute surprises. If all else fails, calling roadside assistance is the safer bet.
Was this review help?
5
5
Share
Expand All
More Forum Discussions

Is Replacing the Subframe Considered a Major Overhaul?

Whether replacing the subframe counts as a major overhaul mainly depends on the extent of the vehicle's damage. If the subframe is slightly damaged but the chassis remains intact, and the repair shop recommends replacing the subframe, it does not qualify as a major overhaul. However, if the damage is severe due to an accident, affecting the chassis significantly, then it is considered a major overhaul. Here is more information about the subframe: 1. The subframe, also known as the auxiliary frame, is part of the vehicle's chassis structure. Its primary function is to connect and secure components of the suspension system. The body is directly connected to the subframe, which enhances the vehicle's structural strength, reduces the impact of suspension vibrations on the body, and improves ride comfort. It is a crucial component of the vehicle's chassis. 2. Replacing the subframe has minimal impact on the vehicle itself, as long as the new subframe is free of quality issues. If the subframe is damaged and replaced, it will not affect the vehicle's handling or driving stability.
18
2
Share

What Causes Power Loss When the Air Conditioner is On?

The reason for power loss when the air conditioner is on is either a fault in the air conditioning system, such as issues with the thermostat or clutch, or if the air conditioner is functioning normally, it could be due to engine carbon buildup or spark plug failure. Here are detailed explanations of these two points: 1. Engine carbon buildup is a key reason for reduced vehicle power. When carbon deposits accumulate in the engine, the fuel system can become clogged, preventing the engine from operating normally and thus affecting the car's power output. 2. Spark plugs play a significant role, and different materials can achieve varying effects. Replacing spark plugs with high-quality ones not only extends their lifespan but also enhances power output efficiency.
19
1
Share

What kind of engine does Hongqi use?

Hongqi uses engines produced by Tianjin FAW Toyota Engine Factory, which are domestically manufactured. Most Hongqi models use the CA4GC engine series. For example, the Hongqi HS5 is equipped with a 2.0T all-new CA4GC inline four-cylinder turbocharged engine, delivering a maximum power of 165kW and maximum torque of 340Nm. For daily maintenance of Hongqi engines, the following methods can be applied: Use lubricating oil of appropriate quality grade. For gasoline engines, select SD-SF grade gasoline engine oil based on the additional devices in the intake and exhaust systems and usage conditions; for diesel engines, choose CB-CD grade diesel engine oil according to mechanical load, with the selection standard not lower than the manufacturer's requirements; Regularly change the engine oil and filter. The quality of any grade of lubricating oil will degrade during use. After a certain mileage, its performance deteriorates, which can cause various engine problems. To avoid malfunctions, change the oil regularly based on usage conditions and maintain an appropriate oil level; When oil passes through the fine pores of the filter, solid particles and viscous substances in the oil accumulate in the filter. If the filter becomes clogged and oil cannot pass through the filter element, it may rupture the filter element or open the safety valve, allowing oil to bypass through the bypass valve, bringing contaminants back to the lubrication areas, accelerating engine wear and increasing internal contamination; Regularly clean the crankcase. During engine operation, high-pressure unburned gases, acids, moisture, sulfur, and nitrogen oxides from the combustion chamber enter the crankcase through the gap between the piston rings and cylinder walls, mixing with metal particles from component wear to form sludge. Small amounts remain suspended in the oil, while larger amounts precipitate, clogging filters and oil passages, making engine lubrication difficult and causing wear; Regularly use radiator cleaner to clean the radiator. Removing rust and scale not only ensures proper engine operation but also extends the overall lifespan of the radiator and engine.
11
5
Share

How to Practice Braking and Accelerating?

When starting, release the clutch, and when the car moves slightly in semi-engagement, gently press the accelerator. Once the speed increases slightly, fully release the clutch and press the accelerator. When braking and the car slows down, if you notice slight shaking, press the clutch immediately to prevent the car from stalling. Here are detailed methods for practicing braking and accelerating: 1. For a smooth stop, use the clutch and brake. In emergencies, press the brake two or three times quickly before engaging the clutch. Semi-engagement refers to the point where the clutch connects with the driveshaft, often used when starting on a slope. To do this, lift the clutch with your left foot, press the accelerator with your right foot, hold the steering wheel with your left hand, and pull the handbrake lever with your right hand. 2. When starting, first press the clutch with your left foot, shift to first gear with your right hand, and gently press the accelerator with your right foot while slowly lifting the clutch with your left foot to the engagement point. Once the car starts moving, do not release the clutch immediately—pause at the engagement point until the car is fully moving before releasing.
19
5
Share

How to Set Up Auto Deletion for Dash Cams?

Dash cams come with auto-deletion functionality since they don't have built-in memory and will automatically delete when storage space is low. Here's more information about dash cams: 1. A dash cam is a device that records images, sounds, and related information during vehicle operation. It can record the entire driving process in video and audio, providing evidence for traffic accidents. 2. Dash cams don't have built-in memory and rely on memory card expansion or portable digital hard drives. For MicroSD or SD card expansion, capacities vary between 2G, 4G, 8G, 16G, and 32G. For portable digital hard drives, capacities can be 250G, 500G, 1000G, etc.
3
2
Share

How Many Times Can You Take the Driving License Test Subject One?

There is no limit to the number of times you can take Subject One of the driving license test. According to the "Regulations on the Application and Use of Motor Vehicle Driving Licenses," you can take the Subject One test twice on the same day. If you fail the first attempt, you can take a free second attempt. If you fail the second attempt as well, the Subject One test for that day will be terminated, and you can only schedule another test after ten days. Subject One, also known as the theoretical test or driver's theory test, is part of the motor vehicle driving license assessment. The test content includes driving theory basics, road safety laws and regulations, local regulations, and related knowledge. The test is conducted on a computer and has a time limit of 45 minutes. To pass Subject One of the driving license test, you need a score of 90 or above. The test consists of 100 questions, divided into single-choice and true/false questions, with each question worth 1 point and a total score of 100. If you answer 11 questions incorrectly during the test, the system will automatically submit the test and end the session. Subject One test content includes: driving license and motor vehicle management regulations; road traffic conditions and rules; road traffic safety violations and penalties; road traffic accident handling regulations; basic knowledge of motor vehicles; local regulations; knowledge of braking systems and safety devices for large and medium-sized passenger and freight vehicles; specialized knowledge for wheeled self-propelled machinery, trams, and trolleybuses. Subject One test precautions: During the test, candidates should pay attention to their attire—no slippers are allowed. Electronic devices and bags are prohibited in the examination room. Bring your ID card and queue to enter the waiting hall. Observe the precautions and procedures on the large screen, and store personal belongings in a locker before entering the examination room. Inside, your seat will be assigned at the identity verification area. Once seated, begin the test, ensuring the camera is aligned with you and adhering to test discipline. If you fail the first attempt, you can retake the test the same day. If you fail again, you must pay to reschedule. After the test, queue to collect your score report and sign it—failure to sign will render the result invalid. There is no limit to the number of times you can schedule the Subject One test. Each subject test can be taken once, with one retake allowed if you fail. If you do not take the retake or fail the retake, the test for that subject will be terminated, and you must reschedule. In contrast, Subject Two and Subject Three only allow five attempts each. Subject Two and Subject Three tests can be rescheduled after ten days. If you fail the Subject Three safety and civilized driving knowledge test, your previously passed road driving skills test results remain valid. The driving test consists of three subjects: Subject One, Subject Two, and Subject Three. Subject One refers to the road traffic safety laws, regulations, and related knowledge test. Subject Two refers to the field driving skills test. Subject Three is divided into two parts: road driving skills and safety and civilized driving knowledge tests. The safety and civilized driving knowledge test is conducted after Subject Three, so it is commonly referred to as Subject Four. However, the official terminology (as per the Ministry of Public Security Order No. 123) does not include the term "Subject Four."
13
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.