What are the reasons for the Mazda CX-5 engine warning light to come on?

[DiKing]

There are mainly 7 reasons for the Mazda CX-5 engine warning light to come on: Sensor failure: The sensors mentioned here include coolant temperature, crankshaft position, air flow, intake air temperature, oxygen sensors, etc. When these sensors are damaged, have poor contact, or signal interruption, the car's ECU cannot accurately obtain engine data, which will cause the engine warning light to come on. Fuel quality issues: If fuel and engine oil are not added according to the manufacturer's requirements, it may cause engine wear and trigger the warning light. Poor combustion of the air-fuel mixture: Poor combustion can lead to engine carbon deposits or knocking. After being detected by the oxygen sensor and reported to the ECU, the warning light will come on as a warning. Spark plug failure, ignition coil failure, fuel pump failure, and fuel line blockage can all cause poor combustion of the air-fuel mixture. Turbocharging issues: The intake turbocharging pipeline and turbocharger can also cause the engine warning light to come on. The most common issue is turbocharger damage, accompanied by symptoms such as oil leakage, high oil consumption, reduced power, metal noises, and blue or black smoke from the exhaust pipe. Intake issues: If there is a problem with the car's intake, it may cause engine pipeline blockage, and in severe cases, trigger the engine warning light. A dirty air filter that is not cleaned regularly can lead to intake problems. Exhaust issues: Exhaust faults can also cause the engine warning light to come on. The rear oxygen sensor, three-way catalytic converter, exhaust camshaft, and bearing failures are all causes of exhaust problems, with the three-way catalytic converter being the most common. Using leaded gasoline, lead or silicon-based lubricant additives, physical damage to the catalytic converter, or fuel system failures can easily cause three-way catalytic converter issues. Anti-theft system failure: If the car's electronic anti-theft system malfunctions or the anti-theft controller does not match the engine electronic controller, the anti-theft system can also prevent the engine from operating normally and trigger the engine warning light. If the engine warning light comes on, follow these steps: First, check if the engine is running normally, whether there is shaking, black smoke, etc. If so, try not to start the engine again. Especially, do not start the engine if the red light is on. If the engine can be started, turn it off for 5-10 minutes, then without pressing the brake, press the start button once or turn the key halfway to the 'on' position without pressing the clutch. The car will perform a self-check after powering on. Wait for 5-10 seconds and observe if the warning light on the dashboard goes off. If the warning light does not go off, visit a service station as soon as possible to find the cause. The service station can use a portable diagnostic tool to read the fault code, obtain fault information, and perform targeted repairs.