What are the reasons for the high fuel consumption of the Kia Soul?

1 Answers
VanBlakely
07/29/25 7:58pm
There are three main reasons for the high fuel consumption of the Kia Soul. Below is a detailed explanation of these three reasons: 1. Abnormal tire pressure: If you notice that the vehicle's coasting distance is significantly reduced during driving, you should check whether the tire pressure meets the standard. If the tires are underinflated, fuel consumption will also increase. It is advisable to inflate the tires properly in a timely manner. 2. Tire wear: Check the degree of tire wear. If the tires are severely worn, slipping will frequently occur, increasing fuel consumption. New tires should be replaced when necessary. 3. Bearings and braking system: If abnormal noises are detected from the wheels during driving or starting, the bearings and braking system should be promptly inspected for faults. If the wheels do not rotate normally, it will affect the vehicle's speed and increase fuel consumption.
Was this review help?
17
3
Share
More Forum Discussions

What does a transit car mean?

Transit cars refer to operational freight cars that do not undergo loading or unloading operations at stations. Transit cars are categorized into two types based on their operational nature: non-switching transit cars and switching transit cars. Below is a detailed introduction about them: 1. Non-switching transit cars: Operational freight cars that are not detached in transit trains at technical stations and operational freight cars on suspended trains. 2. Switching transit cars: Transit cars that do not belong to non-switching transit cars. 3. Notes: When taking transit cars, it is important to reserve the time difference for transfers and pay attention to the intermediate stations for switching. If it is a same-station transfer, it is more convenient, and the reserved time does not need to be too long, approximately more than ten minutes is sufficient.
14
1
Share

What speed should be maintained when visibility on the highway is below 50 meters?

When visibility is less than 50 meters, the vehicle speed must not exceed 20 kilometers per hour, and the driver should exit the highway from the nearest exit as soon as possible. When driving on the highway under low visibility weather conditions such as fog, rain, snow, dust, or hail, motor vehicles must comply with the following regulations: 1. When visibility is less than 200 meters: Turn on fog lights, low beam headlights, clearance lights, front and rear position lights, and the speed must not exceed 60 kilometers per hour, maintaining a distance of more than 100 meters from the vehicle ahead in the same lane; 2. When visibility is less than 100 meters: Turn on fog lights, low beam headlights, clearance lights, front and rear position lights, and hazard warning flashers, and the speed must not exceed 40 kilometers per hour, maintaining a distance of more than 50 meters from the vehicle ahead in the same lane; 3. When visibility is less than 50 meters: Turn on fog lights, low beam headlights, clearance lights, front and rear position lights, and hazard warning flashers, and the speed must not exceed 20 kilometers per hour, and the driver should exit the highway from the nearest exit as soon as possible.
1
1
Share

How Long Does a Wheel Alignment Take?

A wheel alignment typically takes about half an hour to complete, though the exact time required depends on the actual condition of the vehicle. Here is some information about wheel alignment: 1. Performing a wheel alignment ensures good driving performance and improves reliability to a certain extent. The principle is based on the standard values of the original factory's relative wheel position parameters, adjusting and restoring the alignment of the four wheels. 2. Depending on tire usage, chassis condition, and alignment status, it is recommended to check the wheel alignment every six months. If the angles have exceeded the standard allowable range, adjustments or part replacements should be made to restore normal angles.
15
4
Share

Does Replacing the Fuel Pump Affect the Car?

Replacing the fuel pump does affect the car. The impacts of replacing the fuel pump are as follows: 1. When the pump core is damaged, the fuel supply system will not function properly. In this case, turning the ignition key will not produce the sound of the fuel pump operating; 2. If the pump body is damaged, due to pressure leakage, the fuel pressure cannot reach the specified value, leading to poor fuel atomization and preventing the engine from starting; 3. Do not wait until the fuel warning light comes on before refueling, as the fuel pump relies on gasoline for cooling. When the fuel level is too low, it cannot effectively dissipate heat, which reduces the pump's lifespan.
6
4
Share

What does it mean when the snowflake light on the vehicle dashboard is on?

The snowflake indicator light on the vehicle dashboard indicates that the outdoor temperature is quite low, reminding the driver that there may be frost on the ground. Here are some precautions for driving in frost conditions: 1. When frost appears on the ground, tire grip will deteriorate, and drivers need to drive carefully. The vehicle's onboard computer display can show the outside temperature, a function achieved through a temperature sensor fixed on the front bumper. The temperature sensor on the front bumper is usually positioned quite low. When the snowflake symbol on the dashboard lights up in winter, drivers should reduce their speed and maintain a sufficient safe distance from the vehicle ahead to prevent emergency braking. 2. If there is frost on the ground, emergency braking can easily cause the car to skid and lose control. In winter, when tire temperatures are quite low, it is advisable to drive at reduced speeds. In cases of extremely severe weather conditions, it is recommended not to drive.
6
2
Share

What is the difference between 92 and 95 gasoline for cars?

There are mainly the following differences between 92 and 95 gasoline for cars: 1. The proportion of isooctane in 95 gasoline is slightly higher than that in 92 gasoline; however, the proportion of n-heptane in 92 gasoline is higher than that in 95 gasoline. 2. Isooctane indicates better anti-knock performance, so 92 gasoline has a much higher probability of causing knocking compared to 95 gasoline. 3. Different anti-knock properties are suitable for engines with different compression ratios. High-compression engines should use 95 gasoline; low-compression engine vehicles can use 92 gasoline.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.