What are the reasons for the failure of all four power windows in a Santana?
4 Answers
The reasons for the failure of all four power windows in a Santana are as follows: Aging window rubber strips: The inability of the car windows to roll up or down may be due to the aging of the rubber guide channels on the exterior of the windows or the accumulation of dust on the rubber strips affecting their operation. It is recommended to inspect the rubber strips. Battery depletion: If the car's battery is depleted or disconnected, the windows will also fail to operate. During repair or maintenance, if the power or ground wire of the window control module is disconnected, and if the car battery is severely depleted, the initialization data for the windows may be lost after the engine is restarted, affecting the normal operation of the windows. In this case, simply resetting the system should resolve the issue.
I encountered this issue when driving my Santana. If none of the four windows move, it's likely due to a blown fuse or a faulty main control switch. Last month, after my car was parked outdoors for a few days, the switches didn't respond when pressed. I first checked the fuse box. The Santana's fuse box is usually located under the steering wheel or in the engine compartment. Look for the fuse corresponding to the window circuit—if it's blackened, try replacing it with a new one. If the fuse is fine, the problem might be a short circuit or a malfunctioning control unit, possibly caused by moisture-induced corrosion. In such cases, avoid forcing the windows to move to prevent damaging the motor and compromising safety. It's advisable to perform a simple check yourself first; if that doesn't help, visit a repair shop to avoid turning a minor issue into a major, costly problem. Regular maintenance, such as preventing water accumulation in the windows and avoiding excessive use of the switches, can help reduce such failures.
When all the power windows of a Santana fail, the issue usually lies in the fuse, master switch, or power wiring. As an experienced driver and long-time owner, I believe the first step is to check if the fuse has blown—the fuse box is generally easy to locate. If the fuse is intact, then inspect the master control button for poor contact; sometimes, button wear or water damage can cause malfunctions. Next, examine the power wiring for breaks or short circuits, especially since older Santana models are prone to faster wire aging, and damp or cold weather can lead to rust-induced disconnections. Avoid attempting DIY repairs to prevent further damage—it's best to contact a professional technician directly. Regular maintenance, such as keeping the window tracks clean and dry, can help prevent similar issues and extend the lifespan. Safety first—never manually lower the windows in hazardous areas.
Non-functional car windows can be dangerous, especially when you can't close them in emergencies. I've experienced a situation where all four windows of a Santana wouldn't move, mainly due to a blown fuse or faulty control relay. First, ensure the battery power supply is normal and check the location of the fuse box. If the power supply isn't interrupted, the issue might be a malfunctioning switch button or a short circuit in the wiring. Santana's design sometimes allows water to enter the control panel, causing problems. Stay calm when dealing with it—park the car first before checking. If you can't fix it, get it repaired immediately to prevent being trapped in the car. Regular window maintenance helps avoid dirt blockages.
