What are the reasons for the engine warning light in Volkswagen Bora?

[StJayce]

There are mainly 7 reasons for the engine warning light in Bora: Sensor failure: The sensors mentioned here include water temperature, crankshaft position, air flow, intake temperature, oxygen sensors, etc. When these sensors are damaged, have poor contact, or signal interruption, the car's ECU cannot accurately obtain engine data, which will cause the engine warning light to illuminate. Fuel quality issues: If fuel and engine oil are not added according to the manufacturer's requirements, it may cause engine wear and trigger the warning light. Poor combustion of the air-fuel mixture: Poor combustion can lead to engine carbon deposits or knocking. When detected by the oxygen sensor and reported to the ECU, the warning light will illuminate as a warning. Spark plug failure, ignition coil failure, fuel pump failure, and fuel line blockage can all cause poor combustion of the air-fuel mixture. Turbocharging issues: The intake turbocharging pipeline and turbocharger can also cause the engine warning light to illuminate. The most common issue is turbocharger damage, accompanied by symptoms such as oil leakage, excessive oil consumption, reduced power, metallic noises, and blue or black smoke from the exhaust pipe. Intake issues: If there is a problem with the car's intake, it may cause engine pipeline blockage, and in severe cases, trigger the engine warning light. A dirty air filter that is not cleaned regularly can lead to intake problems. Exhaust issues: Exhaust faults can also cause the engine warning light to illuminate. The rear oxygen sensor, catalytic converter, exhaust camshaft, and bearing failures are all causes of exhaust problems, with the catalytic converter being the most common. Using leaded gasoline, lead or silicon-based lubricant additives, physical damage to the catalytic converter, or fuel system failures can easily cause catalytic converter issues. Anti-theft system failure: If the car's electronic anti-theft system malfunctions or the anti-theft controller does not match the engine electronic controller, the anti-theft system can prevent the engine from operating normally, and the engine warning light will illuminate. If the engine warning light is on, follow these steps: First, check if the engine is running normally, whether there is shaking, black smoke, etc. If so, try not to restart the engine. Especially, do not restart if the red light is on. If the engine can start, turn it off for 5-10 minutes, then without pressing the brake, press the start button once or turn the key halfway to the 'on' position without pressing the clutch. The car will perform a self-check after powering on. Wait for 5-10 seconds and observe if the warning light on the dashboard turns off. If the warning light does not turn off, visit a service station as soon as possible to diagnose the issue. The service station can use a portable diagnostic tool to read the fault code, obtain fault information, and perform targeted repairs.