What are the reasons for the engine warning light in JAC Shuailing?

[MarleyMarie]

There are mainly 7 reasons for the engine warning light to illuminate: Sensor malfunction: The sensors mentioned here include coolant temperature, crankshaft position, air flow, intake air temperature, oxygen sensors, etc. When these sensors are damaged, have poor contact, or signal interruption, the vehicle's ECU cannot accurately obtain engine data, which will cause the engine warning light to illuminate. Fuel quality issues: If fuel and engine oil are not added according to the manufacturer's requirements, it may cause engine wear and trigger the warning light. Poor combustion of the air-fuel mixture: Poor combustion can lead to engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the warning light will illuminate as a warning. Spark plug failure, ignition coil failure, fuel pump failure, and fuel line blockage can all cause poor combustion of the air-fuel mixture. Turbocharging issues: The intake turbocharging pipeline and turbocharger can also cause the engine warning light to illuminate. The most common issue is turbocharger damage, accompanied by symptoms such as oil leakage, high oil consumption, reduced power, metal noises, and blue or black smoke from the exhaust pipe. Intake issues: If there is a problem with the car's intake system, it may cause engine pipeline blockage, and in severe cases, trigger the engine warning light. A dirty air filter that is not cleaned regularly can lead to intake problems. Exhaust issues: Exhaust system faults can also cause the engine warning light to illuminate. The rear oxygen sensor, catalytic converter, exhaust camshaft, and bearing failures are all causes of exhaust problems, with the catalytic converter being the most common. Using leaded gasoline, lead or silicon-containing lubricant additives, physical damage to the catalytic converter, or fuel system failures can easily cause catalytic converter issues. Anti-theft system malfunction: If the car's electronic anti-theft system fails or the anti-theft controller does not match the engine ECU, the anti-theft system can also prevent the engine from operating normally, and the engine warning light will illuminate. If the engine warning light is on, follow these steps: First, check if the engine is running normally, such as whether there is shaking, black smoke, etc. If so, avoid restarting the engine. Especially note that if the red light is on, do not restart the engine. If the engine can be started, turn it off for 5-10 minutes, then without pressing the brake, press the start button once or turn the key halfway to the 'on' position without pressing the clutch. The car will enter self-inspection mode after powering on. Wait for 5-10 seconds and observe if the warning light turns off. If the warning light remains on, visit a service station as soon as possible. The service station can use a portable diagnostic tool to read the fault code, obtain fault information, and perform targeted repairs.