What are the reasons for the Chevrolet Cavalier's reversing camera not displaying?
2 Answers
The reasons for the Chevrolet Cavalier's reversing camera not displaying: 1. Setting issue, enter the navigation settings page, find the reversing mirror option, check if it is turned off. If it is turned off, the image will not display; simply turn it on. 2. It could be a camera malfunction or a video cable issue, which requires inspection and repair. The Chevrolet Cavalier is a compact car under the Chevrolet brand, with dimensions of 4474mm in length, 1730mm in width, and 1471mm in height, and a wheelbase of 2600mm. It is equipped with a 1.0T 125 horsepower L3 turbocharged engine, paired with a 6-speed automatic transmission. The suspension system uses a MacPherson strut independent suspension at the front and a torsion beam non-independent suspension at the rear.
Last time I encountered the same issue, and after struggling for a while, I found out that the trunk lid opening and closing too many times had loosened the wiring. The Chevy Cavalier's reverse camera not displaying is most likely due to a problem with the camera itself, such as the lens being covered in mud or water seeping in and causing a short circuit. If the reverse lights don’t even turn on when shifting into reverse gear, then there’s an issue with the power circuit, and the fuse blowing is a highly likely possibility. I’ve personally opened up the trunk lid’s interior panel and checked—those thin wires inside are constantly being pressed and bent, leading to poor contact, which is very common. Sometimes, turning the car off and restarting the infotainment system makes it work again, indicating a system glitch or software freeze. Cars with aftermarket reverse cameras need extra caution, as the connectors on retrofitted equipment tend to loosen, and tangled wiring can interfere with the original vehicle’s signals. If you notice this issue, you should address it immediately—relying solely on guesswork while reversing is too dangerous.
