What are the reasons for the Chery Jetour one-button start not working?

1 Answers
JustinFitz
07/29/25 6:35pm
Chery Jetour one-button start not working may be due to reasons such as the car key running out of battery or being interfered with, insufficient battery power, or ignition system failure. Car key out of battery: When the battery is dead, the one-button start function cannot work properly, and the battery should be replaced as soon as possible. Car key near electronic devices: Frequently placing the car key near electronic devices such as mobile phones, computers, or televisions can cause interference with the low-intensity radio waves in the key. Insufficient battery power: Charge the battery in time or replace it with a new one. Ignition system failure: The ignition system is relatively complex, and the cause of the failure is difficult to determine directly. It is recommended to go to a repair shop for professional help.
Was this review help?
14
3
Share
More Forum Discussions

How to Remove the Porsche 718 Key?

First, after parking, straighten the steering wheel. If the steering wheel is not straightened, the vehicle may not drive straight when starting. To turn off the key, generally twist it twice in steps: first twist to the position to shut off the engine, then twist in the opposite direction to the end to completely turn off the car. Finally, you can pull out the car key. After removing the key, always remember to close the door and lock the car.
11
4
Share

How to turn on the headlights of the Borgward BX7?

Enter the driver's cabin and locate the vehicle's light control lever. The "0" position turns off the vehicle lights. The "AUTO" position activates the automatic light function. Adjust the light control to the position light setting. Turn the knob to the right position for the low beam setting. Push the light lever upward for the right turn signal and downward for the left turn signal. Push the vehicle light lever forward for the high beam setting and pull it backward for the single high beam flash.
12
4
Share

How to reset the tire pressure on a Porsche Macan?

First, turn the one-touch start button on the left side of the steering wheel to start the vehicle; otherwise, the tire pressure cannot be reset. Then, press the custom button on the right side of the multifunction steering wheel. Next, press the '+' button on the left side of the multifunction steering wheel. After that, use the lever below the steering wheel, push it downward, and select the clear function. Finally, observe the tire pressure information on the dashboard to confirm that the tire pressure has been reset.
8
4
Share

How to Turn Off and Power Down the Borgward BX5?

First, firmly press the brake pedal to keep the vehicle stationary and prevent it from moving. This avoids potential scratches or collisions with other objects. Next, shift the gear to neutral, release the clutch while keeping the brake pedal depressed. Turn off the ignition and remove the key, then open the door to prepare for exiting the vehicle. Finally, after exiting the car, press the logo button on the key once to completely cut off power and shut down the engine.
2
2
Share

Will I Be Caught on Camera When Driving Out of a Restricted Zone?

During the implementation of traffic restriction measures, all vehicles violating the restrictions will be captured by cameras. Penalties for violating traffic restrictions: The traffic police department will impose a penalty of 3 demerit points and a fine on drivers who violate the restrictions. Restricted vehicles driving within the city will still be penalized if caught by cameras when exiting the city. Points to note about being caught on camera: Not all electronic police surveillance systems capture restricted vehicles. Generally, only traffic video surveillance devices or traffic flow monitoring devices will capture every passing vehicle. Most other devices will only take photos under certain triggering conditions (such as running a red light).
14
0
Share

How to turn off and lock the BORGWARD BX5?

To turn off the BORGWARD BX5, first press the brake pedal, wait for the speed to decrease, gradually downshift, and press the clutch pedal until the vehicle comes to a complete stop when nearly stopped. After stopping, shift into neutral, release the clutch pedal, and only press the brake pedal. Finally, turn off the power and remove the key. Open the door to exit the vehicle and press the lock button on the key to lock the doors.
9
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.