What are the reasons for the car not accelerating when the throttle is floored?

1 Answers
LaTucker
07/30/25 6:06am
The reasons for the car not accelerating when the throttle is floored are: 1. Severe carbon buildup inside the car engine; 2. Engine misfire; 3. Engine overheating; 4. Low-quality fuel. The solutions for the car not accelerating when the throttle is floored are: 1. Check the gasoline pressure and cleanliness, replace the gasoline filter; 2. Inspect the ignition system, spark plugs, and cylinder wires; 3. Check the cylinder pressure to see if the engine is misfiring; 4. Inspect the intake and exhaust pipes for blockages; 5. Verify the ignition timing, throttle position sensor, and idle control motor; 6. Use higher-quality gasoline. The throttle controls the engine's throttle valve opening by adjusting the pedal position, regulating the air intake, while the computer controls the fuel amount, thereby controlling the engine's speed.
Was this review help?
9
4
Share
More Forum Discussions

Should an Automatic Transmission Car Use S Gear or M Gear for Climbing Hills?

For climbing hills with an automatic transmission car, it is recommended to use the M gear. Lower gears provide stronger engine power, and when facing a steep incline, shifting to M- will enhance the car's power, ensuring a successful climb. Scenarios where the M gear can be used in a car: During overtaking, when going up or down hills, when driving on highways, and when driving on icy or snowy roads. When overtaking, using the M- gear to lower the gear can provide higher torque, allowing the car to accelerate quickly in a short time. For uphill driving, M- should be used as lower gears offer stronger engine power. When descending, adjusting the gear to 2-3 using M+ can utilize the engine's braking effect to slow the vehicle, reducing reliance solely on the brakes and enhancing driving safety. Additionally, using the M gear on steep descents helps control speed through engine braking, preventing brake overheating and thermal fade. When driving on highways, manually shifting to higher gears using M+ and maintaining a speed of 80-100 km/h can improve fuel efficiency. On icy or snowy roads, adjusting the gear to 2 using M+ can reduce wheel slippage.
16
5
Share

How to Extract Gasoline from a Motorcycle?

To extract gasoline from a motorcycle, you can close the fuel valve under the fuel tank and disconnect the fuel pipe connected to the carburetor to drain the gasoline. Below is an introduction to the knowledge of extracting gasoline from a motorcycle: 1. Precautions: First, prepare a container for collecting the gasoline, preferably a metal one. Avoid using plastic containers as they may generate static sparks, posing a certain safety risk. 2. Carburetor Introduction: The carburetor is a mechanical device that mixes a certain proportion of gasoline with air under the vacuum generated by the engine. As a precision mechanical device, the carburetor utilizes the kinetic energy of the incoming airflow to atomize the gasoline.
19
3
Share

Can a Vehicle on the Main Road Make a U-turn onto the Auxiliary Road?

Vehicles on the main road can make a U-turn onto the auxiliary road. The rule that vehicles on the auxiliary road must yield to those on the main road is based on the principle that the main road serves as the trunk line while the auxiliary road functions as the branch line, where branch traffic yields to trunk traffic. Generally, main roads have more lanes and higher speed limits, hence auxiliary road vehicles must give way to main road traffic. The differences between main and auxiliary roads are as follows: Main roads are exclusively for motor vehicles, whereas auxiliary roads accommodate mixed traffic of motor vehicles, non-motorized vehicles, and pedestrians. Key distinctions include: 1. Function: When main road traffic volume is excessive, auxiliary roads help alleviate congestion by diverting some vehicles. 2. Specifications: For unidirectional motor vehicle lanes physically separated from bicycle lanes, the minimum width should be 7.5m; when separated by markings, auxiliary roads should be no narrower than 8.5m; for high traffic volumes of both vehicle types, auxiliary road widths may range 12-13m. 3. Configuration: In urban ground-level expressways, auxiliary roads should run continuously on one or both sides of the main road; for elevated expressways, they're situated at ground level beneath the structure. Suburban expressway auxiliary roads may be continuous or intermittent.
18
3
Share

Will I get points deducted for speeding less than 10%?

According to regulations, speeding within 10% of the prescribed speed limit will not be penalized but will result in a warning. Relevant information is as follows: 1. Penalty: Exceeding the prescribed speed limit by more than 10% but less than 20% will result in a 50 yuan fine and 3 points deducted. 2. Overtaking: Vehicles exceeding the prescribed speed limit by less than 10% will not be fined or have points deducted. Exceeding the prescribed speed limit by more than 10% but less than 20% will result in 3 points deducted and a 50 yuan fine. Exceeding the prescribed speed limit by more than 30% but less than 50% will result in 6 points deducted and a 100 yuan fine.
11
3
Share

How to Check Vehicle VIN Number?

Vehicle VIN numbers are generally visible at the bottom of the windshield on the driver's side. Here is some information about VIN numbers: 1. Definition: A VIN number refers to a long string of characters that serve as the vehicle identification code, consisting of seventeen digits. 2. Content: It includes information such as the vehicle's manufacturer, year, model, body type and code, engine code, and assembly location. 3. Function: Correctly interpreting the VIN number is crucial for accurately identifying the vehicle model and performing proper diagnosis and repairs.
12
5
Share

What to Do When Your Car Gets Hit?

After a traffic accident occurs, the first thing to do is to report to the traffic police and then call your insurance company. Let the traffic police determine who is at fault and how to handle the situation, while the insurance company assesses the damage and determines if it falls within the claim coverage. Follow the instructions of the traffic police first, then take your car to the repair shop as required by the insurance company. Here are the specific steps: 1. Damage Assessment: Typically, if the vehicle damage is not severe, the insurance surveyor can assess the damage on the spot. If the damage is significant, you will need to go to an assessment center. 2. Submit Claim Documents: According to the insurance policy, the policyholder should submit the necessary accident documents to the insurance company within ten days after the traffic authorities have concluded the case. Once these steps are completed, the car owner can wait for the insurance company's claim notification with peace of mind.
6
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.