What are the reasons for the car body crossing the line when reversing into the parking space?

1 Answers
Hallie
07/29/25 9:40pm
The reason for the car body crossing the line when reversing into the parking space is turning the steering wheel too early at the starting point of reversing. Below are the specific steps for reversing into the parking space: 1. Identify the starting point: Taking right-side reversing as an example, when reversing backward, use the lower edge of the left rearview mirror as a reference. When the two align, turn the steering wheel fully to the right and continue reversing. 2. Control the corner point: Pay attention to the changing distance between the corner of the parking space and the car body until the car body is parallel to the parking line, then turn the steering wheel back one and a half turns in one motion.
Was this review help?
6
0
Share
More Forum Discussions

What are the penalties for not wearing seat belts in the back seat?

Generally, not wearing seat belts in the back seat will not be penalized, but there are exceptions in certain cities, such as Shenzhen. When a motor vehicle is in motion, the driver and passengers must use seat belts as required, and motorcycle drivers and passengers must wear safety helmets as required.
12
1
Share

How to Remove Residual Crystal Coating?

Use a damp towel to wipe; moistening it with warm water yields better results. Applying polishing wax is highly effective for removal. Using tar remover provides similar effectiveness as removing tar stains. Automotive crystal coating transforms the paint surface into a continuous layer through traditional polishing techniques, increasing the overall density of the paint surface.
4
4
Share

How to Open the Lexus Hood?

Located at the lower left corner of the driver's seat, lift the hood, remove the engine compartment cover support rod, and hang the engine compartment cover support rod into the groove of the engine compartment cover. Located on the left panel of the center console, reach into the front end of the engine compartment cover and lift the cover upwards; take out the cover support rod and place one end of the support rod into the slot.
1
2
Share

How to Start in Second Gear Without Stalling?

After starting the car in neutral, quickly press the clutch pedal and shift into first gear. Then slowly release the clutch pedal until you feel the vehicle begin to move forward. Once you feel the wheels moving, hold the clutch steady and gently press the accelerator. Do not release the clutch too quickly, or the car will jerk.
9
0
Share

How to Connect Jumper Cables?

Open the engine hood and locate the battery. Connect one end of the red jumper cable to the positive terminal of the working vehicle's battery. Connect one end of the black jumper cable to the negative terminal of the working vehicle's battery, and the other end to an unpainted metal part of the engine on the dead vehicle. Start the working vehicle, then attempt to start the dead vehicle.
9
3
Share

What to Do If Walnut Shell Grit Enters the Combustion Chamber?

Clean the throttle body by removing it, using carburetor cleaner for cleaning, and then drying it with a cotton cloth before reinstalling. To clean internal engine carbon deposits, open the oil cap, pour in the entire can of cleaner, let the engine idle for 10-15 minutes, and then turn it off. Cleaning carbon deposits in the fuel system includes cleaning the fuel injectors, combustion chamber, spark plugs, and other components.
12
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.