What are the reasons for the Audi Q5 displaying abnormal tire pressure?

1 Answers
KarterLynn
07/30/25 5:21am
The reasons for the Audi Q5 displaying abnormal tire pressure are: 1. Abnormal tire pressure caused by a punctured tire; 2. Excessive or insufficient tire pressure in a certain tire. Taking the 2020 Audi Q5 as an example, it belongs to the mid-size SUV category, with body dimensions of: length 4753mm, width 1893mm, height 1659mm, wheelbase 2908mm, fuel tank capacity 73l, and curb weight 1855kg. The 2020 Audi Q5 features a five-link independent suspension in the front and a five-link independent suspension in the rear. It is equipped with a 2.0l turbocharged engine, delivering a maximum horsepower of 190ps, maximum power of 140kw, and maximum torque of 320nm, paired with a 7-speed dual-clutch transmission.
Was this review help?
20
5
Share
More Forum Discussions

What to Do When the Car Floor Mat Is Always a Bit Wet Underneath?

Here are the reasons for water accumulation under the car floor mat: 1. Observation: Check if the sunroof drainage pipe is clogged. Fully open the sunroof to see a groove. Slowly pour water into the groove (the sunroof drainage pipe) to see if the water drains or gets blocked. The outlet of this drainage pipe should be on the A-pillar or C-pillar of the car. 2. Inspection: Examine the door drainage pipes. Open the door, and you will find many small holes at the bottom—these are the drainage holes. Check if they are blocked. 3. Door Removal: It may be necessary to remove the door panel. Many small advertisements or business cards are often stuffed into the gaps between the door and window. If unnoticed, they can fall inside the door. Upon removing the door panel, you might find clusters of wet business cards, which not only block the drainage holes but also cause water to seep out.
13
2
Share

What does the EPC light indicate in a Volkswagen Polo?

EPC stands for Electronic Power Control, which is the engine electronic stability system. When this indicator light stays on continuously, it signifies a fault in the engine or electronic systems. If the light remains illuminated or flashes after ignition or during driving, it indicates that the management system has detected an issue with the engine or electronic systems. Please contact a service center immediately. Below is relevant information about EPC: 1. Introduction to EPC: EPC, fully known as Electronic Power Control, is commonly referred to as the electronic throttle system. 2. Components of the EPC system: It mainly consists of the engine control unit, engine wiring harness, throttle body, accelerator pedal, brake switch, and clutch switch (for manual transmission vehicles). If any of these components malfunctions and the engine control unit detects the issue, it will directly trigger the EPC light to illuminate.
7
3
Share

Does the BMW 5 Series engine mount sinking need to be replaced?

BMW 5 Series engine mount sinking needs replacement. Here's information about engine mounts: 1. Types of engine mounts: Vehicle mounts are divided into two types - torque mounts and engine mounts. The engine mount is a rubber block directly installed at the bottom of the engine, while the torque mount is similar to a component installed on the side of the engine. 2. Function of engine mounts: Engine mounts provide support and reduce direct contact between the engine and frame, serving as a buffer; they minimize engine vibration to enhance driving comfort; damaged engine mounts significantly reduce comfort and increase noise levels.
3
5
Share

What does the car air conditioning recirculation light indicate?

The illuminated recirculation light indicates that the air conditioning system is in recirculation mode. In this state, the vehicle's air conditioning operates in internal circulation. Most car air conditioning systems feature both internal and external circulation functions. When internal circulation is activated, outside air cannot enter the vehicle cabin. Conversely, when external circulation is enabled, outside air can flow into the cabin. Here's additional information: 1. Car Air Conditioning: This is a crucial comfort feature in vehicles, used almost daily during winter or summer. 2. Air Conditioning Principle: The system can provide both cooling and heating. The cooling mechanism is relatively simple: during cooling, the compressor clutch engages, allowing the engine to drive the compressor. The compressor then continuously compresses refrigerant and delivers it to the evaporator. Inside the evaporator, the refrigerant expands and absorbs heat, cooling the evaporator. This cooled evaporator then chills the air blown by the blower, resulting in cool air being emitted from the air conditioning vents.
17
2
Share

Why does the Volkswagen CC's anti-theft system activate and prevent the engine from starting?

This is because the car's anti-theft safety lock has not been deactivated. Below is some information about the car safety lock: 1. Introduction: A car safety lock is a type of vehicle security device used to lock the steering wheel, consisting of a lock rod, lock body, and lock handle. 2. Principle: Bent rods are welded onto the lock rod and lock handle, and the right end of the lock body is threaded to connect with the lock handle. When in use, the bent rods clamp onto the inner side of the steering wheel, aligning the lock handle with the seat, thereby preventing unauthorized drivers from operating the steering wheel and thus deterring vehicle theft. The safety lock features a simple structure, ease of use, high reliability, and strong anti-theft capabilities, making it an ideal security device for vehicle protection.
19
5
Share

What is the function of a 48V mild hybrid system?

48V mild hybrid systems can help reduce fuel consumption, enhance power, and decrease emissions. Below is a detailed introduction to the 48V mild hybrid system: 1. System division: Volvo's 48V mild hybrid system builds upon the 12V battery by adding a 48V lithium-ion battery hybrid system. Here, the 12V circuit handles traditional electrical loads such as lighting, ignition, and audio systems. The 48V circuit supports active chassis systems, air conditioning compressors, and regenerative braking systems. 2. Structural composition: The 48V mild hybrid system mainly consists of three core components: the boost recovery motor, power conversion unit, and power battery. In this system, the electric motor hardly participates in directly driving the vehicle but serves as a tool for energy recovery to assist the engine. This allows all electrical devices in the vehicle to minimize reliance on the engine, enabling the engine to drive the vehicle more efficiently.
19
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.