What Are the Reasons for the Air Conditioner Not Blowing Hot Air?

1 Answers
Cynthia
07/29/25 7:58pm
Air Conditioner Not Blowing Hot Air?" /> The reasons for the air conditioner not blowing hot air are: 1. The condenser and air filter are too dirty; 2. The belt is aged; 3. The air conditioner compressor or temperature sensor is faulty. The car air conditioning system consists of a refrigeration system, heating system, ventilation and air purification device, and control system. The functions of the car air conditioner are: 1. Using the continuous circulation of refrigerant to achieve cooling effects; 2. Utilizing the engine coolant, waste heat, or heat generated by a burner as a heat source for heating through the heater, with air blown into the car by the blower to raise the temperature at the air outlet for heating purposes; 3. Drawing in fresh external air for ventilation and air exchange, which also helps prevent windshield fogging; 4. Removing dust, odors, smoke, and toxic gases from the car's interior air to freshen it, and humidifying the interior air to increase its relative humidity.
Was this review help?
5
5
Share
More Forum Discussions

What Causes Abnormal Noises When Driving on Rough Roads?

Abnormal noises when driving on rough roads can be attributed to the following reasons: 1. Friction between car components: It may be caused by the friction sound from the fixed rubber sleeve of the suspension lateral stabilizer bar, or related components of the interior trim panel rubbing against each other. 2. Lack of lubrication in the steering column dust cover: Insufficient lubrication in the steering column dust cover can lead to dry friction sounds. Applying some grease inside the dust cover can eliminate the noise. 3. Abnormal noise from the steering column universal joint: The front end of the steering column is equipped with a universal joint. Lack of lubrication in the universal joint can cause abnormal noises, which can be resolved by lubricating the universal joint.
20
2
Share

Should the Negative Terminal of the Car Battery Be Disconnected When the Car Is Not Used for a Long Time?

When a car is not used for a long time, it is necessary to disconnect the negative terminal of the battery to prevent battery drain. Generally, if the car is not used for more than a month, the negative terminal should be disconnected. If the period is not very long, there is no need to disconnect the negative terminal. Here is some information about car batteries: 1. A car battery is a type of battery, also known as a storage battery, which works by converting chemical energy into electrical energy. 2. The commonly referred-to car battery is a lead-acid battery, which mainly uses lead and its oxides as electrodes and sulfuric acid solution as the electrolyte.
11
0
Share

What is the maximum speed of the Corolla 12t on the highway?

The Corolla 12t can reach a maximum speed of 120 km/h on the highway, but traffic regulations must be observed. Factors affecting maximum speed: The maximum speed is largely related to the road surface and is also subject to the road's speed limit. Discussing maximum speed alone is not meaningful. Speed regulations: Motor vehicles must not exceed the speed limit signs on the road. On roads without a centerline, the speed limit is 30 km/h in urban areas and 40 km/h on highways. On roads with only one lane in the same direction, the speed limit is 50 km/h in urban areas and 70 km/h on highways. When turning, the maximum speed of a motor vehicle must not exceed 30 km/h.
12
4
Share

What is the issue when the fault light of Chery E3 is on?

Chery E3 engine fault light may be on due to sensor failure, intake pressure sensor failure, or unstable circuit in the engine fuel injection system. Sensor failure: The system reports a fault code, but it works normally, which may be caused by an operation beyond the control range of the computer. Solution: You can first clear the fault code and then check if it reappears. Unstable circuit in the engine fuel injection system: Loose or broken connections in the engine fuel injection system can also cause the fault light to come on. Solution: It is recommended to go to a 4S repair shop for inspection and repair.
14
5
Share

What is the reason for the lack of clutch in the Baojun 730?

Baojun 730 lacks clutch for the following reasons: Lack of lubrication in the actuator: Due to insufficient lubrication in the clutch system's operating mechanism, the clutch stroke is too small, leading to abnormal clutch return. Check the transmission: If abnormal noise persists after lubrication, this may indicate a transmission malfunction, requiring a thorough inspection and possible repair. Excessive wear: Excessive wear of the clutch, constantly pressing the clutch will keep the release bearing in high-speed rotation, reducing the bearing's lifespan. Pressure plate spring breakage: Severe abnormal noise when pressing the clutch pedal may be caused by a broken pressure plate spring in the clutch.
2
4
Share

What is the function of urea solution for heavy vehicles?

The purpose of using urea in vehicles is to reduce exhaust emissions. The function of vehicle urea and national policy regulations are as follows: Function of vehicle urea: The main purpose of adding urea to vehicles is to reduce exhaust emissions, as the exhaust from diesel engines mainly consists of nitrogen oxides and carbon particles. National regulations clearly stipulate: Because vehicle exhaust emissions pose significant hazards to both humans and the environment. Therefore, the National IV standard implemented in China in 2008 stipulates that diesel vehicles' emission reduction systems must use vehicle urea to reduce the hazards of vehicle exhaust.
17
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.