What Are the Reasons for Noises Coming from Car Tires?

1 Answers
McZachary
07/30/25 2:29am
Reasons for noises coming from car tires: 1. If the tire bearing is abnormal, it will produce a humming sound. It is necessary to immediately go to a repair shop for inspection and replacement to avoid exacerbating damage to the axle and car body. 2. If the tire tread is uneven, it will produce a rumbling sound. The tire should be replaced immediately, and driving should not continue to avoid vehicle loss of control. 3. If the tire bolts are not tightened, a clanging sound will come from the wheel. Tightening the bolts will solve the issue. 4. If the tire is punctured by a nail or has small stones stuck in it, a tapping sound will occur. Drive at low speed and promptly take it to a repair shop for maintenance. Tires are often used under complex and demanding conditions, enduring various deformations, loads, forces, and high and low temperatures while driving. Therefore, they must have high load-bearing performance, traction performance, and cushioning performance, as well as high wear resistance and flex resistance, along with low rolling resistance and heat generation.
Was this review help?
20
1
Share
More Forum Discussions

How to Drive an SUV for Better Fuel Efficiency?

Avoid sudden braking while driving, as it not only increases fuel consumption but also causes significant wear on brake pads, raising maintenance costs. When the vehicle is coasting in neutral gear, the car's computer interprets it as an idle state, resulting in wasted fuel.
13
2
Share

What are the symptoms of insufficient engine oil in a car?

Performance of insufficient engine oil in a car: Lack of engine oil will result in insufficient lubrication, leading to dry friction, high water temperature, valve noise, and knocking sounds. In severe cases, it can cause cylinder scuffing and damage mechanical components of the engine, such as the crankshaft and crankshaft bearings. The engine oil level should be maintained at the middle line of the dipstick's limit area. When checking, make sure to park the car in a safe and stable place. The main functions of engine oil: Lubrication between the piston and cylinder, as well as between the main shaft and bearings, involves rapid relative sliding. To prevent excessive wear of parts, an oil film needs to be established between the two sliding surfaces. A sufficiently thick oil film separates the surfaces of the relatively sliding parts, achieving the purpose of reducing wear.
16
1
Share

How to Smooth Out After Using a Touch-Up Pen?

Use 2000-grit wet sandpaper for polishing. Once it feels satisfactory, clean the area and restore the gloss with car wax. First, sand with wet sandpaper, then fill with putty, let it dry, sand it smooth again, mix the touch-up pen with the matching oil by shaking, and then spray it using a spray can.
5
1
Share

How to Replace Antifreeze?

Conduct a thorough inspection to check for any cracks or signs of leakage in all pipes. If there are signs of antifreeze leakage, replace the hose as needed. Before adding new antifreeze, it's best to flush the fluid channels with clean water to drain out the old antifreeze. Approximately one hour after draining, add the new antifreeze through the radiator hose, then pour another bottle of antifreeze into the antifreeze reservoir, stopping when it's nearly full.
2
3
Share

How to Determine if the Primer is Exposed?

Gently run your finger over the scratch. If you feel noticeable unevenness, it means the primer has been damaged. If you can distinctly feel "a line" when touching it, such a scratch has already reached the primer and requires immediate treatment.
13
1
Share

How to Replace the Battery in a Teana Key Fob?

First, prepare some tools, including a screwdriver and a new battery. Then, press the button on the back of the key fob to remove the mechanical key. Use the prepared screwdriver to open the key fob, replace the battery, and then reassemble the key fob.
13
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.