What are the reasons for no response when starting a car?

1 Answers
McJosiah
07/25/25 12:49pm
The reasons for no response when starting a car are: 1. There is a problem with the control circuit of the starter; 2. The starter brush is faulty; 3. The battery voltage is insufficient; 4. There is an issue with the relay; 5. Poor contact of the starter's magnetic switch. The solutions for no response when starting a car are: 1. Check if there is a problem with the control circuit of the starter; 2. Check if the starter brush is faulty and replace it in time if there is a problem; 3. Adjust the battery voltage; 4. Check if there is an issue with the relay; 5. Check the contact condition of the starter's magnetic switch; 6. Check if the starter wire is loose or detached, and whether the switch or adsorption switch is malfunctioning.
Was this review help?
15
0
Share
More Forum Discussions

What is the equivalent gasoline displacement for a 2.0t diesel engine?

A 2.0t diesel engine is equivalent to a 2.4t gasoline engine in terms of displacement. Below is some relevant information about diesel: Introduction: Diesel is a light petroleum product, a mixture of complex hydrocarbons (carbon atoms approximately 10-22). It serves as fuel for diesel engines. It is mainly produced by blending diesel fractions obtained from processes such as crude oil distillation, catalytic cracking, thermal cracking, hydrocracking, and petroleum coking. It can also be derived from shale oil processing and coal liquefaction. Diesel is categorized into light diesel (boiling point range approximately 180-370°C) and heavy diesel (boiling point range approximately 350-410°C). It is widely used in large vehicles, railway locomotives, and ships. The most important application of diesel is in diesel engines for vehicles and ships. Differences from gasoline: Compared to gasoline, diesel has a higher energy density and lower fuel consumption rate. Due to its low energy consumption, some small cars and even high-performance vehicles have switched to diesel.
13
1
Share

What are the reasons for the diesel engine's inability to increase speed?

Diesel engine's inability to increase speed is caused by fuel line blockage. Below is relevant information about the car throttle: Throttle: It refers to the control device that regulates engine power (thrust). Throttle pedal: Also known as the accelerator pedal. It is part of the car's fuel supply system. By controlling the amount of pedal depression, it regulates the engine throttle opening, controls the intake air volume, and the computer controls the fuel quantity, thereby controlling the engine speed. Reasons for pedal sticking: Divided into three categories - human error, design defects, and inadequate craftsmanship. The driver information interface displays the odometer, trip meter, exterior temperature indicator, and other gauges.
9
1
Share

Does repairing the frame rail have a significant impact on the car?

Repairing the frame rail has a significant impact on the car. Here is a relevant introduction about automotive configurations: Tire pressure monitoring function: The tire pressure of a car plays a crucial role during driving. If the tire pressure varies, it often leads to increased fuel consumption, louder tire noise, and significantly reduced passenger comfort during driving. The tire pressure monitoring function can monitor the tire pressure of each tire in real-time and display it on the car's onboard computer. Main and passenger airbags: To ensure the safety of passengers in the most dangerous positions in the car, although the effectiveness of airbags is far less than that of seat belts, even an additional 1% safety indicator can save a life.
8
3
Share

Why is Opas film so expensive?

Opas film is so expensive because of its actual effectiveness. Here is a partial introduction regarding fuel consumption: Constant-speed fuel consumption: Constant-speed fuel consumption refers to the fuel economy indicator when a car is driving at a constant speed on a good road surface. Since constant-speed driving is a basic operating condition for cars on highways, and this type of fuel consumption is easy to measure, it is widely adopted. Road cycle fuel consumption: Road cycle fuel consumption is the fuel economy indicator measured when a car drives in repeated cycles according to specified speed and time regulations on the road, also known as multi-condition road cycle fuel consumption. In the speed and time regulations, each cycle includes various driving conditions, and specifies the shift timing, braking and stopping time, as well as the values of driving speed, acceleration, and braking deceleration for each cycle.
12
1
Share

What engine does the Sail use?

The Sail engine is manufactured at the Liuzhou Wuling Engine Plant and is a domestically produced engine. The 1.5L version of the Sail uses an L2B engine model with a maximum power of 76kw and a maximum torque of 127 Nm. The 1.3L version uses an LEW engine model with a maximum power of 83kw and a maximum torque of 141 Nm. For daily maintenance of the Sail engine, the following methods can be used: Use lubricating oil of the appropriate quality grade. For gasoline engines, choose SD--SF grade gasoline engine oil based on the additional equipment of the intake and exhaust systems and usage conditions; for diesel engines, select CB--CD grade diesel engine oil based on mechanical load, with the selection standard not lower than the manufacturer's requirements; Regularly change the oil and filter. The quality of any grade of lubricating oil will change during use. After a certain mileage, its performance deteriorates, leading to various engine problems. To avoid faults, change the oil regularly according to usage conditions and maintain an appropriate oil level; When oil passes through the fine pores of the filter, solid particles and viscous substances in the oil accumulate in the filter. If the filter is clogged and oil cannot pass through the filter element, it may burst the filter element or open the safety valve, allowing oil to bypass through the bypass valve and carry contaminants back to the lubrication area, accelerating engine wear and increasing internal pollution; Regularly clean the crankcase. During engine operation, high-pressure unburned gases, acids, moisture, sulfur, and nitrogen oxides from the combustion chamber enter the crankcase through the gap between the piston rings and cylinder walls, mixing with metal powder from component wear to form sludge. Small amounts remain suspended in the oil, while large amounts precipitate, clogging filters and oil passages, making engine lubrication difficult and causing wear; Regularly use a radiator cleaner to clean the radiator. Removing rust and scale not only ensures the engine operates normally but also extends the overall lifespan of the radiator and engine.
2
3
Share

What is the speed of 80 kilometers per hour?

80 kilometers per hour is a speed of 80 km/h. Below is an introduction about the car's accelerator: The function of the car's accelerator: In gasoline engines, the accelerator does not control the fuel injection amount but regulates the throttle opening size. That is, a smaller opening means less air-fuel mixture enters the cylinder, resulting in lower engine power output, and vice versa. Solution for a heavy accelerator pedal: If the accelerator pedal feels heavy, you can perform a fuel system cleaning. Alternatively, try accelerating further to see if the engine revs increase but the speed does not. If this happens, it might be due to a damaged sensor in the transmission locking the overdrive gear.
11
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.