What Are the Reasons for No Acceleration When Pressing the Gas Pedal Hard?

1 Answers
VonAriel
07/25/25 2:50pm
Here are the main reasons for no acceleration when pressing the gas pedal hard: 1. Engine fuel system malfunction: If low-quality gasoline is used, it may cause the fuel pump to burn out, catalytic converter failure, piston malfunction, etc., directly affecting engine power. This can easily lead to engine stalling, no acceleration when pressing the gas pedal hard, and other phenomena. 2. Abnormal vehicle power: Engine power is generated by the coordinated operation of the intake system, ignition system, and fuel system. If any component malfunctions, it may lead to a decrease in engine power, resulting in no acceleration when pressing the gas pedal hard, body shaking, smoke from the exhaust, etc. 3. If the throttle position sensor is dirty or the voltage is unbalanced, it may cause electronic throttle failure, leading to no acceleration when pressing the gas pedal hard.
Was this review help?
19
2
Share
More Forum Discussions

How to Use the Nissan Factory-installed Dash Cam?

Press and hold for 1-3 seconds to power off; short press after powering on to toggle WIFI on/off. Short press to lock the currently recorded video file and capture a screenshot of the current footage. Short press to start recording. Press and hold for 10 seconds to restore factory settings and format the TF card. Blue LED flashes once per second during recording.
8
5
Share

How to Issue an Invoice for One Vehicle One Ticket?

Open [Invoice Management/Invoice Issuance] in sequence, select 'Motor Vehicle Sales Unified Invoice Issuance', and enter the invoice issuance interface. Fill in the invoice information, verify that the information on the ticket is correct, and then click the 'Print' button in the upper right corner.
2
3
Share

How to Reset the Maintenance Light on a Leopard with One-Key Start?

Press and hold the SET button until the driving menu appears on the display, then select the 'Other Settings' option. The third item in the submenu is the maintenance mileage reset. Hold down both the SET and TRIP buttons simultaneously until the maintenance mileage reset option is highlighted. Wait for it to become adjustable, then press the SET button twice to complete the reset.
18
4
Share

How to Fix the Black Screen Issue on Roewe i5's Central Control?

When the central control screen does not light up, the first step is to check the battery—whether it is functioning normally and has sufficient power. If the central control battery is in good condition, restart the central control to see if it can boot up normally. If the issue persists after these steps, it is recommended to visit a 4S store for further inspection and repair.
1
5
Share

How to Reset the Service Wrench Light on Roewe 350?

Hold down the two arrow buttons and turn on the ignition switch. After about 3 seconds with the ignition switch on, release the two arrow buttons. At this point, the service menu will appear on the display, asking if you want to reset. Hold for more than 3 seconds; press the "mode" button. The service light will then be reset.
2
0
Share

How to Adjust the Screen Brightness of the Avalon?

Use the key to unlock the car door, enter the vehicle, and start the ignition to power on the car. Click the 'Menu' button, and you will find the screen display contrast and brightness adjustment options in the lower right corner. Select and adjust them accordingly.
2
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.