What Are the Reasons for High Fuel Consumption in Cars and Their Solutions?

1 Answers
ClaraFitz
07/30/25 8:04am
Detailed reasons for high fuel consumption in cars and their solutions are as follows: 1. Insufficient tire pressure and tire wear: Low or insufficient tire pressure increases friction between the tires and the ground, leading to greater resistance and higher fuel consumption. Severe tire wear often results in slipping, which also increases fuel consumption. Solution: Replace the tires. 2. Poor-quality gasoline: Low-quality gasoline leads to more carbon deposits, which roughen the intake pipe walls, affecting the intake efficiency and the quality of the air-fuel mixture, causing a sharp rise in fuel consumption. Solution: Use higher-quality gasoline. 3. Prolonged use of the oxygen sensor: The oxygen sensor, a ceramic component located on the engine's exhaust pipe, detects and controls the oxygen-to-fuel ratio. Extended use can prevent the electronic fuel injection system's computer from receiving accurate oxygen concentration information from the exhaust pipe, resulting in a higher concentration of the air-fuel mixture in the engine and increased fuel consumption. Solution: Regularly inspect the oxygen sensor's condition and replace it promptly.
Was this review help?
9
4
Share
More Forum Discussions

How to Install Car Door Anti-Collision Strips?

Method for installing car door anti-collision strips: 1. Wipe the area where the anti-collision strip needs to be installed clean with a towel; 2. Peel off a small portion of the adhesive tape inside the anti-collision strip to better secure its position; 3. Attach the adhesive side of the anti-collision strip to the desired installation area; 4. Press the anti-collision strip along its direction while peeling off the remaining double-sided tape; 5. Trim any excess anti-collision strip that protrudes, and the installation is complete. There are two types of door anti-collision strips: patch-type and strip-type. The patch-type anti-collision strip is a small adhesive block with double-sided tape on one side, usually attached to the most vulnerable areas of the door. This type offers limited protection but has a relatively refined appearance, providing some decorative effect. The strip-type has a U-shaped cross-section with double-sided tape on the inner side of the U. When installed, the U-shaped groove is embedded into the edge of the door. This type offers a larger protective area but has a simpler appearance, which may somewhat affect the vehicle's aesthetics.
6
3
Share

Can I reattach and activate the ETC device myself after it falls off?

No, you cannot use it. The ETC device will become invalid if it is removed by yourself or falls off on its own. This is because the ETC device has an anti-tamper feature. There is a small switch behind the ETC electronic tag, which will automatically shut off once the device is detached from the windshield. Therefore, you must take your vehicle's registration certificate to the ETC service provider for reactivation. ETC Billing Principle: There will be one or more ETC lanes on highways. Through dedicated short-range microwave communication between the vehicle-mounted electronic tag installed on the windshield and the microwave antenna in the ETC lane at the toll station, computer networking technology is used for backend settlement with the bank. This achieves the purpose of vehicles not needing to stop at toll stations to pay road and bridge fees, all based on the principle of "pass first, deduct later." Benefits of Installing ETC: Time-saving: Eliminates the hassle of waiting in queues; Green and eco-friendly: Low-carbon, as vehicles pass through toll stations without stopping, reducing noise and exhaust emissions and minimizing pollution; Reduced wear and tear: Saves costs by reducing the frequency of vehicle starts and brakes, lowering wear and fuel consumption. Users also enjoy a 5% discount on toll fees; Improved efficiency: Theoretically, ETC lanes can increase vehicle throughput by 2-3 times, making traditional ETC faster, more advanced, and more high-tech. Compared to license plate payment, ETC technology is more mature and advantageous. More policy support: The State Council explicitly stated in the "13th Five-Year Plan for the Development of a Modern Comprehensive Transportation System" that "by 2020, the interoperability of transportation cards in key city clusters will be basically achieved, and the proportion of vehicles equipped with ETC will significantly increase." It also set a target in the "13th Five-Year" comprehensive transportation development indicators: "By 2020, the ETC usage rate for road passenger vehicles should reach 50%." More future possibilities: In addition to continuously improving the convenience of ETC installation and usage and increasing the ETC adoption rate for passenger vehicles, efforts will be made to promote ETC usage for trucks in the future. There will also be exploration of deep integration between ETC systems and smart transportation directions such as vehicle-to-vehicle communication and vehicle-to-infrastructure coordination, providing comprehensive travel services for vehicle owners. This means more application scenarios will support ETC usage. Precautions for Installing ETC: Do not obstruct the driver's view; it is best to install it behind the rearview mirror: Many car models have windshields with a steep rearward angle, which can reduce the driver's field of vision. If this is not considered during ETC installation, it may increase blind spots for the driver. Install it on the right side behind the rearview mirror to avoid obstructing the view. Do not interfere with charging: The ETC electronic tag requires power but generally does not need to be charged or have its battery replaced, as it has a solar panel on the back for self-charging. Therefore, avoid installing it on the blackened areas of the windshield or positions that may block the solar panel. Do not remove it randomly once installed: The adhesive in the middle has an anti-tamper rod connected to a switch. Once the electronic tag is installed on the windshield, the anti-tamper rod will be pressed in. If the device is removed, the rod will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You will then need to visit an ETC service point to unlock it. This feature is designed to prevent multiple vehicles from sharing one device. Notes for Using ETC: The ETC transaction sensing range is 8 meters. To prevent issues caused by the ETC device of the vehicle ahead, maintain a distance of at least 10 meters from the vehicle in front to avoid automatic payment for it. The ETC lane recognition speed is 20 km/h; driving too fast may result in failure to read the vehicle's device information and cause billing failure. When using a debit card linked to ETC, insufficient balance may also lead to billing failure.
9
5
Share

What is the purpose of a car's sport mode?

Car's sport mode significantly improves the vehicle's power and acceleration, better unleashing its performance. The working principle involves altering the logic of the transmission's shifting operation in normal mode. In sport mode, the transmission's shifting timing is delayed to maintain higher engine RPM, thereby achieving greater torque output and enhancing the car's acceleration performance. After activating sport mode, the electronic control unit increases the engine RPM to ensure sufficient torque for quick starts and stops. This allows the car's performance to be fully demonstrated, and the previously unexperienced "back-pushing sensation" will follow. Additionally, the car adjusts other settings, such as stiffening the suspension for greater support, increasing throttle sensitivity, boosting engine air intake, and raising fuel consumption. It may even directly modify electronic systems and body configurations, such as deactivating the vehicle stability system and adjusting spoilers. Generally, sport mode is most effective during uphill climbs and overtaking. It can also be used during high-speed driving, where the high engine RPM helps clear carbon deposits. When used correctly, sport mode has minimal negative effects. However, it's important not to keep sport mode constantly activated, as it increases transmission load and temperature, leading to accelerated wear and higher fuel consumption. Sport mode should be used periodically and appropriately to help clear carbon deposits in the engine, improve fuel economy, and extend engine life.
17
5
Share

Where is the cigarette lighter fuse of the Arrizo 5 located?

The fuse box of the Arrizo 5 is located under the air vent on the left side of the dashboard. There is a small pull-out box; removing it reveals the fuse box. On the fuse box, there is a diagram indicating the positions of the fuses corresponding to various electrical devices. You can check the position of the cigarette lighter fuse on this diagram and replace it accordingly. Below is additional information: 1. Replacing the fuse: If an unqualified adapter is used or the connected device has excessive power, it often leads to the cigarette lighter fuse blowing. In this case, the fuse needs to be replaced. 2. Precautions: When replacing a fuse, the specifications on the replacement fuse must match those of the faulty fuse. The fuse should only be replaced after the cause of the fault has been identified and resolved. Never use a fuse with a higher ampere rating than specified or any other object, as this may cause severe damage to the electrical system and potentially lead to a fire. In emergency situations, a fuse with a lower safety rating or a fuse from auxiliary equipment can be used as a temporary replacement.
5
4
Share

What is the button on the Camry gear lever?

The black button next to the P gear on the GAC Toyota Camry is the auto-hold button. When the auto-hold function is activated, the driver does not need to pull up the handbrake when the vehicle is parked. The following is relevant information about the Camry: 1. Versions: The new Camry has three powertrain versions: 2.0L, 2.5L, and hybrid. Although the 2.0L engine is not as impressive as the 2.5L and hybrid versions in this generation of the Camry, it is still not weak and can fully meet daily driving needs. The 2.5L and hybrid engines are among the biggest highlights of the eighth-generation Camry. The 2.5L engine was nominated for the 2018 World's Top 10 Engines, while the hybrid engine was ultimately rated as one of the World's Top 10 Engines, highlighting the advantages of these two engines. 2. Power and fuel consumption: The 2.5L engine has a thermal efficiency of 40%, paired with an 8AT transmission, delivering stronger power and lower fuel consumption. As for the hybrid engine, it has a thermal efficiency of 41%, excellent fuel consumption, and better performance than the 2.5L engine.
17
1
Share

Can the Cadillac XT5 automatically close windows when locking the car?

After the Cadillac XTS is turned off, the windows can be automatically closed. The vehicle's remote key has a lock/unlock button. Press and hold the lock button to close all windows, and press and hold the unlock button to open all windows. The Cadillac XTS windows are equipped with a one-touch up/down feature, which needs to be enabled in the vehicle's personalized settings. Once this function is activated, you can press and hold the switch on the remote key to operate the windows with one touch. Below are the features of the Cadillac's one-touch window operation: 1. Anti-pinch function: Cadillac windows come with an "anti-pinch" feature. The "anti-pinch" function means that during the window's upward movement, if the control system detects resistance, it will stop the window from rising and lower it slightly, preventing the risk of pinching fingers. Some car owners have reported that while they can still feel a relatively strong force when their hand is caught, there is no strong squeezing sensation, possibly due to the slow rising speed of the window, making this function quite effective. 2. Purpose: Mid-to-high-end models are generally equipped with one-touch window operation, primarily for the convenience of drivers and passengers, and to avoid distractions when operating windows, thereby improving safety. One-touch windows usually come with an "anti-pinch" function to prevent the danger of pinching fingers.
19
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.