What are the reasons for failing to book a driving test?

Are There Two Attempts for the Subject 3 Driving Test?

Subject 3 driving test allows two attempts. According to Article 44 of the 'Regulations on the Application and Use of Motor Vehicle Driving Licenses,' each subject test is conducted once, and if the test is failed, a retake is permitted once. If the retake is not attended or still results in failure, the current test session is terminated, and the applicant must reschedule the test. However, for Subject 2 and Subject 3 tests, rescheduling must be done at least ten days later. If the Subject 3 safety and civilized driving knowledge test is failed, the passed road driving skill test scores remain valid. Below are the precautions for the Subject 3 driving test: Perform a pre-drive check; Adjustments after entering the vehicle; Physical movements; Follow voice prompts; Maintain a calm mindset. Perform a pre-drive check: Before entering the vehicle, a full walk-around inspection is required. The test vehicle is equipped with two sensors, and the examinee must be detected by these sensors during the walk-around to complete this step. Failure to do so will result in point deductions. Adjustments after entering the vehicle: Once inside, first adjust the seat to a comfortable position, then fasten the seatbelt—this is the most critical step. Not wearing the seatbelt will result in an immediate failure. Next, adjust the rearview mirrors and ensure the gear is in the correct position before starting the engine. Physical movements: During the test, examinees must perform certain physical actions, such as looking back to observe. These movements must be executed properly to avoid point deductions due to incorrect form. Follow voice prompts: During the test, strictly follow the voice instructions step by step. Premature actions will lead to point deductions. Maintain a calm mindset: It is essential to stay composed during the test. Many examinees become overly nervous upon hearing the voice prompts, leading to forgotten steps. Proper mental preparation before the test is crucial.

18

4

Share

What Causes the Car Ignition Lock Cylinder to Not Turn?

If the car lock cylinder won't turn, it indicates either a problem with the lock cylinder or the steering wheel being locked. First, check the specific reason why the lock cylinder isn't turning. If the lock cylinder is stiff or the key is stuck, you can use a rust remover by spraying it into the keyhole and then moving the key back and forth. Steering Wheel Lock: This is a common anti-theft feature in cars. In this case, don't force the key. The driver should gently turn the key with their right hand while lightly turning the steering wheel with their left hand to align the steering lock's teeth. If it still doesn't turn, try using a spare key. If neither key works, it indicates a problem with the lock cylinder, which should be replaced. The main function of a lock cylinder is to transmit torque from the head, which then drives other parts of the lock, allowing it to open and close. Normally, when the key is inserted, the lock cylinder's pin should drop, aligning all parts on the same plane, enabling the lock cylinder to turn. When the key is removed, the pin pops back up, preventing the lock cylinder from turning. Detailed Cause Analysis: The steering wheel has an ignition switch assembly, with one half being the lock cylinder and the other half the base. If the base is faulty, it must be replaced. If the base lacks lubrication, you can try spraying dashboard wax. The lock cylinder may not turn due to key wear, where the key has become smaller than its original size. When the key is worn to a certain extent, inserting it won't fully lower the lock cylinder's pin, causing misalignment and preventing the lock cylinder from turning. If the issue is due to key wear, consult a professional locksmith to create a larger-sized key based on the worn one.

20

0

Share

What is the content of the automatic transmission subject three test?

Automatic transmission subject three test content: preparation before getting on the car, starting, driving in a straight line, shifting gears, changing lanes, parking on the side of the road, going straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school areas, passing bus stops, meeting cars, overtaking, turning around, and driving at night. Test items and precautions: adjust the seat and rearview mirror before getting on the car, check whether the brake and acceleration are normal. Left and right turns and U-turns (the steering wheel cannot be moved within three seconds of turning on the turn signal, and the speed must match the gear). Passing bus stops, pedestrian crossings, and school areas (the speed cannot exceed 30 km/h, and you must look left and right to see if there are pedestrians passing). Shifting gears (complete the shifting operation within the specified time and distance). Changing lanes and overtaking (the steering wheel cannot be turned within three seconds of turning on the turn signal, and the operation must be completed within the specified time and distance). Driving in a straight line (the speed cannot be lower than 40 km/h, the steering wheel fluctuation cannot exceed three degrees, and the straight-line driving must be completed within the specified distance). Passing traffic lights (stop and wait at red lights, and use first gear when starting after stopping midway). Parking on the side of the road (choose a suitable section to park on the side of the road within the specified distance). The subject three test includes road driving skills and safe and civilized driving knowledge tests, both with a full score of 100 points. A score of 80 and 90 points respectively is required to pass. Automatic transmission is easier than manual transmission because automatic transmission only requires the D gear, and you just need to press the accelerator or brake. Since both manual and automatic transmissions are unfamiliar to beginners, it is necessary to practice hard to master the essence of the test. Without diligent practice, even an automatic transmission vehicle cannot pass the test.

18

3

Share

Does Canceling a Subject 2 Reservation Count as One Attempt?

The traffic management office cancels a Subject 2 reservation once, which does not count as one exam attempt. Introduction: The driver's test (motor vehicle driver's test) is a qualification examination organized by the traffic management office of the public security bureau. Only by passing the driver's test can one obtain a driver's license and legally operate motor vehicles. Exam Subjects: Applicants for a motor vehicle driver's license must pass the following four subjects: Road Traffic Safety Laws, Regulations, and Related Knowledge Exam (Subject 1), Venue Driving Skills Exam (Subject 2), Road Driving Skills Exam (Subject 3), and Safe and Civilized Driving Related Knowledge (Subject 4).

20

1

Share

What is the tire wear resistance index?

Tire wear resistance index refers to the wear resistance performance of the tire, which is the tire wear life grade, usually represented by numbers. The TREADWEAR+number marking on the side of the tire indicates the tire wear resistance index. The wear resistance coefficient is TREADWEAR+number, for example, TREADWEAR280 means the tire's wear resistance is 280% of the standard tire. It should also be noted that a higher tire wear resistance index is not always better, as its improvement often comes at the cost of losing other performance aspects, such as handling and comfort. Except for vehicles used for commercial purposes, a wear resistance index of around 200-350 is generally considered good. The wear resistance of a tire should not be judged solely based on its wear resistance index. It should be evaluated in combination with driving conditions and habits. When the tire wears down to the wear indicator mark, it should be replaced promptly. Generally, the service life of a tire is about 5 years, and the production date is also marked on the side of the tire. If the tire shows no obvious wear but has been in use for more than 5 years, replacement is still recommended because tires are rubber products that can age over time, develop cracks, and pose a risk of blowouts, endangering driving safety.

13

0

Share

What is an Electronic Driver's License?

An electronic driver's license is a digital version of the physical driver's license, serving as a supplement to the physical document. In cases where the physical license is not carried, the electronic version can be used for road inspections and other purposes. Definition of an electronic driver's license: As a supplement to the physical document, the electronic version can be used for road inspections and other purposes when the physical license is not carried. Development history of electronic driver's licenses: On April 12, 2017, the Yancheng Traffic Police introduced an electronic driver's license, primarily to provide convenience to the public, not to encourage drivers to stop carrying their physical licenses. On May 10, 2021, the Ministry of Public Security held a press conference to announce 12 convenience measures for deepening public security and traffic management reforms, stating that starting from June 1, 2021, electronic motor vehicle driver's licenses would be piloted in three cities: Tianjin, Chengdu, and Suzhou.

8

4

Share

What are the reasons for failing to book a driving test?

Are There Two Attempts for the Subject 3 Driving Test?

What Causes the Car Ignition Lock Cylinder to Not Turn?

What is the content of the automatic transmission subject three test?

Does Canceling a Subject 2 Reservation Count as One Attempt?

What is the tire wear resistance index?

What is an Electronic Driver's License?

Do I Need to Wait for the Left Turn Signal When Making a U-Turn in the Left Turn Lane?

What Causes Gear Shifting Jerk in Automatic Transmissions?

Under What Circumstances Can Insurance Cover Water Damage Inside the Vehicle?

Can a B2 license be upgraded to an A1 driver's license?