What Are the Reasons for All Warning Lights on the Car Dashboard Illuminating?

1 Answers
EleanorAnn
07/30/25 2:35am
Car dashboard warning lights all illuminating is due to: 1. ECU CAN bus failure, poor contact at the ECU CAN interface; 2. Excessive dirt and carbon deposits, abnormal air flow, leading to inaccurate control of normal air intake and unstable gas content; 3. Low fuel pressure combined with poor constant pressure performance results in low system atomization levels, making the car difficult to start. The solutions for all dashboard warning lights illuminating are: 1. Check if there are any issues with the battery terminals, disconnect and reconnect the negative terminal, then start the car; 2. Measure the generator's output voltage—if it's around 14V, it indicates the issue is not insufficient generator output; 3. Use a diagnostic tool to read fault codes and narrow down the analysis based on the codes.
Was this review help?
9
4
Share
More Forum Discussions

How often should RAV4 tires be replaced?

RAV4 tires typically need to be replaced every 3 years or around 50,000 kilometers, depending mainly on the degree of tire wear. If the tread wears down to the triangular mark on the tire sidewall, replacement is necessary. If this mark cannot be found, visually inspect the tire tread pattern; if it's significantly worn, replacement is also required. The RAV4 is a compact SUV under Toyota, with a wheelbase of 2690 mm, and dimensions of 4600 mm in length, 1855 mm in width, and 1680 mm in height. The RAV4 is equipped with two types of engines: a 2.0-liter naturally aspirated engine and a 2.5-liter naturally aspirated engine.
17
5
Share

Why does the car ABS pump keep buzzing?

Car ABS pump keeps buzzing is the self-check of the ABS pump. The following are specific introductions to the ABS light being on: 1. Front wheel skidding: such as driving on icy or snowy roads. Because the rotation conditions of the front and rear wheels are different, and the brakes are applied at the same time, it is easy to cause a difference in the braking of the front and rear wheels, and the ABS light will come on. In this case, stepping on the brakes a few more times will turn off the ABS light. 2. The sensor is covered by contaminants: The sensing part of the ABS speed sensor on the wheel is covered by dirt, mud, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal, making the ABS computer unable to determine the speed, unable to determine the wheel's slip rate, and thus unable to issue corresponding action commands to adjust the braking.
2
4
Share

Is There a 30 km/h Speed Limit and Speed Detection in School Zones?

Generally, there is a 30 km/h speed limit near schools, and in practice, corresponding instruments are used for speed detection and monitoring. If the speed exceeds 50%, i.e., the speed is over 45 km/h, 12 points will be deducted from the driver's license, and a fine will be imposed. Below are the relevant details: 1. Detail one: On roads without a central dividing line, the speed limit is 30 km/h for urban roads and 40 km/h for highways. 2. Detail two: On roads with only one lane in the same direction, the speed limit is 50 km/h for urban roads and 70 km/h for highways. 3. Detail three: On expressways, the maximum speed for small passenger vehicles must not exceed 120 km/h, and for other motor vehicles, it must not exceed 100 km/h.
7
5
Share

What are the reasons for difficulty in shifting gears after starting the car?

Reasons for difficulty in shifting gears after starting the car: 1. The synchronizer is not working properly, excessively worn, or damaged; 2. The gear lever is deformed or loose; 3. The clutch is not fully disengaged, failing to completely cut off the power. When shifting gears, the clutch and throttle should be well coordinated. Press the clutch pedal all the way down, then immediately release the throttle pedal, and quickly shift to the corresponding gear. Gear shifting should be done according to the car's speed: start in first gear, shift to second gear after driving a few meters; shift to third gear when the speed reaches above 20 mph but below 35 mph; shift to fourth gear when the speed reaches above 35 mph but below 45 mph; and shift to fifth gear when the speed exceeds 45 mph.
18
2
Share

Can You Still Drive When the Turbocharger Glows Red?

It is normal for the turbocharger to glow red during operation, and you can continue driving. Here are the details: 1. Glowing during operation: The phenomenon of the cast iron shell turning red due to prolonged operation of the turbocharger is a design consideration, so there is no need to worry about its lifespan. The R&D engineers have already planned cooling solutions when designing the engine. 2. Turbocharger maintenance: Keeping the turbo clean mainly involves changing the engine oil and air filter. Oil changes are a routine maintenance task for every car, as engine oil can be considered the lifeblood of the engine. Turbocharged engines operate in harsh conditions, so the lubricating role of the oil is essential, making regular oil changes important. The air filter determines the cleanliness of the turbo and should also be replaced periodically.
7
1
Share

What is the equivalent car engine displacement for a 150cc motorcycle?

Motorcycle 150 is equivalent to a car with 1.0 displacement. Fluid volume: Displacement is a specialized term in hydraulic transmission, referring to the volume of fluid inhaled or discharged per stroke or cycle. Generally, a larger displacement means the engine releases more energy per unit time, which translates to better "power performance". Off-road vehicles and sports cars usually have relatively larger displacements. Cylinder displacement: The working volume through which the piston moves from the top dead center to the bottom dead center is called the cylinder displacement; if the engine has multiple cylinders, the sum of the working volumes of all cylinders is called the engine displacement. It is usually expressed in liters (L). Engine displacement is one of the most important structural parameters, representing the size of the engine more accurately than cylinder diameter and number of cylinders. Many engine indicators are closely related to displacement.
17
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.