What Are the Reasons for a Car Not Starting Even When the Battery Has Power?

2 Answers
Madelyn
09/01/25 4:16am
Reasons for a car not starting even when the battery has power include incorrect gear selection, running out of fuel, or a malfunctioning fuel pump. Specific explanations are as follows: Incorrect gear selection: If the gear is set to D (Drive) or R (Reverse), the car will not start. The car can only be started when the gear is in P (Park) or N (Neutral). Running out of fuel: Apart from a dead battery causing the car not to start, running out of fuel will also prevent the car from starting. This usually happens when the engine is left running while the car is parked, leading to fuel depletion and battery drain, making it impossible to start the car. Fuel pump malfunction: If the starter motor operates normally when attempting to start the car but the engine does not ignite, it is necessary to check the fuel lines.
Was this review help?
15
0
Share
JudeDella
09/13/25 7:04am
As an experienced driver, I've seen plenty of cases where cars won't start. When the battery clearly has power but the engine cranks weakly like it's half-asleep, it usually comes down to a few common culprits: The worst scenario is a faulty starter motor, which means you'll need a tow to the shop. Another possibility is poor contact in the ignition switch - sometimes tapping below the steering wheel can provide a temporary fix. If the key symbol on the dashboard keeps flashing, it's likely an anti-theft system glitch; try placing the key against the steering column. Loose wiring connections are frequent offenders too, especially noticeable on rainy days. The most perplexing issue is when the crankshaft position sensor fails - the engine itself is fine, but the car gets confused when this sensor slacks off. Modern cars have added another headache: some designs absolutely refuse to start unless you press the brake pedal, so check if your floor mat is blocking it.
Was this review help?
5
0
Share
Expand All
More Forum Discussions

How to activate the automatic handbrake on a Camry?

Mechanical handbrake, located on the left side of the gear lever, is engaged by lifting the handbrake lever and released to allow the vehicle to move. Electronic foot brake, located on the left side of the brake pedal, is engaged by pressing the brake with the left foot to stop the vehicle, and released by pressing and then lifting the foot. Electronic handbrake, located behind the gear lever, is engaged by lifting it with a finger when the vehicle is stationary, and released by pressing the brake pedal and then pressing the electronic handbrake button before starting the vehicle. Alternatively, it can be automatically released by lightly pressing the accelerator while wearing the seatbelt.
19
1
Share

What are the correct driving steps for an automatic transmission car?

The correct driving steps for an automatic transmission car: 1. Turn the ignition key to the second position (power mode) to allow the car's computer system to perform self-check for at least 6 seconds. 2. Press the foot brake and shift the gear from P to N. 3. Release the foot brake and turn the ignition key to start the engine. 4. When starting the car after prolonged parking, it's recommended to warm up the engine for 1-2 minutes while stationary. 5. Press the foot brake and shift the gear from N to D, then release the parking brake (for electronic parking brake, simply press the button briefly). 6. Gradually release the foot brake to start moving. 7. Apply the accelerator smoothly according to road conditions for safe driving.
2
1
Share

What Causes the Abnormal Noise After Installing Snow Tires?

The reasons for abnormal noise after installing snow tires include severely worn brake pads, damaged shock absorbers, deformed wheel hubs, tire wear, or damaged drive shafts. Causes: The vehicle's braking force will decrease when encountering objects like nails or stones. Solutions: Promptly replace the brake pads. If the wear on the left and right drive wheels is uneven, it is generally recommended to first install new tires on the non-driven wheels for some mileage. After the four tires have worn in, perform a cross rotation. For regular use, it is best to perform a cross rotation every 20,000 kilometers, as the driven wheels are dragged along and tend to wear unevenly compared to the drive wheels. Have a repair shop inspect further. Replace the wheel hub if necessary.
1
1
Share

What brand is Qoros?

Qoros is an independent automotive brand, which was founded in China. Qoros Auto is a joint venture company providing automotive products and services, headquartered in Changshu, Jiangsu. The models under the Qoros brand include: Qoros 3, Qoros 7, Qoros 5, Qoros 3 City SUV, and Model Young. Taking the Qoros 3 as an example: it is a compact car with a length, width, and height of 4627mm, 1839mm, and 1445mm respectively, and a wheelbase of 2702mm. In terms of power, the Qoros 3 is equipped with an L4 turbocharged engine, paired with a CVT continuously variable transmission, delivering a maximum power of 115kw and a maximum torque of 230nm.
16
4
Share

How to Playback Recorded Videos on Camry Dash Cam?

Remove the TF memory card from the dash cam, insert it into a card reader, and then connect it to a computer to access the recorded content. Connect the dash cam to a computer using a USB cable, and the computer will recognize the dash cam as a mass storage device. The dash cam is equipped with a display screen. You can playback videos directly on the dash cam. The general method is to first pause the recording, then press the "MODE" button. Locate the recorded video and click "OK" to play it. Press the MODE button to make a selection and click on the recorded video file.
14
3
Share

What causes the airbag warning light to illuminate on the dashboard?

The reasons for the airbag warning light illuminating on the dashboard: 1. Foreign objects around the airbag sensor wiring harness, especially metal debris causing a short circuit, leading to false warnings. 2. The warning light may illuminate due to erroneous data reported by the car's ECU sensor. 3. If the warning light comes on without reason, it is likely caused by the vehicle being parked in a humid environment for a long time or moisture in the wiring connectors during car washing, resulting in a short circuit. 4. A fault in the airbag itself, mostly caused by loose connectors. However, if the USB also fails, the fault in the airbag itself can be largely ruled out.
13
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.