What are the reasons for a car feeling sluggish and not accelerating when stepping on the gas pedal?

1 Answers
OKiara
07/29/25 3:48pm
The reasons for a car not accelerating when stepping on the gas pedal include clutch slippage, poor fuel quality, throttle carbon buildup, small engine displacement, or excessive vehicle load. Clutch slippage: When you press the gas pedal hard, the engine RPM increases quickly, but the vehicle speed does not rise accordingly; prolonged coasting with the clutch engaged; not fully depressing the clutch when shifting gears, resulting in incomplete gear engagement; or keeping the vehicle in a semi-clutch state for extended periods. It is important to maintain good driving habits, use the clutch properly, and replace the clutch disc if necessary. Poor fuel quality: Using low-quality fuel can affect the gasoline filter and fuel lines, leading to poor fuel supply and resulting in weak acceleration. It is necessary to switch to qualified gasoline. Throttle carbon buildup: Carbon deposits accumulating on the throttle can affect the air intake volume, leading to insufficient engine power and the car's inability to accelerate when stepping on the gas. Regular cleaning of throttle carbon deposits is required. Small engine displacement or excessive vehicle load: If this is the case, it is considered a normal phenomenon. How the gas pedal works: When the gas pedal is pressed, it directly controls the throttle. The throttle opening increases, allowing more air to enter the engine. At this point, the ECU commands the fuel injection system to inject more fuel, increasing the engine RPM and causing the car to accelerate.
Was this review help?
7
4
Share
More Forum Discussions

How to Remove the Rear Seats of Jetta VS5?

Jetta VS5 body dimensions are: length 4419mm, width 1841mm, height 1616mm, wheelbase 2630mm, fuel tank capacity 51l, luggage compartment volume 482l. Jetta VS5 is equipped with a 1.4t turbocharged engine, with a maximum power of 110kw and a maximum torque of 250nm, matched with a 5-speed manual transmission. The front suspension type is MacPherson independent suspension, and the rear suspension type is multi-link independent suspension.
11
2
Share

Is MG a Domestic Car Brand?

MG is a domestic car brand, and its models include: MG6, MG5, MG ZS, MG HS, MG Pilot, etc. Taking the 2020 MG6 as an example, its body dimensions are: length 4704mm, width 1848mm, height 1466mm, with a wheelbase of 2715mm. The 2020 MG6 is equipped with a 1.5T turbocharged engine, delivering a maximum power of 133 kW and a maximum torque of 285 Nm. It is paired with a 6-speed manual transmission. The front suspension uses a MacPherson independent suspension, and the rear suspension employs a multi-link independent suspension.
7
2
Share

What brand are the original tires on the Jeep Cherokee?

The original tires on the Jeep Cherokee are Bridgestone. Tires are circular elastic rubber products assembled on various vehicles or machinery to roll on the ground, usually mounted on metal rims. They support the vehicle body, cushion external impacts, ensure contact with the road surface, and maintain the vehicle's driving performance. The dimensions of the Jeep Cherokee are: length 4669 mm, width 1865 mm, height 1691 mm, with a wheelbase of 2707 mm. The Jeep Cherokee is equipped with a 2.0T turbocharged engine, delivering a maximum power of 195 kW and a maximum torque of 400 Nm, paired with a 9-speed automatic transmission.
8
5
Share

Should Windshield Washer Fluid Be Diluted with Water?

Whether windshield washer fluid should be diluted with water depends on the type of fluid: 1. Ready-to-use liquid windshield washer fluid does not need dilution and can be directly poured into the reservoir; 2. Solid windshield washer fluid requires dilution, as it needs to be dissolved in clean water before use; 3. Highly concentrated liquid windshield washer fluid must be diluted with water in the correct proportion, as direct use can be too corrosive. Windshield washer fluid, short for automotive windshield cleaning fluid, mainly consists of water, alcohol, ethylene glycol, corrosion inhibitors, and various surfactants. Based on its form, windshield washer fluid can be categorized into solid and liquid types, both providing cleaning and antifreeze properties.
2
5
Share

How to Adjust the Headlight Height of the Tayron?

The method to adjust the headlight height of the Tayron is: Press the small lever near the front wheel, and the two sensors at the front and rear will detect the vehicle's height. Adjust the height of the headlights by raising the front sensor or lowering the rear sensor. The dimensions of the Tayron are: length 4453mm, width 1841mm, height 1632mm, with a wheelbase of 2680mm. The Tayron is equipped with a 1.4T turbocharged engine, delivering a maximum power of 110kW and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission. It features a front MacPherson independent suspension and a rear multi-link independent suspension.
17
0
Share

How to deal with scratches under the front bumper?

Scratches under the front bumper can be dealt with as follows: 1. If the scratch is not extensive, follow the normal paint repair procedure to restore it to its original condition; 2. If the scratch is extensive, or there is even cracking or breakage, use plastic welding, metal welding, or special techniques like fiberglass welding for repair, followed by the normal paint repair procedure to restore its appearance. The front bumper consists of an outer panel, cushioning material, and a crossbeam, and its functions are: 1. To provide cushioning and protect the front and rear body of the car in low-speed collisions; 2. To protect pedestrians in case of an accident involving pedestrians; 3. To serve a decorative purpose.
3
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.