What are the pros and cons of powering a dash cam from the fuse box?

What are the reasons for the frequent low battery level in the third-generation Haval H6?

It may be due to battery quality issues. The electricity consumed when starting the car requires the car's alternator to run steadily for at least 25 minutes to recharge the battery. Here are some related explanations: 1. Vehicle circuit leakage: Battery failure leads to weakened power storage capacity. The driving distance is too short (too many engine starts). There are electrical appliances that are not turned off after the vehicle is parked. It is recommended to contact the local 4S store for inspection and repair. 2. Working principle: The battery, also known as a storage battery, is a type of battery. Its working principle is to convert chemical energy into electrical energy. Usually, the battery people refer to is a lead-acid battery. That is, a battery mainly made of lead and its oxides, with sulfuric acid solution as the electrolyte.

12

1

Share

What is the Difference Between 5w20 and 5w30?

Here are the detailed differences between 5w20 and 5w30 engine oils: 1. Fuel consumption: 20-grade oil offers better fuel economy, is more fuel-efficient, but comes at a higher price. 5W30 oil has higher viscosity limits, resulting in greater engine operating resistance, higher fuel consumption, but better sealing performance and quieter engine operation. 2. Low-temperature performance: Both 5W20 and 5W30 oils have the same low-temperature performance. The difference lies in the number after the W, which represents the oil's high-temperature viscosity. The larger the number, the higher the viscosity. 3. Oil selection: When choosing oil viscosity, consider the age of the vehicle. Newer vehicles with smaller engine component clearances should use lower viscosity oil, while vehicles with significant engine wear should opt for higher viscosity oil.

5

Share

How Much is Half a Turn of the Steering Wheel?

Turning the steering wheel half a turn rotates the wheels approximately 15-20 degrees, while a full turn rotates them about 40 degrees. The steering ratio varies slightly for each vehicle and can be adjusted in some high-end cars and sports cars. Here is some relevant information about car steering wheels: 1. Definition: The wheel-shaped device used to control the direction of the car, which converts the force applied by the driver on the edge of the steering wheel into torque and transmits it to the steering shaft. 2. Grip: If the steering wheel is viewed as a clock face, the correct hand position is to place the left hand between the 9 and 10 o'clock positions and the right hand between the 3 and 4 o'clock positions. This posture provides better support for the body in the event of a collision. 3. Materials: - The frame is usually made of zinc alloy or aluminum alloy. Some manufacturers are experimenting with cheaper and lighter magnesium alloys. The frame is produced through die-casting. A few manufacturers still use steel sheet metal for the frame, which is more structurally complex.

4

Share

How to Drive to Annual Inspection with an Expired Vehicle Inspection?

If your vehicle inspection has expired and needs an annual inspection, you can drive directly to the inspection station. If a supplementary inspection is required, the vehicle owner must personally submit a written application for supplementary inspection to the traffic police department and promptly take the vehicle to the inspection station for the annual check. Additionally, if the inspection is overdue, you need to contact a traffic officer on the road or visit the traffic police station to first obtain an overdue penalty ticket, which involves a 3-point deduction and a fine. Then, take the overdue penalty ticket to the inspection station for the required tests. Below are the precautions for vehicles that have not undergone annual inspection: 1. Accident Liability: For any traffic accidents caused by a vehicle that has not undergone the annual inspection on time, the involved party will bear full or primary responsibility, and the insurance company will not be liable. This is because the insurance policy specifies that vehicles with expired inspections are among the objects for which claims are denied. 2. Mandatory Scrapping: According to the 'Regulations on the Mandatory Scrapping Standards for Motor Vehicles,' if a motor vehicle fails to obtain an inspection qualification mark for three consecutive inspection cycles after the expiration of its inspection validity period, it will be mandatorily scrapped.

6

2

Share

What are the causes of abnormal noise in Xichai engines?

Here is a detailed introduction to the causes of abnormal noise in Xichai engines:1. Valve noise: During idle, apply a slight throttle and observe if the frequency changes. If the frequency remains unchanged, it is the sound of the solenoid valve; if the frequency changes, it is valve noise.2. During startup: When the car is cold started, the engine noise is slightly louder than when the engine is warm. As long as the sound is uniform, smooth, and not harsh, there is no problem. This is because, during a cold start, the gap between the cylinder wall and the piston has not yet reached the optimal size, and the lubrication from the engine oil is insufficient. When the engine block temperature reaches around 95 degrees, the sound will return to normal.3. Engine oil issues: Poor-quality engine oil, prolonged lack of oil changes, or insufficient oil can increase friction between the valves and guides, as well as hydraulic lifters, causing various noises in the engine to become louder.

2

4

Share

How to Deal with Waterlogged Car Carpets?

When car carpets get waterlogged, the first step is to remove the seats and carpets, then use a dryer to dry both the carpets and the underlying sponge. If the waterlogging is severe, it's essential to thoroughly dry the carpets and the sponge beneath them to prevent mold and unpleasant odors. Here are methods to identify flood-damaged and accident-damaged vehicles: 1. Inspect the Car Locks: Check for signs of forced entry, tampering, or adhesive injection. Use the key to open each door to verify if all locks are from the same set and operate smoothly. Difficulty in turning the key, especially to the point of nearly breaking it, may indicate water damage causing rust in the central control motor, leading to malfunction. 2. Engine Compartment: Examine the brackets of the lighting and signal lamp groups in the engine compartment for breaks or looseness. Inspect wire connectors and sockets; the presence of excessive mud or rust spots suggests potential flood damage. 3. Engine Room Assessment: Check the wiring and vacuum tubes on the engine body, as well as the gaps between high-voltage ignition coils and spark plugs for mud traces. Assess whether the aging and cracking of pipelines and wires align with the vehicle's age, and check the stability of fuel injector mounts. Rust on springs can also help determine the likelihood of flood damage.

5

Share

What are the pros and cons of powering a dash cam from the fuse box?

What are the reasons for the frequent low battery level in the third-generation Haval H6?

What is the Difference Between 5w20 and 5w30?

How Much is Half a Turn of the Steering Wheel?

How to Drive to Annual Inspection with an Expired Vehicle Inspection?

What are the causes of abnormal noise in Xichai engines?

How to Deal with Waterlogged Car Carpets?

How to Handle the Physical Examination for Online Driver's License Renewal?

Can a motorcycle still be deregistered after being sold?

Where to Obtain a Vehicle Transfer Certificate?

Does Water Inside the Cabin Count as a Flood-Damaged Vehicle?