What are the precautions for Subject 3?

2 Answers
LaJulianna
07/28/25 5:00pm
Subject 3 has the following precautions: 1. Check before getting in the car: Before the Subject 3 test, you need to walk around the car for inspection. There are usually two sensors on the test car, one at the front and one at the rear. When walking around the car, you need to pause briefly near the sensors to ensure they detect you. 2. Adjust before operating: Adjust the car's rearview mirrors and seat height, then confirm if they are suitable. When observing through the rearview mirrors, make sure you can see the rear wheels. Fasten your seatbelt and ensure the gear is in neutral before starting the engine. 3. Light simulation test: The light simulation test requires flexible mastery. Learn the skills of using lights during practice and perform the relevant light operations within 5 seconds after the test instruction is given. 4. Follow the instructions: During Subject 3, you need to follow the instructions. Listen carefully to the instructions before operating, and do not act before the voice announcement ends, as this may lead to point deductions.
Was this review help?
14
1
Share
IsabellaRose
08/11/25 11:32pm
The third subject exam is the actual road driving segment, and I believe the key is to perform the basic operations smoothly. Before getting in the car, adjust the seat and rearview mirror positions to ensure a clear field of vision. When starting, you must first observe the traffic behind, turn on the turn signal for three seconds before moving, otherwise points will be deducted. When changing lanes, pay attention to the rearview mirror and blind spots, and only switch lanes when it's safe. Speed control is also crucial—don't exceed the speed limit in restricted zones, especially near intersections or school areas where you should maintain below 30km/h. The parking segment is where most mistakes happen: get close to the curb, leave space front and back, and don’t mix up the sequence of pulling the handbrake and turning off the engine. Practice more simulations to familiarize yourself with the test route, which can reduce exam nerves. If you make a mistake, don’t give up—keep driving, as the examiner evaluates overall performance. Stay calm and treat it like everyday driving; this will significantly improve your pass rate.
Was this review help?
5
0
Share
Expand All
More Forum Discussions

What brand is Scorplon tire?

Pirelli's tire series includes the Scorpion tire. The term 'Scorpion' translates to 'scorpion' in Chinese, hence the Scorpion series is referred to as the scorpion series tires. These tires feature a scorpion logo on the sidewall and are Pirelli's SUV tires. Currently, the most renowned tires in this series are the Scorpion Verde and Scorpion Verde All Season, each with distinct tread patterns and characteristics. Alongside the P Zero series, it is one of Pirelli's primary SUV tire offerings. The Scorpion Verde is an eco-friendly SUV tire designed for mixed and urban road conditions. It incorporates Pirelli's latest materials, structure, and tread pattern designs, delivering excellent performance in terms of economy, environmental friendliness, comfort, and safety across various road conditions. Its pitch sequence and phased tread design effectively reduce internal noise, enhancing ride comfort. The Scorpion Verde All Season is another eco-friendly SUV tire. It utilizes Pirelli's newly developed rubber compounds and silica-infused treads for more uniform wear. The closely spaced sipes and wide continuous longitudinal grooves efficiently disperse water, improving lateral stability and traction for safer driving. Pirelli, founded in Italy in 1872, is one of the world's most renowned tire companies and the primary sponsor of Inter Milan Football Club. With 24 factories across 12 countries, Pirelli places significant emphasis on the Chinese market. Its tires are widely recognized by prestigious automakers such as Audi, Bentley, Ferrari, Lamborghini, BMW, and Mercedes-Benz, often serving as original equipment tires. Tires operate under complex and demanding conditions, enduring various deformations, loads, forces, and temperature extremes. Thus, they must possess high load-bearing, traction, and cushioning capabilities, along with excellent wear and flex resistance, low rolling resistance, and minimal heat generation. Directly contacting the road, tires work with the vehicle's suspension to absorb shocks, ensuring ride comfort and smoothness, while maintaining good road adhesion to enhance traction, braking, and maneuverability, all while supporting the vehicle's weight. Scorpion Tire Maintenance Tips: Enhance awareness of tire safety and conduct regular inspections. Periodically correct wheel balance to prevent high-speed vibrations and uneven tire wear. Rotate tires every 5,000 km to ensure even wear across all tires on the vehicle. Daily Use Tips for Scorpion Tires: Regularly check for surface defects like cracks or deformations. As treads wear down, their grooves shallow, reducing water drainage and anti-skid performance, which can significantly degrade vehicle performance. Small cracks may pose a risk of blowouts at high speeds. Remove stones lodged in grooves promptly. Park on level ground, avoiding areas with thick, sharp, or pointed stones. Keep away from petroleum products, acids, or other materials harmful to rubber. Avoid turning the steering wheel while parked to prevent accelerated tire wear. Allow tires to cool naturally in hot weather or after high-speed driving; never deflate or splash water to cool them, as this can cause abnormal tread aging. Avoid sudden braking to minimize tire drag and tread wear.
12
5
Share

What is the removal direction of a square taper bottom bracket?

The removal direction of a square taper bottom bracket is counterclockwise. Below is relevant information about square taper bottom brackets: 1. Concept: It is an improvement upon the traditional cottered bottom bracket. Cottered bottom brackets are secured by a single cotter pin, which has a small contact area and is prone to loosening and damage. They are now only found in very old civilian bicycles. The performance improvement of square taper bottom brackets lies in increasing the contact surfaces from 1 to 4. 2. Features: More even force distribution, higher strength, better power transmission, excellent waterproofing and lubrication. Long service life.
16
3
Share

How much damage can a side mirror cause when hitting a person?

Being hit by a side mirror can cause pain. Here is relevant information about side mirrors: 1. Principle: When parallel light rays hit a convex mirror, the reflected rays diverge, thereby expanding the field of vision. This allows for better awareness of vehicles behind without the driver needing to deliberately look at the convex mirror—peripheral vision is sufficient to observe the rear. 2. Precautions: Before driving, adjust the position and angle of the side mirrors. During driving, vehicle vibrations may alter the mirrors' position and angle, so it's important to monitor and readjust as needed.
14
4
Share

What brand of tires does the Baojun 360 use?

The Baojun 360 currently uses Kumho Solus HS61 tires. The tire model size is 185/65R15, which is designed for wear resistance. Tire introduction: 1. Tires are round, elastic rubber products mounted on various vehicles or machinery that roll on the ground. 2. Tires are usually mounted on metal rims to support the vehicle body, cushion external impacts, maintain contact with the road surface, and ensure driving performance. 3. Tires often operate under complex and demanding conditions, enduring various deformations, loads, forces, and temperature extremes during use, so they must have high load-bearing, traction, and cushioning performance.
3
3
Share

What Do Red and Yellow Colors Mean in Navigation?

In navigation systems, dark red indicates severe traffic congestion, red represents congestion, yellow signifies slow-moving traffic, green denotes smooth traffic flow, solid blue lines indicate roads with no traffic information, dashed blue lines represent internal roads (including non-navigable routes), and gray dashed lines mark roads inaccessible to vehicles. Additional information: An automotive navigation system primarily consists of a navigation host unit and a display terminal. The built-in GPS antenna receives data signals from at least three of the 24 GPS satellites orbiting Earth, enabling it to determine the vehicle's current position. By matching the coordinates obtained from GPS satellite signals with digital map data, the navigation host can pinpoint the vehicle's exact location on the electronic map.
1
4
Share

What is generally broken when the navigation screen goes blank?

The causes of a blank screen in a car navigation system include unstable current, screen damage, wiring issues, IC and motherboard problems, as well as full memory or insufficient memory leading to navigation program errors causing the blank screen. Solutions: When the car navigation screen goes blank, the first step is to try restarting by cutting off the power. If that doesn't work, you can delete some unimportant content. Finally, you can also take it to a 4S store to upgrade the navigation board. Car navigation uses onboard GPS (Global Positioning System) in conjunction with electronic maps to conveniently and accurately guide drivers to their destination via the shortest or fastest route, making it a great assistant for drivers.
20
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.