What are the precautions for starting on a slope in Subject 2 of the driving test?

1 Answers
OVanessa
07/25/25 2:25am
Precautions for starting on a slope in Subject 2 of the driving test: 1. The initial state should be in neutral with the brake pedal pressed; 2. Pull up the handbrake as tightly as possible; 3. Slowly release the brake pedal to ensure the vehicle does not roll back when the brake is fully released, and tighten the handbrake again if necessary; 4. Press the clutch and shift into first gear; 5. Gently press the accelerator to keep the engine speed between 1500 and 2000 RPM; 6. Release the clutch gradually, first to the half-clutch position, then continue to release it slowly while maintaining the throttle to ensure engine speed. Tips for parking within 30 cm on a slope: 1. Observe the left reinforcement rib on the front of the car, which is the raised line on the left side of the front. When the left reinforcement rib aligns with the center of the lane, the distance between the car body and the side line will be 30 cm; 2. Align the raised part of the left wiper with the white line on the right side of the ground, and then confirm by checking the right rearview mirror.
Was this review help?
19
5
Share
More Forum Discussions

What are the symptoms of valve leakage?

Automotive valve leakage manifests as weak vehicle performance, difficulty in starting/accelerating, decreased engine power leading to increased fuel consumption, and over time, noticeable carbon buildup in the engine system. The following are the manifestations of valve leakage: 1. Reduced sealing between the valve and valve seat due to valve erosion. 2. Poor grinding of the valve sealing ring during maintenance. 3. Valve clearance adjusted too small, resulting in incomplete valve closure. 4. Foreign objects causing poor sealing when the valve is installed into the valve seat. 5. Carbon buildup on the conical surface of the valve and valve seat. 6. Pitting, scratches, stains, burns, or dents on the valve working surface. 7. Excessive runout of the valve and valve stem. 8. Excessive coaxiality deviation between the valve guide hole and seat hole.
10
4
Share

What to Do When the Key is Locked Inside the Chevrolet Cavalier?

Here are the solutions for when the key is locked inside the Chevrolet Cruze: 1. You can go home and get the spare key to unlock the car door. 2. Enter through the trunk to retrieve the key or use a stick to fish it out. 3. You can call a locksmith to open the car door. Below is more information about opening the car door without a key: 1. Generally, cars nowadays come with two keys—one for regular use and the other as a spare. If the regular key is lost, the spare key can come in handy. You can either go back home to get it or ask a family member to bring it to you. Always remember not to leave the spare key inside the car. 2. Retrieve the key through the trunk. Since modern car keys are not the old-fashioned type, as long as the key is within the detectable range, the trunk can be opened. After opening the trunk, there is usually a "small door" connecting the trunk and the interior of the car. You can crawl through to get the key or use a stick to pull it towards you.
19
0
Share

How to Add Coolant to a BMW?

Here is the method for adding coolant to a BMW: 1. Open the engine hood and locate the coolant reservoir on the left side of the engine compartment; 2. Open the reservoir filler port to add coolant. Below is more information about BMW cars: 1. BMW models include: BMW 5 Series, BMW 3 Series, BMW X1, BMW X5, BMW X3, etc. 2. Taking the BMW 5 Series as an example, it belongs to the mid-to-large-sized car category, with body dimensions of: length 5106mm, width 1868mm, height 1500mm, and a wheelbase of 3105mm. 3. The BMW 5 Series is equipped with a 2.0T turbocharged engine, with a maximum power of 135kW and a maximum power speed of 5000 to 6500 rpm, paired with an 8-speed automatic transmission.
16
4
Share

Differences Between Full-Size and Non-Full-Size Tires

The differences between full-size and non-full-size tires are as follows: Size difference: A full-size spare tire refers to a spare tire with the same specifications as the four original tires on the car, usually equipped with the same rim as the original wheel; a non-full-size spare tire is narrower in tread width or has a smaller rim size, typically using a steel rim. Speed difference: Non-full-size spare tires have speed restrictions (maximum speed not exceeding 80 km/h) and can only temporarily replace the original tire. Full-size spare tires have no such restrictions. Weight difference: Full-size spare tires, being identical in specifications to the original tires, are much heavier than non-full-size spare tires. In daily use, the following points should be noted for tires: Regularly check the tire surface for cracks, deformations, or other defects. Due to wear from driving, the tread grooves gradually become shallower. If the tread is worn flat, it loses its drainage and anti-slip functions, significantly reducing the car's performance. Small cracks can be potential hazards for tire blowouts at high speeds. Additionally, promptly remove pebbles stuck in the grooves. Park on level ground whenever possible. Avoid parking on roads with thick, sharp, or pointed stones. Do not park near or in contact with petroleum products, acids, or other materials that may deteriorate rubber. After parking, avoid turning the steering wheel, as this accelerates tire wear. Do not splash water to cool down. In hot weather or during high-speed driving, tires can overheat, increasing air pressure. In such cases, stop to let the tires cool naturally. Never release air to reduce pressure or splash water to cool down, as this can cause abnormal aging of the tread rubber. Avoid sudden braking. Minimize frequent and hard braking to prevent accelerated tread wear from dragging on the ground.
9
1
Share

Where is the Lynk & Co 05 produced?

Lynk & Co 05 is produced at the Yuyao factory in China. Below is some information about the Lynk & Co 05: 1. Exterior: The Lynk & Co 05 is a compact crossover SUV under the Lynk & Co brand. It has a wheelbase of 2734mm, a length of 4592mm, a width of 1879mm, and a height of 1628mm. 2. Powertrain: The Lynk & Co 05 is equipped with a 2.0-liter turbocharged engine across all variants. This engine delivers 254 horsepower and a maximum torque of 350 Nm, with a maximum power output at 5500 rpm and maximum torque available between 1800 to 4800 rpm. The engine features direct fuel injection technology and uses an aluminum alloy cylinder head and block. Additional information: The Lynk & Co 05's engine is paired with an 8-speed automatic transmission (8AT). The advantages of this transmission include: 1. Enhanced comfort. The 8AT improves ride comfort and fuel efficiency. 2. Smooth operation. The 8AT offers excellent shift smoothness and is known for its high reliability and durability.
2
4
Share

What car has a cross with a snake?

The cross with a snake is the emblem of Alfa Romeo. Here is an introduction to Alfa Romeo: 1. Alfa Romeo is a famous Italian manufacturer of cars and sports cars, founded in 1910 and headquartered in Milan. It was acquired by the Fiat Group in 1986 and officially entered the Chinese market in April 2017. 2. When Alfa Romeo was founded, the creators combined two symbols of Milan to create a badge: the red cross is part of the city's coat of arms, commemorating the medieval Crusader knights, while the dragon-snake eating a man comes from the emblem of a local noble family (the Visconti family). 3. The Alfa Romeo badge also symbolizes the legend of the medieval Duke of Milan, Visconti, whose ancestor repelled a giant serpent that was causing suffering to the city's people. The combination of these two unrelated symbols representing Milan's traditions has become one of the most famous logos in the automotive world. The later additions of the Alfa Romeo and Milan lettering, as well as the decorative borders, have undergone subtle changes over the brand's century-long history.
7
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.