What are the precautions for installing car license plates?
3 Answers
Here are the precautions for installing car license plates: 1. No advertising: If there is sales advertising on the license plate, according to the new regulations, such a license plate frame cannot be used. If you insist on driving with it, the traffic police will impose penalty points. 2. Hanging position: The position where the license plate is hung should not affect the safe driving of the vehicle or the identification of the license plate. Hanging it at an angle may prevent the checkpoint camera from capturing the license plate completely. 3. Installation holes matter: The installation holes for the vehicle license plate must have special seals that represent the local abbreviation. If the owner only installs two sealing devices, it does not comply with the national regulations. The correct approach is to install sealing devices on all four installation holes of both the front and rear license plates.
As a semi-elderly man who has driven all kinds of cars, I believe the primary consideration when installing license plates is compliance with traffic regulations. The license plate must be installed in the designated position on the vehicle, such as the front plate fixed in the exact center of the bumper and the rear plate placed below the tailgate, without any obstruction. Otherwise, you might attract unwanted attention from the police. The size must comply with national standards—standard plates are blue with white characters, measuring approximately 440mm in length and 140mm in height. Don’t try to replace them with smaller or colored plates, as they won’t pass the annual inspection. For fixing, I recommend using anti-rust and anti-theft screws, preferably purchased from a reputable auto parts store. Tighten them securely with a Phillips screwdriver or wrench to prevent loosening and falling off on bumpy roads. After installation, regularly check for rust or misalignment. When washing the car, clean the plates gently to avoid excessive force that might cause peeling or damage. In short, compliance and safety come first—it saves you both hassle and trouble.
Hey, I'm a DIY car enthusiast, and installing license plates by myself is fun but requires attention to detail. Preparation is key: purchase specialized license plate screws and mounting brackets, preferably anti-theft types, along with a Phillips screwdriver or small wrench. Positioning is crucial—the front plate should be centered on the bumper, and the rear plate should be at the bottom of the tailgate, ensuring no characters are obscured. Before installation, clean the surface thoroughly, as grease can affect adhesion. Gently place the license plate in position and tighten the screws slowly without over-torquing to avoid stripping or damaging the plate. I also recommend treating the screws with anti-rust spray to extend their lifespan. After installation, give the plate a few shakes to check for stability and listen for any unusual noises while driving. In case of heavy rain, inspect for water accumulation that could cause corrosion. Sharing these tips with you—DIY saves money and ensures safety.
