···
Log in / Register

What are the precautions for driving in water?

4 Answers
Melanie
07/29/25 7:39am

Precautions for driving in water are as follows: 1. Slow down or stop to observe: When driving and encountering waterlogged roads, as long as the water level reaches two-thirds of the bumper or tires, there is a certain danger in continuing to drive through water. High speed will increase the actual water depth the car passes through, causing rainwater to enter the cabin from the engine compartment or chassis. Avoid driving against waves from large vehicles. If observation shows high water levels, try to detour and do not force your way through. 2. Do not stop: When driving through water, in addition to maintaining a low speed, try not to stop, shift gears, release the throttle, or accelerate. You should pass through at a steady speed with low gear and medium-high throttle, rather than speeding through and splashing large waves or water.

Was this review help?
16
5
Share
CatherineRose
08/13/25 1:43am

Remember last time I drove through heavy rain, the water depth shouldn't be too deep—don't exceed half the wheel height or the exhaust pipe, otherwise the engine could get flooded and you're done for. Drive as slow as a crawling turtle, keep it steady and don't stomp on the gas to avoid creating waves that splash into the car. Also, turn off the AC and fans beforehand to prevent sucking in moisture. If the car stalls, absolutely do not restart the engine, or you'll face expensive repairs. After crossing, find a safe spot to stop and pump the brakes to make sure they're not slippery. Driving through water requires extra caution—I once almost drowned my car and had to check the undercarriage and electrical systems afterward to prevent rust damage. A few more practices and you'll learn that safety comes first above all else.

Was this review help?
15
0
Share
Expand All
McGideon
10/04/25 8:17am

Driving through water is risky, so I always believe in proceeding with caution. Before starting, check the water depth clearly and use a stick to test the path—only proceed if it's below 30 cm. Move slowly during the process, maintaining a low gear to keep the engine steady, which helps prevent water from entering the intake. Avoid sharp turns to prevent losing control. Also, close windows in advance and keep hazard lights on for emergencies. If the car gets submerged, don’t panic—unlock the doors and open windows immediately for an easy escape. After passing through, be sure to dry the brakes and check for debris stuck in the tires. These details prevent accidents. I once heard from a friend that neglecting this even once could mean replacing the engine—is spending thousands extra worth it? Regular car maintenance is key.

Was this review help?
12
2
Share
Expand All
Clyde
11/18/25 3:05am

Drive carefully when entering water, don't let the depth exceed the limit, as submerged wheels can cause trouble. Move slowly at low speed, avoid accelerating too hard to prevent large splashes that may enter the engine. If the engine stalls, stop immediately and don't restart it to avoid more serious damage. Afterward, check if the brakes are wet and dry them properly. Simply put, prevention saves a lot of hassle.

Was this review help?
17
2
Share
Expand All
More Forum Discussions

What gear should be used in Subject 3 driving test?

Subject 3 involves the use of gears from 1st to 5th. Below are relevant details about the Subject 3 examination: Examination requirements: The specific components of Subject 3 test are road driving skills and safety & civilized driving knowledge, each with a full score of 100 points. A minimum score of 90 points in each section is required to pass. Training hour requirements: Subject 3 consists of 40 training hours in total, including 16 hours of theory, 4 hours of simulated driving, and 20 hours of practical operation. According to the teaching syllabus, driving training follows a clock-in timing system with cumulative hours. Each student can register a maximum of 4 training hours per day.
3
4
Share

Are Audi and Volkswagen engines the same?

Audi engines and Volkswagen engines are the same, but there are differences in some functions and details. The specific differences are as follows: Different systems installed: Audi engines are equipped with the AVS system, while Volkswagen engines are not. The AVS system is Audi's variable valve lift technology. Engines equipped with this system can change the valve lift according to different working conditions. Differences in engine cooling, noise reduction, and heat insulation: Audi is Volkswagen's high-end model, and many optimizations have been made in engine cooling, noise reduction, and heat insulation, which Volkswagen does not have. Different combustion methods: The stratified combustion of Audi engines is a type of lean combustion. This combustion method makes power delivery smoother and fuel consumption performance more perfect, while Volkswagen does not use this technology.
14
3
Share

What is the recommended cold tire pressure in summer?

Summer cold tire pressure is normal between 2.2 2.5, with relevant information as follows: 1. Cold tire pressure: The generally recommended cold tire pressure is 2.5, which results in lower fuel consumption and keeps the tire pressure within the safe range of 3.0 during high-speed driving. 2. Tire pressure: Actually, the tire pressure requirements vary for different vehicle models, with different maximum and minimum limits for tire pressure. Even the same tire installed on different vehicle models has different pressure requirements, so the optimal tire pressure is not a fixed value but depends on the specific vehicle model. The standard tire pressure value for each vehicle model is indicated in the user manual, on the inside of the fuel tank cap, or below the B-pillar on the passenger side. Although manufacturers provide the optimal tire pressure value, it should be adjusted according to temperature changes. In summer, when temperatures are higher, it is recommended to reduce the tire pressure by 0.1 0.2, while in winter, when temperatures are lower, it is recommended to increase the tire pressure by 0.1~0.2.
19
5
Share

What is the logo of Changan Automobile?

Changan Automobile's logo is a V-shaped emblem. Below is a relevant introduction to Changan Automobile: Powertrain: Equipped with the Blue Whale NE1.5T engine, the only in its class with dual-exhaust port cylinder head integrated exhaust manifold and dual-scroll electronically controlled turbocharger, delivering a maximum power of 132kW and a maximum torque of 300N·m, boasting 180 horsepower. Paired with a wet 7DCT automatic transmission, the gearbox achieves a response time of 251ms and a comprehensive transmission efficiency of up to 94.5%. Configuration: Features a high-strength steel ring body design, with high-strength steel accounting for 78% of the structure. Includes DMS (Driver Monitoring System), LDW, ACC, AEB, ESP, ABS, EBD, BAS, TCS, ultra-high-definition surround-view driving recorder, cloud-eye rearview mirror, 360° panoramic imaging, and bodyguard mode.
6
4
Share

Can You Continue Driving When the Warning Light Comes On?

When the car's warning light comes on, you need to stop immediately for inspection and determine whether you can continue driving based on the inspection results. There are generally two situations when the warning light comes on: A yellow symbol light indicates an engine malfunction. A red symbol light indicates a serious engine malfunction that requires immediate maintenance. For the above two situations, the specific solutions are as follows: Check the oil pressure warning light and the water temperature gauge. If there are no issues with the oil pressure gauge and the water temperature gauge, the car can continue to drive, but you should control the speed and immediately head to the nearest repair shop for maintenance. If the oil pressure gauge and the water temperature warning light come on, it indicates that the car has a clear malfunction. You should pull over immediately and call for assistance.
2
5
Share

What to Do If the Car Sunroof Was Left Open and Rainwater Got Inside?

Here are the solutions for when the car sunroof was left open and rainwater got inside: Clean Interior Items: Items inside the car can easily mold when damp. Remove washable items such as floor mats and seat covers for cleaning and thorough drying. Carpets can be vacuumed directly; if necessary, use specialized cleaning agents, but ensure they are completely dry afterward. Disinfect and Sanitize: For seat covers and seats, it's best to rinse them with bleach to prevent bacterial growth. The evaporator and blower of the air conditioning system should also be removed and disinfected. An air purifier can be used to eliminate odors inside the car.
9
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.