What are the precautions for car maintenance in autumn?

1 Answers
MacLillian
07/29/25 3:53pm
There are several aspects to pay attention to for car maintenance in autumn: 1. Engine compartment maintenance: Check the engine oil, brake fluid, and coolant in the engine compartment to ensure they are sufficient, not deteriorated, and within the replacement cycle. These fluids are like the lifeblood of your car, and they must be replaced when due to ensure smooth circulation. 2. Brake system maintenance: Brake system care should not be neglected at any time, not just in autumn. Regularly check if the braking performance weakens or pulls to one side, and whether the brake pedal's resistance changes. If necessary, clean the entire brake system's piping. 3. Heater lines and fan maintenance: As the weather cools in autumn, frost may appear at lower temperatures. Pay special attention to whether the defrost vents under the windshield are functioning properly and providing sufficient heat. Address any issues promptly. 4. Air conditioning maintenance: Inspect the air conditioning system to ensure the pipes are intact and check if the cabin air filter needs replacement. 5. Battery maintenance: The battery terminals are the most problematic areas in autumn. If green oxide deposits are found during inspection, rinse them off with boiling water immediately. These deposits can lead to insufficient generator output, causing the battery to discharge and, in severe cases, result in battery failure or difficulty starting the car. 6. Interior maintenance: Due to high temperatures and frequent rain in summer, carpets, floor mats, and other hidden areas inside the car can harbor bacteria. It is essential to perform a thorough interior disinfection and cleaning.
Was this review help?
18
5
Share
More Forum Discussions

How to Spray Water on the Windshield?

Method for spraying water on the windshield: The windshield washer is located below the right side of the steering wheel, and the wiper switch controls the front and rear windshield wipers and washers. The correct way to use the car windshield washer is as follows: 1. Check the spray position of the nozzle: If the spray position is incorrect, adjust it promptly. The normal spray position should be slightly above the middle of the windshield, allowing the washer fluid to flow down and be evenly spread by the wiper blades to clean and remove dirt. 2. Check if the nozzle is clogged: If the nozzle fails to spray or the spray pattern is abnormal, check for blockages. The nozzle holes are very small and can be clogged by dirt, mud from washing the car, or wax residue. 3. Ensure timely operation of the wipers: The wipers should activate promptly after the washer fluid is sprayed on the windshield. If not, check and adjust the synchronization between the washer and the wipers.
14
4
Share

What Causes a Motorcycle to Stall Automatically?

Reasons for a motorcycle stalling automatically: 1. Fuel supply failure. The solution is to check if there is fuel in the carburetor. If there is no fuel, it indicates a blockage in the fuel line from the fuel tank to the carburetor, which should be cleaned and unclogged. 2. Engine overheating. The solution is to check if there is lubricating oil in the crankcase. If the lubricating oil is insufficient or absent, inspect the oil pan or drain plug for leaks. After identifying and fixing the issue, refill with the specified amount of lubricating oil. 3. Electrical circuit failure. Sudden stalling caused by an electrical circuit interruption will not show any abnormal signs in the engine beforehand. Causes of sudden electrical interruption include loose or disconnected connectors, broken wires, or short circuits. The solution is to check all connectors, clean off any oil stains, increase the clamping force of the connector tabs, and enhance contact strength to ensure stable connectivity.
20
5
Share

What to Do When the Car Windshield Freezes in Winter Morning?

To deal with a frozen car windshield in winter, you can use physical de-icing methods, chemical de-icing methods, or covering anti-icing methods. The specific operation methods are as follows: 1. Physical de-icing method. Prepare a hard plastic scraper or a dedicated glass frost scraper to remove ice and snow. You can use the hard plastic piece to gently scrape off the frost on the windshield, being careful to avoid scratching the glass surface. 2. Chemical de-icing method. Prepare a spray de-icer, which is a high-speed anti-ice spray concentrate specially designed to thaw frozen car windows and wipers. It does not damage the car's surface and can prevent re-freezing. When sprayed evenly at temperatures below -30℃, it can easily remove ice and snow. Additionally, it prevents the windshield and water accumulation areas from freezing again, leaving the glass clean and undamaged. 3. Covering anti-icing method. It is recommended that car owners purchase a dedicated windshield frost cover to completely cover the car windshield.
7
2
Share

Where is the automatic mirror button located?

Automatic mirror switches are generally located on the main driver's door or on the left side of the instrument panel. Detailed information about rearview mirrors is as follows: 1. As the widest component installed on a vehicle, rearview mirrors are most susceptible to impact in case of side collisions. To minimize scratches, folding functionality is required for rearview mirrors. 2. Foldable rearview mirrors can be retracted when passing through narrow sections, improving vehicle passability. When the driver leaves the car, the mirrors can be folded to protect the mirror surface, reduce parking space requirements, and prevent scratches. 3. Nowadays, mid-range and high-end vehicles are basically equipped with foldable rearview mirrors. There are two types of folding mechanisms: manual and electric. For manual folding, the driver must reach outside the window or exit the vehicle to fold the mirrors. The advantage of electric folding is that the driver can operate it from inside the vehicle, and the mirrors will automatically unfold when starting the car.
5
4
Share

How to Adjust the Front and Rear Positions of Power Seats?

Adjust by pushing the control switch forward or backward. More information about seat position adjustment is as follows: 1. Seat adjustment is divided into manual adjustment and power adjustment. Manual adjustment works by the driver acting as the force-applying party, releasing the seat's locking mechanism via a handle, then changing body posture and position to drive seat movement, finally fixing the seat at the selected locking point position. Power adjustment is achieved through an electric motor, with the seat being the force-applying party. Passengers only need to toggle the control button to move the seat without actively changing body posture. 2. Power seat adjustment can be understood as completing adjustment actions via motors controlled by buttons. Seat direction adjustment is accomplished through three mechanisms: seat recliner, seat slide rail, and seat lifter. Each mechanism can provide adjustment in two or more directions respectively. The more adjustment directions a seat has, the easier it is for the driver to find a suitable driving posture and reduce driving fatigue.
13
1
Share

How to Turn on the 360-Degree Panoramic View in Toyota RAV4?

Toyota RAV4's 360-degree panoramic view can be activated by pressing the View button located near the steering wheel knee position on the automatic display panel, followed by pressing the auto button on the central control screen. The Toyota RAV4 is equipped with a 2.0-liter naturally aspirated engine, featuring a MacPherson strut front suspension and an E-type multi-link rear suspension. The vehicle's dimensions are 4630mm in length, 1855mm in width, and 1685mm in height, with a wheelbase of 2660mm. It has a ground clearance of 190mm, a trunk capacity of 970 liters, and a fuel tank capacity of 57 liters. The RAV4 can reach a top speed of 185 km/h, has a curb weight of 1420 kg, a maximum torque of 209 Nm, and achieves this torque between 4400 to 5000 rpm.
1
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.