What are the new regulations for the 6-year annual inspection of private cars?

1 Answers
VanRhett
07/30/25 3:16am
Introduction to the new regulations for the 6-year annual inspection of private cars is as follows: 1. Valid documents: Drive the vehicle to the inspection station with ID card, vehicle license, vessel tax or tax exemption certificate, and compulsory traffic insurance policy for vehicle inspection. 2. Function check: After applying for the annual inspection, drive the vehicle into the automatic identification area to successively inspect whether the exhaust, speed, lighting, and chassis meet the requirements. 3. Verify the vehicle license plate: Ensure the type, body color, engine number, VIN code, and frame number are accurate. 4. Inspect the vehicle appearance: Check details such as the bumper, engine hood, rearview mirror, lower mirror, car windows, paint, engine operation status, interior, and wheels.
Was this review help?
19
1
Share
More Forum Discussions

How to resolve the illuminated ABS light on a Skoda?

Check the ABS fuse, system wiring, all connectors, and relays for any damage. Use specialized computer diagnostic equipment to retrieve fault codes. Soft fault codes can be cleared using the device and will no longer display. Remove the wheel speed sensors from all four wheels and inspect the sensor heads for any dirt accumulation. If present, clean the sensor heads thoroughly before reinstalling. The sensors may have detectable open circuits or short circuits to positive/ground. Inspect the wiring connections between the wheel speed sensors and the ABS control unit.
2
4
Share

How to Remove Asphalt from Car Body?

To remove asphalt from the car body: 1. Prepare asphalt cleaner and a clean towel; 2. Spray the cleaner 3 to 5 times on the asphalt spots; 3. Wait for fifteen minutes until the asphalt begins to dissolve; 4. Wet the towel with water, wring it out, and wipe off the treated asphalt. Methods for maintaining car paint: 1. Wash the car after the engine has cooled down; 2. Minimize exposure to direct sunlight; 3. Clean any stains on the car body promptly; 4. Rinse with clean water after rain to prevent acid rain corrosion; 5. Apply wax or glaze coating.
13
0
Share

What to do if the chassis of Lynk & Co 03 has been scraped several times?

Try not to drive the car onto the curb, and develop good car usage habits to save money and avoid trouble. Reducing the impact of speed bumps on tires and the vibration amplitude of the vehicle's suspension can make it less likely to hit the chassis. In such cases, slow down and drive carefully. You can adopt the method of driving the vehicle diagonally, that is, letting one front wheel reach the top (or bottom) of the slope first to avoid scraping the undercarriage.
9
2
Share

What is the solution for the oil light on in the Passat Lingyu?

Press the "set" button on the odometer side. Then hold the button while turning on the ignition switch, and the display area will enter the reset mode. It is best to release the button. Turn off the engine and remove the key, hold down the lower right button on the dashboard, insert the key to maintain the power-on state, release after power-on, and press the lower left button on the dashboard. Press and hold the reset button, then hold the reset button again with one hand and turn the ignition switch back on. At this point, the maintenance reminder on the dashboard will flash, and you should continue holding the reset button.
8
5
Share

Is It a Big Problem to Put 200 kg in the Trunk?

Putting 200 kg in the trunk should not have a significant impact. It is recommended to load according to the vehicle's condition, generally allowing for about 200kg to 300kg. Here are some precautions for trunk usage: 1. Avoid placing valuables and luggage in the car: First, valuables should not be stored in the trunk, including luggage. 2. Never place flammable or explosive items in the car: Flammable and explosive items must not be stored in the trunk. Due to high temperatures in summer and road bumps, these items can easily explode, leading to danger.
1
5
Share

Reasons for the F1 light on Suzuki's malfunction indicator display?

FI is the fuel injection indicator light for motorcycles. If it stays lit or flashes continuously, it indicates a fault in the fuel injection system components, sensors, or their wiring. However, sometimes it might just be a false alarm. You can consult Suzuki's after-sales service or ride to the service center for a check. But if the light only comes on during the initial key-on self-test, it's normal. FI stands for Fuel Injection, which is essentially electronic fuel injection. There might be an issue with the fuel injection system. Generally, FI-equipped vehicles can diagnose problems based on the pattern of the FI light illumination.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.