What are the new regulations for new vehicle annual inspections?

1 Answers
SaraDella
07/29/25 7:46pm
New regulations for new vehicle annual inspections, effective from November 20, 2020, change the inspection frequency for non-commercial vehicles aged 6 to 10 years from annual to biennial inspections. Below are detailed explanations of the new regulations: 1. Within 6 years: If your vehicle is still within 6 years, it can be exempt from inspection twice (inspection labels must be applied for every two years, but no on-site vehicle inspection is required). 2. 6 to 10 years: If your vehicle falls within this range, an on-site inspection is required. In the 8th year, an on-site inspection is mandatory, while in the 9th year, you should inquire whether an on-site inspection can be waived. 3. Over 10 years: The original inspection cycle still applies, meaning vehicles aged 10-15 years must be inspected annually, and those over 15 years must be inspected every six months.
Was this review help?
9
4
Share
More Forum Discussions

Is It Normal for a 125cc Motorcycle to Run at 80 km/h?

It is relatively normal for a 125cc motorcycle to run at 80 km/h on open roads, but in urban areas, maintaining a speed of 60 km/h is safer. Here are the relevant details: 1. Detail One: Typically, the maximum designed speed for a 125cc motorcycle is around 95 km/h. 2. Detail Two: If the motorcycle in use has not had its fuel system inspected and cleaned for a long time, its speed performance may be affected to some extent. Therefore, both the carburetor and electronic fuel injection system require regular maintenance, and the condition of the air filter should also be checked periodically.
1
1
Share

What is the MIIT fuel consumption of the Haval F7?

Haval F7 is mainly divided into four models, the details are as follows: 1. The 1.5T engine with a 7-speed dual-clutch transmission has a fuel consumption range of 8-11. 2. The 1.5T engine with a 7-speed wet dual-clutch transmission has a fuel consumption range of 8-10.5. 3. The 2.0T engine with a 7-speed dual-clutch transmission has a fuel consumption range of 9-12. 4. The 2.0T engine with a 7-speed wet dual-clutch transmission has a fuel consumption range of 9-12.5. Additional details about the Haval F7 powertrain: 1. Equipped with 1.5GDIT and 7DCT: 1.5GDIT: "China's Top 10 Engines", supported by 8 advanced technologies; 2.0GDIT: 6 advanced technologies. 7DCT: The first domestically developed transmission, with 85 patents/independent intellectual property rights, "World's Top 10 Transmissions". 2. Golden powertrain combination, new chassis tuning + all-terrain technology: BorgWarner all-wheel drive system, four-wheel drive control, front-wheel drive cruising, rear-wheel drive acceleration, single-wheel drive escape. 3. Six all-terrain driving modes: Standard, Sport, Economy, Mud, Sand, and Snow modes.
12
0
Share

What Causes a Manual Transmission Car to Fail to Shift Gears After Starting?

Common reasons why a manual transmission car fails to shift gears after starting are analyzed as follows: 1. Clutch disc not disengaging properly: If there is an issue with the clutch disc disengagement, it is necessary to visit a repair facility to inspect and adjust the clutch or replace it. 2. Damaged clutch disc and pressure plate: This causes the clutch to malfunction, preventing the disconnection and engagement of engine power. The issue can be resolved by inspecting and replacing the clutch disc and plate. 3. Worn shift mechanism: Internal gear wear in the shift lever causes it to get stuck, making gear shifting impossible. It is essential to promptly visit a repair facility to diagnose the fault and replace the necessary parts.
6
4
Share

How Much Fuel Should Remain in the Tank When Replacing the Fuel Pump?

4S shops recommend keeping about 1/3 of fuel remaining. Below is a partial introduction about the fuel pump: 1. Function: The main function of the fuel pump is to supply fuel to the engine. The fuel pump delivers high-pressure fuel to the injection pipe, ensuring a continuous supply of fuel to the injectors. 2. Composition: The fuel pump consists of an electric motor, a pressure limiter, and a check valve. The electric motor actually operates within the fuel inside the pump housing. There's no need to worry, as there are no ignition sources inside the housing. The fuel lubricates and cools the fuel motor. A check valve is installed at the fuel outlet, and the pressure limiter is located on the pressure side of the pump housing, featuring a passage leading to the fuel inlet.
14
2
Share

What is the method for changing transmission fluid using a circulation machine?

The method for changing transmission fluid using a circulation machine is: 1. Remove the protective plate and loosen the drain plug; 2. Drain the used fluid through the drain plug hole and by removing the oil pan; 3. Expose the automatic transmission and remove the oil pan; 4. Clean the oil pan with a cleaning agent; 5. Reinstall the oil pan and add transmission fluid; 6. Unscrew the drain and fill plug holes of the automatic transmission, and insert both the fill and drain hoses of the circulation machine into the transmission; 7. Start the circulation machine; 8. Start the vehicle and shift through all gears; 9. When the color in the oil sight glass turns clear red, the circulation machine fluid change is complete.
5
1
Share

What should not be used to extinguish a motor vehicle fuel fire?

Here are three methods that should not be used to extinguish a motor vehicle fuel fire: 1. Water is ineffective for extinguishing: When a motor vehicle fuel fire occurs, water should not be used for extinguishing because fuel is lighter than water. When water comes into contact with fuel, it not only fails to cover the fuel but also carries the fuel, causing it to spread and intensify the fire. 2. Carbon dioxide fire extinguishers are not suitable for extinguishing: Because it is not a confined space. 3. 1211 fire extinguishers should not be used for extinguishing: Because such fire extinguishers have a destructive effect on the atmosphere. Additional information: When a motor vehicle fuel fire occurs, roadside sand, cotton clothing, or work clothes can be used to extinguish the fire, and dry powder fire extinguishers can also be used.
1
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.