What are the new regulations for license plate frame installation?

[McIsabelle]

License plate frame installation new regulations are as follows: Motor vehicles can use license plate frames to assist in installing license plates, but the inner edge of the license plate frame should be no less than 5mm from the edge of the motor vehicle registration number characters. Except for external lock-type, internal lock-type, electronic automatic shielding, and replaceable movable license plate frames that facilitate replacement and disassembly, license plate frames should be fixed-type frames that protect the license plate and do not affect the recognition of license plate characters. The use of detachable movable license plate frames and flip-up license plate frames is not allowed. The outer frame of a motor vehicle license plate must not contain letters, logos, or decorative patterns, and must not obscure the license plate characters. What are the new traffic regulations for license plate restrictions: The front license plate should be installed in the middle or slightly to the right of the front section of the motor vehicle, and the rear license plate should be installed in the middle or slightly to the left of the rear section of the motor vehicle, without affecting the safe driving of the motor vehicle and the recognition of the license plate. License plates must be installed to ensure no deformation or obstruction, horizontally level, vertically perpendicular to the ground without inversion, and with a vertical angle not exceeding 15 degrees. Except for temporary entry vehicle license plates and temporary driving license plates, other motor vehicle license plates must be fixed with at least two uniform, embossed license plate sealing devices bearing the issuing authority code. When using a license plate frame for auxiliary installation, the inner edge of the license plate frame must be more than 5mm from the edge of the motor vehicle registration number characters.