···
Log in / Register

What are the must-know tips for passing the curve section in Subject 2?

3 Answers
LeMadeline
09/09/25 2:12am
Subject 2 curve passing tips are as follows: Reversing into the garage: Pay attention to the speed. Excessive speed will affect the control of the steering wheel, leading to crossing the line. So don't be nervous, just press the clutch to keep the speed steady, which will greatly improve the pass rate. Slope positioning and starting: When starting on a slope, be sure to watch the dashboard. Wait for 3 seconds after the dashboard shakes, then slowly release the brake a little. If you feel the car moving forward, you can completely release the brake at this time. Parallel parking: Park the car 30cm-50cm away from the yellow line, remember to turn on the turn signal and watch the rearview mirror. You can see the wheels rubbing against the ground and slow down the speed.
Was this review help?
16
1
Share
DamianLynn
09/20/25 7:12am
The key to navigating curves lies in anticipation and rhythm control. I always emphasize the importance of slowing down before entering a curve. In the Subject 2 test venue, reducing speed to around 20 km/h is ideal, using first or second gear to maintain stability. Keep your gaze fixed on the exit point of the curve to guide smooth steering wheel movements, avoiding sharp turns that could cause crossing the line. During the test, the examiner will observe your steering operation and speed consistency—it's not about going faster but ensuring smooth actions. More practice enhances familiarity with the test route and reduces nervousness. These skills also prevent loss of control in real-world driving, such as maintaining a safe distance on urban curves. Stay calm, and simulating test scenarios during practice will boost confidence, ensuring a one-time pass.
Was this review help?
16
0
Share
Expand All
SanJack
11/03/25 7:33am
I just passed Subject 2 not long ago, and the curve section relied on a combination of mindset and daily practice. Before entering the curve, lightly press the brake to slow down to under 30km/h, keep your eyes fixed on the distant target point without looking around, and turn the steering wheel slowly without sudden movements. The key during the test is not to cross the boundary lines, and I recommend maintaining a steady speed when entering and exiting the curve. During practice, I repeatedly drove on simulated sections to develop that sense of control. Now, I use similar methods when turning on the road, which effectively prevents tail swings. Subject 2’s curve test is really about your basic driving skills—don’t stress too much. Treat every practice session as a real scenario, and you’ll pass gradually.
Was this review help?
16
4
Share
Expand All
More Forum Discussions

How to Convert Power to Horsepower?

1 horsepower = 735 watts = 0.735 kilowatts. Here is some related knowledge about power: Units of power: Horsepower is a commonly used unit for measuring power in engineering. It generally refers to metric horsepower rather than imperial horsepower. It is conventionally defined as 1 metric horsepower being equal to the work required to lift a 75-kilogram object one meter in one second. The international unit of power is the watt, with other units including kilowatts, megawatts, and milliwatts. Engine power loss: The engine's power is not equal to the car's power, as there are losses during mechanical transmission. Additionally, safety considerations leading to thicker and heavier car body designs can also result in engine power loss.
4
5
Share

Which Audi models have frameless doors?

Audi models with frameless doors include: Audi A5, Audi A7, Audi A3 Cabriolet, Audi TT, and Audi R8. More relevant information is as follows: 1. Audi is a luxury automobile brand under Audi AG, a subsidiary of the Volkswagen Group. As a representative of high technical standards, quality benchmarks, innovative capabilities, and classic vehicle designs, Audi is one of the premier automotive brands. 2. Audi's main models include: A1, A3, A4, A5, A6, A7, A8, Q1, Q2, Q3, Q5, Q7, Q8, TT, R8, as well as the S and RS performance series.
15
2
Share

How to Position the Vehicle 30 cm from the Curb During Hill Start?

Here are the methods to position the vehicle 30 cm from the curb during hill start: 1. Observe the position of the engine hood. After hearing the voice prompt, drive forward and stay to the right. When the right front corner of the engine hood (about 1/3 of its length) aligns with the roadside line, the vehicle is exactly 30 cm away from the curb. 2. Look at the raised part of the windshield wiper. From the driver's seat, when the raised part of the wiper aligns with the right roadside line, the distance is approximately 30 cm. 3. Check the right front door handle. Observe the right front door handle in the right side mirror. If the handle is tangent to the right roadside line, the distance is correct. If it's too far, make slight adjustments to the steering. If it's too close, there's a risk of crossing the line.
17
0
Share

What are the differences between the 2017 and 2016 Nissan Qashqai models?

The differences between the 2017 and 2016 Nissan Qashqai models lie in their exterior and interior designs. Below is an introduction to the distinctions between these two Qashqai models: Exterior Differences: The 2017 Qashqai features a fashionable design with a comfortable texture, incorporating the V-motion family language, which gives it a more refined and trendy appearance. The 2016 Qashqai offers a stronger sense of ride comfort, with just the right balance of support and softness, providing a more comfortable driving experience. Interior Differences: The 2016 Qashqai has slightly weaker power and an outdated interior, making its design appear overly conservative. The 2017 model, while maintaining a trendy steering wheel design, still retains a central console style from several years ago.
5
3
Share

Will the insurance company compensate for a smashed car window?

Here are the specific details regarding insurance compensation for smashed car windows: Procedure for the vehicle owner when the car is smashed: If a parked car is vandalized, it is generally necessary to report the incident to the traffic police or local police station to obtain relevant documentation. Insurance company's compensation method: If the insurance company requires an on-site inspection, you must cooperate with them. In this case, the damage involves the car lights and windows, which are not covered under the standalone glass breakage insurance. These losses are compensated under the comprehensive vehicle damage insurance. Additionally, if the third party cannot be identified, compensation is typically 70% or 50%. You will also need to sign a subrogation agreement, allowing the insurance company to pursue the third party for liability. Compensation scope: Generally, in insurance claims, glass breakage usually occurs alongside damage to other parts of the vehicle. This means that for the glass breakage to be covered under the comprehensive vehicle damage insurance, there must also be damage to other parts of the car body besides the glass.
6
4
Share

How to Replace the Wiper Blade Rubber on Lavida?

Introduction to replacing the wiper blade rubber on Lavida: 1. Turn the Lavida key to the power-on position, quickly move the wiper lever once to make the wiper stay in an upright position for easy replacement of the rubber. 2. Find a small square button on the wiper arm. 3. Press the wiper button, remove the protective cover, and then pull out the wiper blade. 4. Slide the wiper blade out along the steel track. 5. Replace it with a new rubber. Traditional wipers need to be replaced once a year, while the lifespan of beam wipers is two to three times that of traditional wipers, requiring replacement only every two or three years. Since the wiper rubber fits tightly to the glass, beam wipers rarely encounter the issue of sand particles getting stuck between the blades, which is common with traditional wipers. This not only protects the windshield but also provides good protection for the wipers themselves. When replacing the wiper, the rubber should also be replaced together.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.