What are the methods to reset the maintenance light on CS75?

[DelRose]

Here are the methods to reset the maintenance light for Changan CS75: 1. First, turn the car key to the full vehicle power-on state, then press the selection button marked in red on the left side of the steering wheel as shown in the figure. 3. Then press and hold the reset button for about 5 seconds. 4. Turn off the vehicle power, keep the reset button pressed, and then turn on the full vehicle power again. 5. Finally, you can see that the maintenance reminder has been cleared.

[Joanne]

I found resetting the maintenance indicator light on the Changan CS75 is actually quite simple. You sit in the driver's seat, turn the key to the ON position without starting the engine, then the dashboard lights will illuminate. Find a small button or knob labeled TRIP or RESET, press and hold it continuously for a few seconds until you see the maintenance light start flashing or turn off, then you can release. If it doesn't succeed the first time, it might be because the button wasn't held long enough - trying two or three more times usually does the trick. Remember to do this promptly after maintenance, otherwise the light will keep reminding you about service, which can be distracting while driving. Some people forget to reset it and end up having to pull over midway when the light comes on - developing this good habit makes journeys more worry-free.

[EvanFitz]

As a new car owner, I've learned that resetting the maintenance light is quite simple: First, ensure the car is parked in a safe location, turn the key to the ON position without starting the engine. The dashboard will display various information, locate the button similar to the odometer reset and hold it down. Typically, the light will reset after about ten seconds. If you're unsure which button to press, check the user manual for TRIP or similar indicators. If you still can't figure it out, simply visit the 4S store and ask a technician for help—it's safe, worry-free, and avoids mistakes. Don't underestimate this small task; it helps remind you to maintain your car on time, keeping it in good condition for driving.

[AshlynLynn]

With years of experience in car repair, I'm very familiar with resetting the CS75's maintenance light. Turn the ignition to the ON position without starting the engine, locate the reset button on the instrument panel, and press it for a few seconds until the light goes out—simple and efficient. If the light remains on, check if the procedure wasn't followed correctly or if there's a battery issue. Address it promptly to avoid costly repairs later.