What are the lighting operations for manual transmission Subject 3?

[ColinRose]

Here are the lighting test contents for Subject 3: Using low beam: Use low beam when meeting non-motor vehicles on narrow roads or bridges at night, when meeting motor vehicles at night, and when following vehicles closely in the same direction at night. Using high beam: Use high beam when driving at night on roads without streetlights or under poor lighting conditions. Using position lights + hazard lights: Use position lights + hazard lights when a vehicle breaks down or is involved in a traffic accident on the road at night, obstructing traffic and being difficult to move. Using fog lights + hazard lights + headlights on: Use fog lights + hazard lights + headlights when driving in foggy conditions. Using alternating high and low beams: Use alternating high and low beams when passing sharp curves, arched bridges, slopes, pedestrian crossings, or intersections without traffic signals at night.

[DiMolly]

As a novice who just passed the driving test, I personally experienced the lighting operations in the manual transmission Subject 3 exam, and it's no joke. The exam simulates multiple scenarios: you must turn on the low beams immediately after starting nighttime driving, signal for at least three seconds before changing lanes—failing to turn off or using the wrong signal results in point deductions. When encountering oncoming vehicles or cars ahead, flash the high beams briefly but don't keep them on; switch back to low beams promptly to avoid dazzling others. In rainy or foggy conditions, turn on the width markers and rear fog lights to improve visibility, and activate hazard warning lights for emergency stops. During practice, I once forgot to turn off the width markers, but repeated simulations helped me pass. Mastering lighting operations isn't just for the test—it's essential for safe driving habits, like checking bulb brightness before trips. Once you get the hang of it, driving becomes much safer.

[CarterAnn]

From a veteran driver's perspective, the manual transmission Subject 3 lighting operation is essentially about using the right lights in the right situations: low beams for illumination, turn signals for turning and lane changes, width markers and fog lights in rain or fog, and high beams only briefly on empty road sections. Simulating night driving is a key point in the test—switching lights must be quick and accurate, like switching back to low beams when meeting another car, and don't forget to turn off the turn signals. Proper light usage can prevent accidents: fog lights help see the road in rain, and hazard lights warn others in emergencies. Practice the light switch positions thoroughly to avoid nervousness during the test—stay steady and pass smoothly.

[SanTanner]

From a safety perspective, lighting operations are crucial in Subject 3 of the driving test, as they reflect driving responsibility. In manual transmission tests, various scenarios are simulated for light usage: low beams illuminate nighttime roads, turn signals indicate lane changes, width markers and fog lights enhance visibility in rain or fog, and hazard lights are activated in emergencies. Incorrect operations, such as misuse of high beams, can dazzle others and cause accidents. Proper use of lights protects lives, and daily driving requires consistent practice to develop good operational habits.