What are the length and width of the Baojun 310w body?

When is the right time to replace spark plugs?

Under normal maintenance conditions, replacement is recommended after driving 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine type, so it's advisable to follow the user manual. Refer to the following standards for maintenance replacement: Platinum spark plugs should be replaced at 40,000 km, ordinary nickel alloy spark plugs at 20,000 km, and iridium spark plugs at 60,000-80,000 km. Steps for replacing spark plugs: Open the hood, lift the engine's plastic cover, remove the high-voltage distributor wires, and mark each cylinder's position to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. While removing them, check for external debris like leaves or dust and ensure thorough cleaning. Insert the new spark plug into the spark plug hole, hand-tighten it a few turns, then use the socket to tighten further. Reinstall the removed high-voltage distributor wires according to the firing order, then snap the cover back into place.

7

3

Share

How many kilometers does a brand-new car generally have when delivered?

It is generally normal for a brand-new car to have less than 30 kilometers on the odometer when delivered. Here are the details: 1. Actual situation of new car mileage: When a new car arrives at the 4S store, the odometer usually does not show 0 kilometers, but it is normal for it not to exceed 30 kilometers. Domestic new cars mostly have around 10 kilometers on the odometer. 2. Maximum limit of new car mileage: Adding the factory inspection mileage and transportation mileage together, strictly speaking, the total mileage of a domestic new car should not exceed 50km. For imported cars, considering factors such as overseas transportation, port handling, and customs clearance, consumers can still accept a mileage below 100km.

5

0

Share

Will Removing the Rear Windshield Film Damage the Heating Wires?

Here are the specific details about how removing the rear windshield film affects the heating wires:1. Poor-quality film: The heating wires are on the surface of the glass and can be felt as raised lines with your fingers. If the film is of poor quality, removing it may pull off parts of the heating wires.2. High-quality film: If the film is applied properly, there is no need to replace it.3. Careful operation: Removing the film correctly will not damage the heating wires. Avoid pulling directly; instead, spray water to moisten it beforehand.4. Harmful substances: Low-quality sun films contain benzene, formaldehyde, and other chemical materials that can melt and corrode the heating wires under high-temperature sunlight exposure.

16

1

Share

What are the requirements for upgrading from A3 to A1 license?

According to the "Regulations on the Application and Use of Motor Vehicle Driving Licenses" and the "New Regulations on Streamlining Administration, Delegating Power, and Improving Services", applicants for upgrading to a large passenger vehicle driving license must meet one of the following conditions: Have held a city bus or medium-sized passenger vehicle driving license for at least two years; Have held a large truck driving license for at least three years; Have held a tractor driving license for at least one year. In addition to meeting one of the above conditions, applicants must not have accumulated 12 penalty points in any of the last three scoring cycles before applying. What are the situations where upgrading to A1 is not allowed? According to Article 16 of the "Regulations on the Application and Use of Motor Vehicle Driving Licenses", the following circumstances disqualify applicants from obtaining a large passenger vehicle, tractor, city bus, medium-sized passenger vehicle, or large truck driving license: Being responsible for a fatal traffic accident with equal or greater liability; Driving under the influence of alcohol; Having a driving license revoked or canceled within the past ten years. Requirements for upgrading to A1 license: Height: At least 155 cm; Vision: Naked or corrected visual acuity of at least 5.0 on the logarithmic visual acuity chart; Color vision: No red-green color blindness; Hearing: Able to distinguish the direction of sound sources with each ear at 50 cm from a tuning fork; Upper limbs: Both thumbs intact, with at least three other fingers intact on each hand, and normal limb and finger movement; Lower limbs: Both legs intact with normal movement function, and length difference not exceeding 5 cm; Trunk and neck: No movement dysfunction; Age between 22 and 60 years old.

19

3

Share

What are the items for daily car maintenance and care?

Daily car maintenance tasks include cleaning, replenishment, and safety inspections. To keep the car in optimal condition, it is necessary to perform routine maintenance once a month. External cleaning is generally done once a week, while replenishment depends on demand. Below are the specific details: 1. Cleaning maintenance: Cleaning and maintenance of the exterior and interior. Remove dirt from the car's exterior, and clean, wash, and wipe the cabin, driver's compartment, and various accessories. Maintenance tasks not only keep the vehicle's appearance neat and attractive but also prepare for the next steps of other maintenance and repair tasks. 2. Replenishment: Replenishment involves checking and topping up engine oil, coolant, and windshield washer fluid levels. 3. Safety inspection: A safety inspection involves cleaning, checking, adjusting, and lubricating all electrical instruments and equipment in the car, replacing or configuring damaged parts and wires, and inspecting and maintaining the battery. Additionally, check the tire pressure. Inspect the steering wheel, clutch brake pedal free travel, and handbrake to ensure they are in good condition. Note that the steering wheel free travel should not exceed 30°.

3

5

Share

Should You Use Recirculation or Fresh Air Mode for Car AC in Summer?

In terms of cooling efficiency, it's better to use recirculation mode for car AC in summer. Here are details about recirculation and fresh air modes: 1. Working Principle: Recirculation mode means the air inside the car is heated or cooled and then recirculated within the cabin; Fresh air mode brings outside air into the car after heating or cooling, achieving air exchange between interior and exterior. 2. Usage Methods: When initially turning on AC or heater, first activate recirculation mode to quickly cool down or warm up the cabin. After temperature stabilizes, appropriately switch to fresh air mode for ventilation. Avoid fresh air mode when outside air quality is poor (e.g., heavy traffic with exhaust fumes or underground parking). On highways, never open windows - use fresh air mode instead. When feeling stuffy inside with good outdoor air quality, immediately switch to fresh air mode for ventilation.

8

2

Share

What are the length and width of the Baojun 310w body?

When is the right time to replace spark plugs?

How many kilometers does a brand-new car generally have when delivered?

Will Removing the Rear Windshield Film Damage the Heating Wires?

What are the requirements for upgrading from A3 to A1 license?

What are the items for daily car maintenance and care?

Should You Use Recirculation or Fresh Air Mode for Car AC in Summer?

Method for Adjusting Valve Clearance on Sonata

Is Engine Noise Related to Engine Oil?

What is the relationship between car power, torque, and horsepower?

Can you park in a yellow-lined parking space?