What are the impacts of enabling hidden features on BMW?

Where is the cabin air filter located in the Yuexiang?

The cabin air filter in the Yuexiang is located above the glove box on the driver's side. First, remove the plastic panel, then use a tool to unscrew the bolts at the end of the glove box, and take off the cover plate to access the cabin air filter. The maintenance cycle for the air filter is approximately every 10,000 kilometers or every six months. If driving in areas with severe smog, it is recommended to replace it every three months. The cabin air filter should be replaced annually, while the air filter should be replaced every 1.5 years or every 20,000 kilometers. The Yuexiang measures 4390mm in length, 1725mm in width, and 1468mm in height, with a wheelbase of 2535mm, making it a compact sedan.

8

5

Share

How to Reset the Tire Pressure on a Land Rover Range Rover?

Method to reset the tire pressure on a Land Rover Range Rover: First, adjust the tire pressure to light load in the settings on the dashboard. After setting it to light load, inflate the front tires to 2.3 bar and the rear tires to 2.5 bar. Then drive for a while. If no fault is reported, the tire pressure is normal, and the reset is complete. The Land Rover Range Rover has a length of 5000 mm, width of 2073 mm, height of 1869 mm, wheelbase of 2922 mm, front track of 1693 mm, rear track of 1685 mm, and minimum ground clearance of 220 mm. It is a mid-to-large SUV equipped with full-time four-wheel drive.

15

4

Share

What does a faucet symbol in the car indicate?

A faucet symbol in the car indicates the engine malfunction indicator light. When this light illuminates, it signifies that the engine has encountered a fault. If the engine malfunction light comes on while driving, it is likely due to poor combustion conditions in the engine, which may result from issues such as engine knocking or carbon buildup. This could be caused by the use of low-quality fuel or internal engine contamination, leading to the illumination of the engine malfunction light. Once the engine malfunction light is on, it will not disappear automatically. The engine fault signal is emitted by the ECU (Engine Control Unit), which controls all the electronic components of the engine. When the engine malfunctions, components such as the electronic throttle, fuel injectors, alternator, and fuel pump may be affected, causing the engine to operate abnormally.

7

4

Share

Will I get points deducted for driving at 50 in a 30 speed limit zone?

Driving at 50 in a 30 speed limit zone will not result in points deduction. According to the guidelines on traffic violations, driving a motor vehicle in violation of speed limits without causing any consequences will result in a warning from the traffic management department of the public security authorities: 1. Exceeding the speed limit by less than 50% on roads with a speed limit below 60 kilometers per hour; 2. Driving medium-sized or larger passenger or cargo vehicles, school buses, or hazardous chemical transport vehicles at speeds exceeding the limit by less than 10% on roads other than highways or urban expressways; 3. Driving vehicles other than medium-sized or larger passenger or cargo vehicles, school buses, or hazardous chemical transport vehicles at speeds exceeding the limit by less than 10%; 4. Driving a motor vehicle on a highway at a speed less than 20% below the prescribed speed limit.

3

Share

How to Determine When Car Brake Pads Need Replacement

Methods to check if car brake pads need replacement: 1. The vehicle dashboard has a brake pad wear limit warning light; generally, when this light comes on, it reminds the owner to replace the brake pads. 2. The thickness of brake pads is between 1 to 1.5 cm (may vary by manufacturer). When the wear thickness is less than 3 mm, the brake pads should be replaced promptly. 3. If there is brake caliper leakage, contaminating the brake pads and soaking into them, and oil stains are still found after sanding with sandpaper, the pads must be replaced regardless of thickness. 4. A decrease in brake fluid in the brake fluid reservoir. 5. Hearing a squeaking sound when braking is a reminder for the owner to replace the brake pads promptly.

6

3

Share

What is the method for adjusting the height of car lights?

Method for adjusting the height of car lights: Low beam: Position the car vertically facing a wall, about 1 meter away. Adjust the low beams so that both lights are at the same height. Mark two focal points on the wall, with the distance between them approximately equal to the distance between the car's headlights. Slowly reverse the car and observe if the center points shift. Adjust so that the two points always align with the marks. High beam: Position the car vertically facing a wall, about 1 meter away, ensuring both lights are at the same height. Mark two focal points on the wall, with the distance between them approximately equal to the distance between the car's headlights. Slowly reverse the car and adjust so that the two points gradually converge towards the center. At a distance of about 30 to 100 meters, they should merge into a single point. High beams can focus more intensely at 30 to 100 meters, illuminating farther distances with less divergence.

4

5

Share

What are the impacts of enabling hidden features on BMW?

Where is the cabin air filter located in the Yuexiang?

How to Reset the Tire Pressure on a Land Rover Range Rover?

What does a faucet symbol in the car indicate?

Will I get points deducted for driving at 50 in a 30 speed limit zone?

How to Determine When Car Brake Pads Need Replacement

What is the method for adjusting the height of car lights?

What Causes the Clutch to Squeak When Pressed?

Does the Kia K3 have headlight cleaning function?

What is the equivalent of Euro III in China's emission standards?

What engine does the Mustang Bojun use?