What Are the Hazards of Severe Shaking When Starting a Manual Transmission Car?

1 Answers
ONova
07/28/25 4:13pm
Severe shaking when starting a manual transmission car can lead to the following hazards: 1. Aggravates engine carbon deposits: The most common cause of car shaking is a dirty throttle body or excessive carbon buildup in the fuel injectors. When there is too much carbon deposit inside the engine, the gasoline sprayed by the cold-start injector is largely absorbed by the carbon deposits, resulting in an overly lean air-fuel mixture during cold starts and making it difficult to start. In this situation, the car will only start easily once the carbon deposits have absorbed enough gasoline to become saturated. After starting, the gasoline adsorbed on the carbon deposits is then sucked into the combustion chamber by the engine's vacuum, making the air-fuel mixture too rich. This fluctuation between lean and rich mixtures causes idle shaking after a cold start. The lower the temperature, the more fuel is required for a cold start, and the presence of carbon deposits will significantly affect the success of the cold start. 2. Damages the car's spark plugs: If the shaking phenomenon during the start of a manual transmission car is not addressed promptly, it can harm the spark plugs and even the entire ignition system. In severe cases, it can lead to poor ignition and spark plug misfires. 3. Accelerates the aging of engine components: Car shaking is also related to worn engine mounts. Engine mounts act as the shock absorption system for the engine, absorbing minor vibrations during operation. If the engine mounts are faulty, these vibrations will transfer to the steering wheel and the cabin, causing shaking during idle.
Was this review help?
6
0
Share
More Forum Discussions

What are the reasons why a van's air conditioning does not produce heat?

The reasons why a van's air conditioning does not produce heat are: 1. Lack of coolant; 2. Internal blockage of the radiator; 3. Damage to the water pump impeller; 4. Air lock in the engine cooling system. The solutions for a car air conditioner not heating up are: 1. Add or replace the coolant; 2. Clean internal debris from the radiator; 3. Replace the water pump impeller; 4. Replace the cylinder head gasket. The functions of car air conditioning are: 1. Drawing in fresh external air for ventilation and air exchange, preventing window fogging; 2. Removing dust, odors, smoke, and toxic gases from the car's interior to freshen the air, and humidifying the car's interior air to increase relative humidity.
5
1
Share

What are the differences between the Tayron 330 Luxury and Luxury Pro?

The differences between the Tayron 330 Luxury and Luxury Pro are: 1. Different curb weights: the 330 Luxury has a curb weight of 1645kg; the Luxury Pro has a curb weight of 1590kg. 2. Different power: the 330 Luxury is equipped with a 2.0L turbocharged engine; the Luxury Pro is equipped with a 1.4L turbocharged engine. Both the Tayron 330 Luxury and Luxury Pro have the same dimensions of 4589mm in length, 1860mm in width, and 1660mm in height. Both the Tayron 330 Luxury and Luxury Pro feature a front MacPherson independent suspension and a rear multi-link independent suspension, paired with a 2.0L turbocharged engine and a 7-speed wet dual-clutch transmission.
12
0
Share

What engine is used in the BMW M6?

The BMW M6 is equipped with a 4.4T V8 twin-turbocharged engine. This high-performance engine delivers a maximum power output of 560 horsepower and a peak torque of 680Nm. Paired with this 4.4T V8 twin-turbo engine is a 7-speed dual-clutch transmission featuring Drivelogic shift logic. The BMW M6's Drivelogic dual-clutch transmission is an innovative design specifically tailored for high-revving engines, offering features such as automatic gear shifting for optimized traction, launch control, low-speed assistance, and an engine energy-saving auto start-stop function. The BMW M6 has body dimensions of 4871mm in length, 1855mm in width, and 1372mm in height, with a wheelbase of 2781mm.
14
5
Share

Is It Appropriate for the Cold Engine Oil Dipstick to Be Exactly at the Upper Limit?

Cold engine oil dipstick being exactly at the upper limit is a normal situation. Below is relevant information about the car oil dipstick: 1. Function: The oil dipstick is used to measure the static oil level height, thereby reflecting whether the engine oil volume is within a reasonable range. 2. Working Principle: Conventional oil dipsticks will have clear upper and lower limits. As long as the detected oil level is between these two limits, it is acceptable. It is best if the oil level is in the middle position. One thing to note is that more oil is not necessarily better. The higher the oil level, the greater the engine resistance. Ideally, the oil level can be maintained slightly below the middle position, where the engine resistance is the smallest and fuel consumption is the lowest, while the lubrication performance can also remain stable.
14
5
Share

Is the roof of the BMW M8 made of carbon fiber?

The roof of the BMW M8 is made of carbon fiber. All M Power series models from BMW use carbon fiber roofs, except for the M2. The BMW M8 is a high-performance M Power model based on the two-door version of the BMW 8 Series. This car is equipped with a 4.4-liter twin-turbocharged V8 engine across the entire lineup. In terms of power, the BMW M8 Coupe M Sport Package version is powered by a 3.0T inline six-cylinder turbocharged engine, delivering a maximum power of 340Ps and a maximum torque of 500Nm, paired with an improved 8-speed Steptronic Sport transmission. It also features an integrated steering system. The dimensions of the BMW M8 are 4873mm in length, 1912mm in width, and 1381mm in height, with a wheelbase of 2827mm.
3
3
Share

Should a seven-year-old car go to collect the annual inspection sticker?

A seven-year-old car needs to collect the annual inspection sticker. Below is relevant information about vehicle annual inspection: 1. Inspection process: The vehicle owner or unit must fill out the "Motor Vehicle Annual Inspection Form" and send the vehicle to the designated location for inspection on the date specified by the local vehicle management office. After passing the inspection, the vehicle management authority will affix a qualified seal on the vehicle's registration certificate and the "Motor Vehicle Annual Inspection Form." 2. Special circumstances: For vehicles that cannot undergo inspection on time due to long-term assignments in other locations, the owner must submit an application and report to the original vehicle management office, which will then authorize the local vehicle management office to conduct the inspection on its behalf. After inspection, the results will be reported back to the original vehicle management office. Vehicles that cannot undergo annual inspection on time due to special circumstances must apply for an extension in advance with the local vehicle management office.
7
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.