What are the functions of the four buttons on the Geely car key?

Where is the keyhole for the one-button start?

The keyhole for the one-button start is located behind the one-button start button. You can see it by prying off the plastic one-button start button. The method to use the one-button start is: 1. Open the car door and get in; 2. Press the brake; 3. Press the start button to complete the one-button start. The working principle of the one-button start is: radio frequency identification technology, which automatically locks and unlocks the doors through the chip in the smart card. When the owner approaches the vehicle, the vehicle automatically recognizes the owner's identity, and the door locks will automatically open and deactivate the anti-theft system without using a key. The method to install a one-button start is: turn the mechanical key to the "no" position, ensuring the entire vehicle is powered on. The wire on the original ignition switch that has no power is the starter motor wire, which should be connected to the starter motor wire of the one-button start.

14

5

Share

What are the warning lights displayed on the car dashboard?

The warning lights displayed on the car dashboard include: engine oil warning light, engine fault warning light, coolant temperature warning light, brake system fault light, tire pressure warning light, battery warning light, power steering system fault light, and electronic stability control system indicator. The car dashboard is a rigid plate or structural component used for installing instruments and related devices. Common indicator lights include: 1. Coolant level warning light; 2. Fuel level indicator; 3. Washer fluid level indicator; 4. Charging indicator; 5. High/low beam indicator; 6. Transmission gear position indicator; 7. ABS (Anti-lock Braking System) indicator; 8. Airbag warning light.

10

1

Share

What is the 0-100 km/h acceleration time of the Mazda3 Axela?

The 0-100 km/h acceleration times for the Mazda3 Axela 1.5L manual transmission model, 1.5L automatic transmission model, and 2.0L automatic transmission model are approximately 11.97 seconds, 12.02 seconds, and 9.23 seconds respectively. Generally, 1.6L compact cars achieve 0-100 km/h acceleration times between 11 to 13 seconds, while 2.0T midsize sedans range between 7 to 8 seconds. Supercars typically accelerate from 0-100 km/h in less than 3.8 seconds. The Mazda3 Axela is a compact sedan under the Mazda brand, equipped with two engine options: a 1.5L naturally aspirated engine and a 2.0L naturally aspirated engine. The 1.5L naturally aspirated engine delivers a maximum power of 86 kW, peak torque of 148 N·m, with maximum power achieved at 6,100 rpm and peak torque at 3,500 rpm. This engine features direct fuel injection technology and uses an aluminum alloy cylinder head and block. The 2.0L naturally aspirated engine produces a maximum power of 116 kW, peak torque of 202 N·m, with maximum power achieved at 6,400 rpm and peak torque at 4,000 rpm. This engine also incorporates direct fuel injection technology and utilizes an aluminum alloy cylinder head and block.

4

1

Share

Where is the battery located in the Foton Tunland?

Foton Tunland battery is located in a black box with positive and negative terminals next to the engine, which can be seen by opening the hood. Car battery maintenance methods: Regularly clean the battery; avoid using electrical equipment when the engine is off; replace the battery periodically; start the car regularly. Functions of the battery: When starting the engine, the battery supplies power to the starting system, ignition system, and electronic fuel injection system; When the engine is stopped or at low idle, it powers the car's electrical equipment; When the generator's output is insufficient, it can assist in powering the electrical equipment; It mitigates voltage surges in the electrical system and protects the car's electronic devices. Reasons for a dead battery: The Foton Tunland battery model is 55D-23L, generally equipped with a factory-installed Sail battery, which has a high safety factor. When the battery is dead, it is usually due to the battery being too old and reaching the end of its lifespan, at which point its charge retention capacity is significantly reduced; another reason is the vehicle being left unused for a long time, leading to natural discharge and power loss; another situation is forgetting to turn off electrical equipment or the vehicle having a power leak, resulting in power loss.

18

0

Share

What is the tutorial for replacing coolant in Jinbei Haise?

The tutorial for replacing coolant in Jinbei Haise is: Before completely replacing the coolant, conduct a thorough inspection to check for any signs of leakage or cracks in the pipes, with special attention to the five-way water pipe. The five-way pipe is named for its five connecting interfaces that link various parts. The coolant flows through the five-way pipe and is then distributed to different parts of the car to function. If there is any leakage of coolant in this section, the water pipe should be replaced or the interface re-secured as needed. Drain the old coolant, then flush the liquid channels with clean water. Add clean water to the coolant reservoir and continue to fill it until water continuously flows through the engine cooling system. Then, start the engine and let it idle for 3 to 5 minutes to circulate the water. Initially, the water flowing out of the reservoir will have a faint pink color. Keep adding clean water until the water coming out is clear. Note: Don’t forget to remove the heater hose and drain the water from the heater core. After draining for about an hour, add the new coolant through the radiator hose, which allows the coolant to flow quickly into the radiator. Then, add another container of coolant to the reservoir until it is nearly full. Start the engine and let it run for about 10 minutes. As the cooling system expels some air, the coolant level will drop. Add more coolant until it reaches the "MAXT" mark on the reservoir.

13

0

Share

What causes one headlight to suddenly stop working?

The reasons why one headlight suddenly stops working are: 1. The bulb is burnt out; 2. The wire is overheating; 3. The relay switch is damaged; 4. The combination switch is damaged; 5. The wire is open, shorted, or broken; 6. The fuse is blown or there is poor line contact. Types of car headlights include position lights, daytime running lights, turn signals, brake lights, fog lights, reverse lights, and license plate lights. The working principle of car headlights is that the central intelligent control chip determines the brightness changes of the external environment based on the light sensor and completes the operation of turning the lights on and off. Car headlights are composed of the headlight assembly, the onboard computer, and the light sensor, and their characteristics are low power consumption, high brightness, and long service life.

13

1

Share

What are the functions of the four buttons on the Geely car key?

Where is the keyhole for the one-button start?

What are the warning lights displayed on the car dashboard?

What is the 0-100 km/h acceleration time of the Mazda3 Axela?

Where is the battery located in the Foton Tunland?

What is the tutorial for replacing coolant in Jinbei Haise?

What causes one headlight to suddenly stop working?

How to Turn On the Steering Wheel Heating in Volvo S90?

What are the methods to close the sunroof on a Mercedes-Benz?

What is the reason for the Lavida Plus displaying insufficient 12V voltage?

What are the reasons for the Roewe RX5's heater not being warm?