What are the functions and benefits of paint coating?

1 Answers
VonDaniela
07/29/25 5:30pm
Functions of paint coating: Scratch resistance, corrosion resistance, no cracking, easy cleaning, anti-static, enhanced gloss, strong water repellency, and superior value retention. The benefits of paint coating include reduced costs for car washing, enhanced gloss, scratch and corrosion resistance, etc. Detailed explanations are as follows: 1. Functions: Scratch resistance: The hardness of diamond crystals reaches 6H, compared to the 2H hardness of ordinary car paint, it can prevent most minor scratches and has an elastic recovery function, protecting the vehicle from daily minor scratches, reducing paint scratches by more than 70% compared to ordinary coatings. When external forces exceed the elastic protection range of the crystals, usually only scratches are left on the crystals without damaging the paint. Easy cleaning: The powerful fiber network of diamond crystals fills the invisible tiny pores on the car's paint surface, achieving a mirror-like finish, making the car body easy to clean and maintain. Various dust and dirt can be rinsed off with just water (without any detergent), and the car's surface can be restored and maintained to a sparkling clean state. Even if oil stains or insect remains are stuck, they can be easily removed by wiping the surface with a wet towel, while saving more than 50% on car washing, and it also has an ultra-strong hydrophobic self-cleaning function. 2. Benefits: Enhanced gloss: After the car is coated, the crystals protect the car's paint surface, and when dust or minor dirt adheres, simply wiping with a wet towel can restore the gloss. Moreover, the glossiness of a coated car is higher than that of a new car, making the entire vehicle look more comfortable.
Was this review help?
7
0
Share
More Forum Discussions

What is the ground clearance of the GAC Aion Y?

The ground clearance of the GAC Aion Y is 150mm. Introduction to minimum ground clearance: Minimum ground clearance refers to the distance between the lowest point of the car (excluding the wheels) and the road surface when the car is fully loaded. The minimum ground clearance indicates the car's ability to overcome obstacles (such as stones, etc.). Function of ground clearance: The larger the minimum ground clearance, the stronger the vehicle's ability to pass over obstacles or uneven ground, but the higher the center of gravity, which reduces stability; the smaller the minimum ground clearance, the weaker the vehicle's ability to pass over obstacles or uneven ground, but the lower the center of gravity, which can increase stability.
17
4
Share

Where is the air conditioning switch for the 2008 Audi A6L?

The air conditioning switch for the 2008 Audi A6L is located directly below the center console area, specifically the AUTO button beneath the multimedia system. Select the appropriate air conditioning fan speed: During normal vehicle operation, to prevent excessive frosting of the evaporator and ensure the proper functioning of the air conditioning system, the fan speed and temperature control should not be set to the lowest settings for prolonged periods. When the vehicle speed is below 25 km/h, the fan speed switch should be set to the low-speed setting to avoid insufficient power generation and inadequate cooling. Duration of single air conditioning use: If the interior temperature has reached a comfortable level, the air conditioning can be turned off or intermittently used. Prolonged use of the air conditioning can lead to excessive pressure on the condenser, causing wear and tear on the refrigeration system. Therefore, it is advisable not to use the air conditioning for extended periods at a time.
19
3
Share

What is the reason why the fuel gauge of Mercedes-Benz C does not drop?

The reason why the fuel gauge of Mercedes-Benz C does not drop is that the float in the fuel tank is stuck, and it can be adjusted and repaired. Do not overfill the fuel tank: Overfilling the fuel tank can easily block the vent hole of the fuel tank. Once the vent hole is blocked, the air pressure inside the fuel tank will be lower than normal, causing poor fuel supply or even no fuel supply. Overfilling the fuel tank also increases the weight of the car, thereby increasing fuel consumption. The gasoline may also deteriorate, posing a safety hazard to the car. Try to avoid waiting for the warning to refuel: When driving, always pay attention to the fuel gauge. When the pointer shows that there is only a quarter of the fuel left, you should refuel. If the fuel tank is empty for too long, the temperature difference between the inside and outside will be large, and moisture is likely to form inside the fuel tank, which will corrode the fuel tank, affect the fuel quality, and increase the burden on the engine.
14
1
Share

What is the Launch Mode of the Geely Xingyue?

Geely Xingyue's launch mode is: the launch start configuration equipped in the Xingyue. In terms of configuration: The Geely Xingyue is fully equipped, including launch mode, AGS intelligent variable intake grille, DP-EPS electronic steering, rear multi-link independent suspension, and many other cross-level configurations. In terms of power: The Geely Xingyue is equipped with a 2.0T engine identical to that of the Volvo XC90, paired with an 8AT automatic manual transmission. The maximum horsepower is estimated to reach 254 hp, and it is equipped with a Volvo-branded real-time four-wheel drive system. It features BorgWarner's fifth-generation electro-hydraulic four-wheel drive system, which is more lightweight in construction and can intelligently switch between four-wheel drive and two-wheel drive.
18
5
Share

What are the effects of BMW FlexRay communication failure?

The effects of BMW FlexRay communication failure are: it may cut off communication between control units or the entire branch and the bus. Introduction to FlexRay: FlexRay is a brand-new bus system and communication system, with a maximum data transmission rate of 10MBit/s per channel, making FlexRay a very high-speed communication system. FlexRay is a high-speed, deterministic, and fault-tolerant bus technology for automobiles, which combines event-triggered and time-triggered methods, featuring high network utilization and system flexibility. It can serve as the backbone network for the next generation of automotive internal networks. Scope of application of FlexRay: FlexRay can be applied in passive bus and star network topologies, as well as in a combination of both topologies. Both topologies support dual-channel ECUs, which integrate multiple system-level functions to save production costs and reduce complexity.
11
5
Share

What does the blue English letter 'E' followed by a string of characters mean on the BMW 3 Series?

The blue English letter 'E' followed by a string of characters on the BMW 3 Series means: BMW Brake Energy Regeneration System. Exterior of the BMW 3 Series: The new BMW 3 Series largely retains the design style of the overseas version, featuring sharp LED headlights connected to an enlarged glossy black kidney grille, complemented by front air intakes and three-dimensional lines. The rear features a straight and sharp taillight design with L-shaped red light strips inside. Powertrain of the BMW 3 Series: The long-wheelbase version of the new BMW 3 Series is equipped with the latest B-series 2.0T engine, delivering the same 184 horsepower as the current 320i/Li, but with the tail badge changed to 325Li. The transmission remains an 8-speed automatic gearbox.
3
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.