What are the essential car maintenance items?

What are the differences between the large Polo and the small Polo?

The large Polo and the small Polo have the following differences: Different dimensions: Large Polo: Length is 4053 mm, width is 1740 mm, height is 1449 mm, wheelbase is 2564 mm. Small Polo: Length is 3970 mm, width is 1682 mm, height is 1462 mm, wheelbase is 2470 mm. The length is increased by 83 mm, width by 58 mm, height is reduced by 13 mm, and wheelbase is increased by 94 mm. Different interiors: The large Polo has made a leap forward compared to the small Polo model, with an overall design concept similar to the T-Cross. The color-matched trim panels make the interior atmosphere more vibrant.

13

2

Share

Where is the transmission fluid level check port located on the Cruze?

Chevrolet Cruze transmission fluid level check port is located at the filling port position. Introduction to Chevrolet Cruze Transmission: The Chevrolet Cruze transmission generally requires about 5 liters of transmission fluid. The automatic transmission fluid of the Chevrolet Cruze cannot be completely drained using atmospheric pressure, only about half of the used fluid can be drained. Function of Transmission Fluid: The main function of transmission fluid is to keep the shifting system clean and to lubricate and prolong the life of the transmission components. Due to different transmission designs, there are manual transmissions and automatic transmissions, each with its own specific technical requirements. Even the same model of transmission configured in different vehicle models will have differences in torque, weight, speed, structure, etc. Therefore, the original manufacturer specifies its own dedicated transmission fluid.

9

5

Share

What is the ground clearance of the Trumpchi GM8?

The ground clearance of the Trumpchi GM8 is 150mm. Smaller ground clearance: The smaller the ground clearance, the worse the ability to overcome obstacles. Regarding the minimum ground clearance, in previous standards, there was a mandatory requirement for the minimum ground clearance, approximately between 150~160mm, but this mandatory requirement has been removed in the current standards. Larger ground clearance: For sedans, the larger the ground clearance (exceeding 130mm), the relatively better the passing performance, but the worse the high-speed stability; the smaller the ground clearance (below 110mm), the better the high-speed stability, but the worse the passing performance. If you frequently drive on mountain roads, choose a car with higher ground clearance; if you mainly drive on urban main roads or highways, a car with smaller ground clearance is sufficient.

14

0

Share

Where is the Jetta fuel pump relay located?

The fuel pump relay of the Jetta is located under the steering wheel near the clutch pedal. Introduction to the fuel pump relay: It is an electronic control device that has a control system and a controlled system, commonly used in automatic control circuits. Essentially, it is an automatic switch that uses a smaller current to control a larger current. Therefore, it plays roles such as automatic regulation, safety protection, and circuit switching in the circuit. The fuel pump relay is used to control the power supply to the fuel pump. Modern cars generally use direct injection and electronic fuel injection. Once the fuel supply meets certain requirements, the relay cuts off the fuel pump, thus controlling its operation. Basic functions of automotive relays: They are "automatic switches" that use a small current to control the operation of a larger current. In circuits, they serve functions such as automatic regulation, safety protection, circuit switching, and more.

18

3

Share

What are the reasons for the constant illumination of the Lavida's brake light?

The Lavida is a sedan produced by Shanghai Volkswagen and was launched in June 2008. While continuing the design language of "dynamic and stylish" in the A-segment car market, the LAVIDA Lavida embodies a new design DNA—"fusion." Here are the reasons for the constant illumination of the Lavida's brake light: 1. Brake light brightness on the instrument panel: (1) Brake pads are worn to the limit. (2) Insufficient brake fluid. (3) Short circuit in the warning circuit, damaged ABS pump, handbrake not released, or short circuit in the switch. 2. Brake light illumination at the rear of the car: The brake light switch on the brake pedal is damaged or there is a short circuit in the brake light circuit.

7

4

Share

Where is the mirror adjustment button for BYD F0?

The mirror adjustment button for the BYD F0 is located on the left side of the main driver's center console. Here is some related information about BYD: 1. Brand History: BYD Company Limited was founded in 1995, starting with a team of just over 20 people. By 2003, it had grown into the world's second-largest rechargeable battery manufacturer and established BYD Auto in the same year. Starting as a battery manufacturer, BYD initially played the role of an 'outsider' in the automotive industry. However, leveraging its 'independent intellectual property rights' and the acquisition of Qinchuan Auto, BYD gained a first-mover advantage over other newcomers. 2. Brand Introduction: BYD Auto adheres to a development path of independent research, production, and branding, aiming to create truly affordable and high-quality vehicles for the public. The product designs incorporate advanced international trends while aligning with the aesthetic values of Chinese culture.

6

2

Share

What are the essential car maintenance items?

What are the differences between the large Polo and the small Polo?

Where is the transmission fluid level check port located on the Cruze?

What is the ground clearance of the Trumpchi GM8?

Where is the Jetta fuel pump relay located?

What are the reasons for the constant illumination of the Lavida's brake light?

Where is the mirror adjustment button for BYD F0?

What are the symptoms of Volkswagen Tiguan transmission failure?

What Causes Windshield Fogging in Summer?

Does the Trumpchi GS5 require removing the front bumper to replace the condenser?

What is the Renault engine belt routing method?