What are the dimensions of the new BMW X1?

1 Answers
SanLilah
07/30/25 6:28am
The dimensions of the new BMW X1 are 4565mm in length, 1821mm in width, and 1620mm in height. Below is a related introduction to the BMW X1: 1. Design: The 2019 BMW X1 remains largely consistent with the previous model, with adjustments made to the headlights and bumper. The headlight structure has been upgraded, with the LED daytime running lights now featuring the latest polygonal design, providing high recognition when lit. The circular fog lights below have been repositioned lower. The air intakes on both sides of the bumper are larger in size and more stylish compared to the current model. The front grille retains BMW's iconic kidney design with black coating, giving the vehicle a cooler appearance. 2. Powertrain: The new X1 continues to be equipped with the existing 1.5T inline three-cylinder engine (18Li model) and 2.0T inline four-cylinder engine (20Li model), delivering maximum power outputs of 136 horsepower and 192 horsepower respectively. The transmission systems are paired with a 6-speed automatic and an 8-speed automatic transmission respectively. The two higher-end models are further equipped with the xDrive all-wheel-drive system.
Was this review help?
13
4
Share
More Forum Discussions

How to adjust the throttle cable?

Canned spray-type oil film remover works very well for removing oil film. Just spray for 3 seconds within the wiper's sweeping range to remove the oil film. Remove the cap and press the bottle firmly to spray the liquid. Spray it within the wiper's operating range on the windshield, with a usage method roughly similar to the spray type.
11
1
Share

What to do if the fuel gauge doesn't move after overfilling the tank?

There is a small chip sensor at the very top of the fuel float. It might get dirty due to poor fuel quality, requiring cleaning with an eraser. After removing the instrument panel, use a multimeter and a large needle to locate and test the circuit corresponding to the fuel gauge on the panel. Then proceed with the appropriate repairs.
17
5
Share

How to Use Oil Film Remover?

Thoroughly sand the area that needs repair, then apply glue to the area that needs repair. Use an electric soldering iron to weld the damaged area. First, tilt the oil tank to temporarily stop the oil leak. Wipe the leaking area, apply glue to the leaking area, and wait for the glue to dry.
2
2
Share

How to Stop an Oil Drum Leak?

Thoroughly sand the area that needs repair, then apply glue to the area that needs patching. Use a soldering iron to weld the damaged area. Tilt the oil drum so that the leak stops temporarily. Wipe the leaking area, apply glue to the leak, and wait for the glue to dry completely.
20
5
Share

What to Do When the Fuel Gauge Doesn't Show Fuel Level?

Remove the fuel float from the fuel tank, clean it, repair it, and try again. If it still doesn't work, consider replacing it. The above phenomenon occurs due to poor contact between the main fuel level sensor and the auxiliary fuel level sensor. It is recommended to replace the relevant sensors.
7
1
Share

How to Replace a Broken Fuel Tank Cap?

Use tools to push out the two retaining pins at the end connected to the fuel tank cap, then pull off the fuel tank cap tether. Insert one end of the new tether into the fuel tank cap loop position, push the retaining pins into the eyelets, and then squeeze to align them. Finally, screw the fuel tank cap with the tether onto the fuel tank, and secure the other end to the vehicle body.
15
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.