What are the dimensions of the Mercedes-Benz 260L?

1 Answers
DiAlyssa
07/29/25 9:34pm
The dimensions of the Mercedes-Benz 260L are: length 4783mm, width 1810mm, height 1442mm. Method of measuring dimensions: The body length is the distance between the two extreme points in the length direction of the car, measured from the most protruding point of the front bumper to the most protruding point of the rear bumper. The body width is the distance between the two extreme points in the width direction of the car, which is the distance between the left and right most protruding points of the body. According to industry standards, the body width does not include the width of the left and right rearview mirrors when they are folded. The body height is the distance from the ground to the highest point of the car, and the highest point refers to the topmost position of the car body, excluding the length of the roof antenna. Related car dimensions: The exterior dimensions of the Mercedes-Benz A200L are length x width x height: 4622x1796x1454mm. The exterior dimensions of the Mercedes-Benz GL450 are length x width x height: 5099x1920x1840mm.
Was this review help?
10
0
Share
More Forum Discussions

What Causes a Sudden Muffled Sound in Car Horns?

Introduction to the causes of a sudden muffled sound in car horns: A sudden muffled sound in a car horn is usually caused by poor contact at the horn plug, especially around the steering wheel contacts, which are prone to wear due to frequent use. The car horn is an audio signal device used during driving to ensure traffic safety. Below is relevant information about car horns: 1. Components: A car horn mainly consists of an iron core, magnetic coil, contacts, and diaphragm. 2. Working Principle: When the driver presses the horn switch, current flows through the contacts, generating magnetic force via the coil, which moves the diaphragm, producing sound through the connection between the resonator and the diaphragm. 3. Classification of Car Horns: Car horns are divided into air horns and electric horns based on the sound power source, and into high-pitch and low-pitch horns based on frequency. Air horns produce sound by vibrating a diaphragm through compressed air, while electric horns generate sound via electromagnetic attraction. Electric horns are widely used in cars, whereas air horns are commonly found in buses and heavy trucks.
1
3
Share

What are the effects of forgetting to turn off the engine while refueling?

Forgetting to turn off the engine while refueling does not have any negative effects on the car, but it poses certain safety hazards. Here are the relevant details: 1. Hazards: If the vehicle is not turned off, the electrical circuits and equipment remain operational, and the engine continues to run at high temperatures. If there is any electrical leakage, it could potentially spark and cause a fire or explosion. Therefore, it is essential to remember to turn off the engine and power when refueling, and only restart the vehicle after the fuel cap is securely closed. 2. Precautions: Always remember to turn off the engine when entering a gas station for refueling, and avoid any open flames to ensure safety.
1
5
Share

What Causes High Engine RPM Without Corresponding Speed Increase in Motorcycles?

This situation may be caused by clutch slippage. The engine RPM can increase, but the vehicle speed does not correspondingly rise. If the riding method is correct, the likely cause is clutch slippage. First, check the engine oil condition, whether the clutch cable is too tight, and if the clutch release rocker arm is stuck and not returning to position. If these aspects are normal, then inspect the wear condition of the clutch plates and whether there are issues with the clutch springs. Below is relevant information about engine RPM: 1. Introduction: The level of engine RPM relates to the number of work cycles per unit time or the magnitude of the engine's effective power, meaning the engine's effective power varies with different RPMs. Therefore, when indicating the size of the engine's effective power, the corresponding RPM must also be specified. The effective power and its corresponding RPM specified on the engine's product label are referred to as the rated power and rated RPM, respectively. The operating condition of the engine at rated power and RPM is called the rated condition. Rated power is not the maximum power the engine can produce; it is the maximum usable limit of effective power determined based on the engine's application. For the same engine model, the rated power value may differ depending on its use. Effective torque also varies with engine conditions. Therefore, the maximum torque a vehicle engine can output and its corresponding RPM serve as an indicator for evaluating the engine's dynamic performance. 2. RPM Measurement: Typically, an RPM sensor is used, corresponding to the signal teeth on the flywheel, to measure the engine's RPM.
18
1
Share

What is the fuel consumption of the Nissan Murano?

The comprehensive fuel consumption of the Nissan Murano is 8.3-8.4L/100km. There are currently 3 models of the Nissan Murano on sale. The fuel consumption of the Elite version is 8.3L/100km, while the Intelligent Luxury version and Intelligent Leading version have a fuel consumption of 8.4L/100km. The above figures are based on the NEDC comprehensive fuel consumption, which is the fuel consumption data measured under the NEDC test procedure. The actual fuel consumption is higher than these values, ranging from 8.6-9.1L/100km. Specific factors affecting a car's fuel consumption are as follows: Vehicle weight: Larger and heavier cars tend to consume more fuel. Generally, a small family car with a 1.6L engine and a weight of around 1.2 tons has a fuel consumption of about 7.5 liters (calculated under full load conditions), while an SUV weighing around 1.5 tons consumes about 8.5 liters. Different weights result in varying fuel consumption. Drag coefficient: Higher drag coefficients increase fuel consumption during driving. Cars with better aerodynamics have lower drag coefficients, leading to lower fuel consumption. Economical RPM: During driving, the engine has an optimal torque output point. Maintaining the car's speed within this torque output range can significantly reduce fuel consumption. Generally, for small-displacement cars, this is around 70 km/h, while for larger-displacement cars, it is about 100 km/h. Staying within this economical RPM range ensures minimal fuel consumption. Driving style: Aggressive driving behaviors such as sudden acceleration, frequent overtaking, and not easing off the throttle before red lights can increase fuel consumption.
3
2
Share

Can New Energy Vehicles Get Blue License Plates?

New energy vehicles cannot get blue license plates; they must use green license plates, which are special plates designated for new energy vehicles, with green symbolizing environmental protection. Types of new energy vehicles include: pure electric vehicles, plug-in hybrid electric vehicles, and fuel cell vehicles. Characteristics of new energy vehicles: 1. They use natural gas, petroleum gas, hydrogen, or electricity as power sources, saving fuel energy; 2. They reduce exhaust emissions, produce no tailpipe pollution (hydrogen vehicles emit only water, causing no environmental harm); 3. They employ new technologies and structures for higher efficiency; 4. They operate with low noise.
3
0
Share

What are the precautions for new energy vehicles?

Precautions for new energy vehicles are: 1. Before driving, check whether the battery power is sufficient, whether the braking performance is good, whether the screws are loose, and any faults should be repaired and eliminated in time; 2. When parking, the power switch must be turned off, the key must be pulled out, the gear switch must be turned to the neutral position, and the handbrake must be pulled up; 3. When children play in the car, the key switch must be pulled out; 4. Charging should be carried out in a place where children cannot reach; 5. When repairing or replacing the charging fuse, the power plug must be unplugged; 6. When repairing or replacing the battery or electrical appliances, the main power switch must be turned off before operation; 7. Before driving a new energy vehicle, it is necessary to check whether the doors are closed tightly; 8. In case of fire caused by an accident or other reasons, the main power switch should be turned off immediately.
18
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.