What are the dimensions of the A7L?

1 Answers
OAndres
07/30/25 5:25am
The dimensions of the SAIC Audi new A7L-45TFSI are 5076mm in length, 1908mm in width, and 1429mm in height, with a wheelbase of 3026mm. In terms of exterior design, the front face of the domestic Audi A7L largely follows the design language of the imported A7, with some modifications to the grille pattern. The crisscross grille design offers a refreshing visual appeal. The most significant changes to the A7L are on the side profile and rear, where the youthful and dynamic fastback design has been replaced with an extended three-box sedan tail. For the interior, the Audi A7L retains the highly technological triple-screen design, with an overall layout similar to the Audi A6L. The infotainment system uses the MIB3 system. Comfort features such as dual-zone automatic climate control and seat heating are also included. Under the hood, the 2.0T model delivers a maximum of 245 horsepower, while the 3.0T model, with the support of a 48V mild-hybrid system, can produce up to 250kW and 500Nm of torque, achieving a 0-100km/h acceleration in approximately 5.5 seconds. The powertrain is mated to a 7-speed dual-clutch transmission and the Quattro all-wheel-drive system, with the rear wheels also featuring the DAWS dynamic all-wheel steering system.
Was this review help?
5
1
Share
More Forum Discussions

Can You Pay to Pass Subject 2?

Subject 2 cannot be passed by paying money. Introduction: Subject 2, also known as the small road test, is part of the motor vehicle driver's license assessment and is the abbreviation for the field driving skills test subject. Small vehicle C1/C2 Subject 2 test items: Includes five mandatory tests: reverse parking, parallel parking, stopping and starting on a slope, right-angle turns, and curve driving (commonly known as S-curve). Some regions also include a sixth item: highway toll card collection. Large vehicle A1/A2/A3/B1/B2 Subject 2 test items: Includes pile test, stopping and starting on a slope, parallel parking, passing a single-plank bridge, curve driving, right-angle turns, passing a width-limited gate, passing continuous obstacles, driving on undulating roads, narrow road U-turns, as well as simulated highway driving, continuous sharp turns on mountain roads, tunnels, rain (fog) conditions, slippery roads, and emergency handling.
14
3
Share

How to Achieve Rapid Acceleration from a Manual Transmission Start?

To achieve rapid acceleration from a manual transmission start, coordination between the throttle and clutch is essential. The specific steps are as follows: 1. Quickly lift the clutch to the semi-engagement point, and when the car begins to vibrate, stop lifting the left foot and hold the clutch steady; 2. Gently press the throttle with the right foot until the RPM reaches around 1300-1500; 3. Slowly release the clutch with the left foot while simultaneously continuing to apply more throttle (the faster the desired acceleration, the more throttle is needed, but the clutch must also be released more quickly). Once the clutch is fully released, the car will continue moving forward. Shift to 2nd gear when the RPM reaches around 1800-2000, and then shift gears at every 2000 RPM thereafter. Key points to note: At the last second, release the handbrake as quickly as possible, completely lift the clutch with the left foot, press the throttle all the way down with the right foot, swiftly move the right hand to the gear lever, focus your eyes ahead while glancing at the tachometer, and shift to 2nd gear as soon as the needle exceeds the optimal RPM.
20
2
Share

What are the consequences of not replacing the car's air filter?

The hazards of not replacing the air filter for a long time: 1. Accelerated engine wear and carbon deposits: It will accelerate engine wear and carbon deposits. If the vehicle is operated without an air filter, dust will directly enter the cylinder and mix with oil and gas for combustion. In this case, the degree of cylinder wear will be eight times that of a vehicle equipped with an air filter, three times the piston wear, and nine times the piston ring wear. 2. Dirty engine intake tract: Long-term use of a damaged air filter will not only allow dust to enter the engine but also invade the engine's intake tract, causing it to become dirty. 3. Decreased filtration efficiency: When the air filter is not too dirty, an air gun can be used to blow it clean. When blowing, pay attention to blowing from the inside to the outside. However, most air filters are made of coarse filtration and low wind resistance materials. During driving, the filter forms resistance to the airflow. When the dust accumulation exceeds a certain value, the filter resistance will increase, and the filtration efficiency will decrease.
1
2
Share

Can I Get a Refund If I Don't Want to Continue Studying After Passing Subject One?

If a candidate does not wish to continue studying the remaining subjects after passing the Subject One exam, they can apply for a refund from the institution they registered with. The refund amount may vary depending on the location. Subject One Exam Content: Basic knowledge of motor vehicles; laws, regulations, and road traffic signals; safe driving and civilized driving basics; basic knowledge related to motor vehicle driving operations. Subject One Exam Process: Follow the staff's instructions and collect your driving training file in order at the waiting area; Carry and present your ID card for inspection by the supervising officer; Mobile phones must be turned off when entering the exam area; No loud noise is allowed in the exam area; Regulation textbooks are not allowed in the exam area (or must be placed in a bag); After the exam, keep your ID card safe and submit the file to the "Document Submission Window" at the front of the exam area; Candidates who pass the exam must sign under the guidance of the staff at the exam exit before leaving; Candidates who fail the exam can leave immediately and wait for notification from their driving school regarding the retake time.
7
1
Share

Is there any difference between Subject 1 for C1 and C2?

There is no difference between Subject 1 for C1 and C2. The test questions for C1 and C2 Subject 1 are the same because both C1 and C2 driver's licenses are for small vehicles, and according to China's traffic driving examination regulations, Subject 1 has a unified test. C1 driver's license examination: The examination includes four subjects: traffic regulations and related knowledge, field driving, road driving, and safe and civilized driving knowledge. Passing standards: Traffic regulations and related knowledge (Subject 1) - written test, full score is 100, 90 or above is passing. Field driving (Subject 2) - on-site, actual vehicle. The minimum requirement is 80 points, below 80 is failing. Road driving (Subject 3) - on the road or simulated field, actual vehicle. Full score is 100, must achieve 90 or above to pass. Safe and civilized driving knowledge - written test, questions mainly in the form of cases, pictures, animations, etc., including true/false, single-choice, and multiple-choice questions, totaling 50 questions, full score is 100, 90 is passing.
12
4
Share

The Actual Fuel Consumption of the Lingpai?

The actual fuel consumption of the Lingpai is 6.2 to 6.5 liters per 100 kilometers. The following is a related introduction about the Lingpai: 1. Model: The Lingpai is a new strategic mid-size car under GAC Honda, a mainstream compact sedan specifically designed by GAC Honda to meet the comprehensive needs of post-80s consumers, and it is a dream mid-size car for the post-80s generation. 2. Difference: Compared with its competitors, the Lingpai's exterior design clearly shows its sporty positioning, which is significantly different from the family-oriented positioning of the Sylphy, the moderate design of the Bora, and the Lavida.
14
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.