What are the dimensions (length, width, height) of the Lexus NX?

1 Answers
Christine
07/29/25 11:39am
The Lexus UX body dimensions (length, width, height) are: 4495mm, 1840mm, 1520mm; the Lexus NX body dimensions (length, width, height) are: 4640mm, 1845mm, 1645mm. Introduction to Lexus NX: The Lexus NX is positioned below the Lexus RX. Additionally, as the first Lexus model to feature a turbocharged engine, this model will target European mid-size SUVs such as the Mercedes-Benz GLK, Audi Q5, and BMW X3 upon its launch. Lexus NX Exterior: The Lexus NX successfully inherits many of the successful design elements from its concept car and maintains a stunning exterior style even in its production version. The muscular body lines leave a very strong impression.
Was this review help?
5
0
Share
More Forum Discussions

How to Remove Stickers from Car Body?

Methods to remove car body stickers are as follows: Purchase a dedicated adhesive remover spray, simply spray it on the sticker area, wait a few minutes, then wipe it off with a towel and rinse with clean water. You can also apply a hot towel to the sticker and then peel it off. Use a heat gun or hair dryer to warm the sticker until the adhesive melts, then remove it. If the sticker is not carefully removed, residual adhesive may remain on the car body. To remove the residual adhesive, you can try the following methods. Soak a towel with some alcohol and wipe the residual adhesive area to remove it. Using an eraser is also a simple method; just rub the residual adhesive with the eraser. You can also use some tar remover, but remember to wear gloves to avoid corrosion from the cleaner.
5
2
Share

How to Remove the Spare Tire on a Pajero?

Spare tires are typically backup tires. Below are the steps to remove the spare tire on a Pajero: 1. First, locate the two screws inside the door, then unscrew them to open the spare tire cover. 2. Next, loosen the fixing screw of the spare tire to remove it. Additional Information: 1. A spare tire is only for temporary replacement, with a maximum speed limit of 80 km/h and a driving distance not exceeding 100 kilometers. 2. Spare tires have different speed ratings and load indexes compared to the vehicle's four regular tires and cannot be used as a permanent substitute. 3. When using a deflated spare tire, inflate it with the provided air pump to ensure proper usage.
10
5
Share

What is the highway fuel consumption of the Li ONE?

Actual test of the 2021 Li ONE model: cruising at 120km/h on the highway for 351 kilometers consumed 34.1L of fuel, resulting in a fuel consumption of 9.7L per 100 kilometers. For the 2019 BMW X5, owner-measured highway cruising at 120km/h showed a displayed fuel consumption of 8.5L/100km, with the actual consumption estimated at around 9L. The highway fuel consumption of the Li ONE is slightly higher than that of recent fuel-powered vehicles. The technically outdated range-extender hybrid system results in highway fuel consumption comparable to, or even higher than, that of fuel-powered vehicles. There is still a significant gap between domestic and Japanese hybrid technologies. For example, the Highlander hybrid actually has relatively low highway fuel consumption.
10
3
Share

How to Replace the Low Beam Bulb on a BYD F3?

BYD F3 low beam bulb replacement steps are as follows: 1. Open the engine hood. Reach into the opened engine hood and lift the latch upwards. 2. Disconnect the nearby power connector. This is to facilitate the operation. 3. Open the rear cover. Pinch the raised part of the lamp rear cover and rotate it clockwise. 4. Remove the bulb. Press down firmly on the fixing bracket and lift it upwards. 5. Install the new bulb onto the lamp socket. First secure the fixing bracket, then reconnect the power connector. 6. Replace the right low beam bulb. The method is the same as above. 7. Test whether the bulb is functioning properly. After confirming it works, reinstall the rear covers on both sides.
16
4
Share

What are the pros and cons of installing exhaust tips on cars?

No significant drawbacks have been found with car exhaust tips, and they have no adverse effects on vehicles. In addition to preventing deformation of the exhaust pipe, car exhaust tips also provide turbocharging and spoiler effects, and can reduce the noise emitted from the exhaust pipe to some extent. Related information about car exhaust tips: 1. Fire safety: There are exhaust tips specifically designed for fire safety, such as those used on tanker trucks and certain special vehicles. 2. Purely aesthetic purpose: Many chrome-plated exhaust tips are fixed to the original iron exhaust ports to enhance appearance. 3. Sports modification: This type mainly increases the exhaust sound, producing a roar similar to that of a sports car as the exhaust passes through the tip, but it does not actually improve engine performance.
19
4
Share

Toyota Prado Reverse Radar Not Beeping?

Toyota Prado reverse radar not beeping troubleshooting methods are as follows: 1. Check if the reverse radar wiring at the rear bumper is properly connected. 2. Observe whether the reverse lights illuminate when in reverse gear. If not, inspect the reverse light switch. 3. Remove the right-side trunk liner to test the continuity of the wires leading to the radar. 4. Open the fuse box and use a multimeter to check the continuity of the reverse radar-related fuses. 5. If the reverse radar module or buzzer is damaged, replacement is necessary. Additional information about reverse radar is as follows: 1. The full name of reverse radar is reverse anti-collision radar, also known as parking assist device. 2. It mainly consists of ultrasonic sensors, a controller, and a display (or buzzer).
17
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.