What are the differences between the Passat Elite Edition and Business Edition?

When did Beijing implement the China VI emission standard?

Beijing implemented the China VI emission standard on January 1, 2020. China has divided the China VI standard into two phases: China VIa and China VIb, with implementation dates in 2020 and 2023, respectively. Relevant information about the China VI standard is as follows: 1. Meaning of the China VI standard: The China VI standard refers to the National Sixth Stage Emission Standard for Motor Vehicle Pollutants. 2. Purpose of enacting the China VI standard: To enforce China's environmental protection laws; reduce and prevent air pollution caused by vehicle exhaust, protect China's ecological environment, and safeguard human health.

4

2

Share

What is the best way to break in a new automatic transmission car?

For a new automatic transmission car, the break-in period is generally around 500 kilometers. During this period, it's advisable not to drive too fast, maintaining a speed of 60-70 km/h, and keeping the engine RPM below 2200 for optimal results. Below are the specific details of the break-in period: 1. Mid-break-in period: From 500 to 1000 kilometers, you can gradually increase the speed from 60-70 km/h to 90-100 km/h, while still keeping the RPM below 2500. This can actually help promote the break-in process and allow you to check for any abnormalities during acceleration. 2. Late break-in period: From 1000 to 1500 kilometers, you can further increase the speed to below 120 km/h. The break-in process should be gradual, and it's important not to exceed 3000 RPM.

10

2

Share

What is the solution for Dongfeng Nissan P0846?

Replace the transmission oil. The P0846 fault code in Dongfeng Nissan appears due to unclean transmission oil. Here are the reasons for the P0846 fault code: 1. Transmission failure: This means the dashboard warning light comes on during driving, accompanied by issues such as jerky starts, sluggish gear shifts, delayed throttle response, and inability to accelerate. 2. Intermittent acceleration failure: When the throttle is fully pressed, the RPM needle only swings around 1000, with noticeable jerking during gear changes. Sometimes the RPM drops directly from 2000 to 1000, the engine warning light comes on, and the vehicle vibrates.

19

2

Share

Is 18650 a Lithium Battery?

18650 is the pioneer of lithium-ion batteries. Here is the relevant introduction about 18650: 1. It is a standard lithium-ion battery model set by Sony Corporation of Japan to save costs at that time. Among them, 18 represents a diameter of 18mm, 65 represents a length of 65mm, and 0 represents a cylindrical battery. 2. Common 18650 batteries are divided into lithium-ion batteries and lithium iron phosphate batteries. The voltage of lithium-ion batteries is 3.7v, the charging cut-off voltage is 4.2v, the nominal voltage of lithium iron phosphate batteries is 3.2V, the discharge cut-off voltage is 3.6v, and the capacity is usually 1200mAh-3350mAh, with the common capacity being 2200mAh-2600mAh.

10

1

Share

How to reset the maintenance light on Changan Suzuki?

Changan Suzuki's maintenance light reset procedure consists of four steps: 1. Turn on the ignition switch and briefly press the right-side information display selector handle. 2. Press and hold the left-side odometer button for more than 5 seconds until the oil lock indicator appears on the display, then release the button. The display area will show the oil lock. 3. After completing step two, release the button and press it five times consecutively within 2 seconds. This operation must be completed within 3 seconds. 4. The "oil lock" will turn off, and "SUCCESSFUL" will be displayed, indicating the reset operation is complete. The purpose of car maintenance is to keep the vehicle clean and tidy, maintain normal technical conditions, eliminate potential hazards, prevent faults, slow down the deterioration process, and extend the service life.

16

2

Share

How many kilometers should brake pads be replaced?

Generally speaking, the replacement interval for front brake pads is 30,000 kilometers, while rear brake pads should be replaced every 60,000 kilometers. Here is some relevant information about brake pads: 1. Brake pads, also known as brake linings, are the most critical safety components in a car's braking system. The effectiveness of all braking performance is decisively determined by the brake pads, making high-quality brake pads the guardian of both people and vehicles. 2. The main difference between ceramic brake pads and traditional brake pads is the absence of metal. In traditional brake pads, metal is the primary material that generates friction, providing strong braking force but with greater wear and a tendency to produce noise. After installing ceramic brake pads, no abnormal screeching (i.e., scraping sounds) will occur during normal driving. Since ceramic brake pads do not contain metal components, they avoid the metal screeching noise caused by the friction between traditional metal brake pads and their counterparts (i.e., brake pads and brake discs).

15

5

Share

What are the differences between the Passat Elite Edition and Business Edition?

When did Beijing implement the China VI emission standard?

What is the best way to break in a new automatic transmission car?

What is the solution for Dongfeng Nissan P0846?

Is 18650 a Lithium Battery?

How to reset the maintenance light on Changan Suzuki?

How many kilometers should brake pads be replaced?

How Can Beginners Tell If the Car Body Is Aligned Properly?

What Causes Weak Ignition in Cars?

What are the symptoms of a broken gearbox?

How to Open a Car Door?