What are the differences between the Magotan 330 and 380?

1 Answers
SanKarter
07/29/25 10:55pm
1. Power: The 330 model is equipped with a 2.0T low-power engine, with a maximum power of 186 horsepower and a peak torque of 320 Nm. The 380 is the high-end version of this car, featuring a 2.0T high-power turbocharged engine with a maximum power of 220 horsepower and a peak torque of 350 Nm. 2. Transmission: The 330 is paired with a 7-speed wet dual-clutch transmission, with a tested 0-100km/h acceleration time of 7.6 seconds. The 380 also uses a 7-speed wet dual-clutch transmission, achieving a 0-100km/h acceleration time of 6.99 seconds.
Was this review help?
7
0
Share
More Forum Discussions

What to Do If You Forget to Renew an Expired Out-of-Town Driver's License?

An expired out-of-town driver's license can be renewed in the same location where it was issued. Methods for out-of-town renewal: Apply for renewal at the local vehicle management office; Use the "Traffic Management 12123" APP for renewal. Download the app, select Service Center -- Expired License Renewal Service -- fill in the required information. The new license is usually delivered by mail. Visit a "Police-Medical-Post" service point at a postal office for renewal. The entire process, from registration and medical examination to the production of the new license, takes only about half an hour. Currently, this service is available in only a few cities, such as Hangzhou. Driver's License Validity Period: Article 56 of the "Regulations on the Application and Use of Motor Vehicle Driver's Licenses": If a driver has not accumulated 12 penalty points in any scoring cycle during the six-year validity period of the license, they can renew it for a ten-year validity period. If they continue to avoid accumulating 12 points in any scoring cycle during the ten-year validity period, they can renew it for a long-term valid license. Rules for License Invalidation: If expired for less than one year, the license can be renewed normally; if expired for one to three years, the license is revoked but can be renewed by passing the first subject test; if expired for over three years, the license becomes invalid and cannot be renewed.
15
1
Share

How to Identify High-Pressure Common Rail Faults?

Check whether the rail pressure sensor signal voltage terminal 214 (A26) is open circuit. Measure the voltage at pin 2 of the connector with a multimeter; the normal range is 4.9-5.1V. Check the rail pressure sensor signal voltage terminal 214 for short circuit to ground. Turn off the ignition switch and unplug ECU connector 2. Turn on the ignition switch and measure the resistance between ECU harness terminals 213 (A07) and 214 (A26) with a multimeter; the normal reading should be infinite.
15
2
Share

What is the most suitable tire pressure?

Tire pressure of 2.4 to 2.5 bar is most suitable, while reinforced tires require 2.8 to 2.9 bar. The maximum tire pressure should not exceed 3.5 bar. Tire pressure, also known as air pressure, refers to the internal air pressure of the tire. The load capacity of a vehicle depends on the tire pressure, which plays a crucial role in the car's performance and power. Maintaining proper tire pressure is essential. Excessive pressure reduces tire friction and adhesion, affecting braking performance, and may cause steering wheel vibration or deviation, compromising ride comfort. Insufficient pressure increases the friction coefficient between the tire and road surface, leading to higher fuel consumption, heavier steering, and potential deviation, all of which negatively impact driving safety.
18
4
Share

What icon is displayed when the anti-lock braking system is activated?

The anti-lock braking system does not display an icon when it is activated. An icon will only appear on the dashboard when the system is turned off or malfunctions, typically labeled as ABS. The exact appearance may vary slightly depending on the vehicle model. The anti-lock braking system enhances safety during emergency braking while driving. In other words, vehicles without ABS are more prone to wheel lock-up during emergency braking, which means the steering wheel cannot be turned, significantly increasing the risk of severe accidents. Advantages of the anti-lock braking system: When a wheel is about to lock up, the brake fluid pressure causes the system to cycle rapidly, acting 60 to 120 times per second. This mimics a mechanical 'pumping' of the brakes, preventing wheel lock-up and maintaining steering control. ABS prevents the wheels from locking during emergency braking, avoiding skidding and ensuring that the tires do not rub against the ground at a single point, thereby maximizing friction. This increases braking efficiency to over 90% while reducing brake wear, extending the lifespan of brake drums, discs, and tires by up to twice as long. Vehicles equipped with ABS achieve skid resistance performance of 80%–90% on dry asphalt, 10%–30% on wet roads, and 15%–20% on snowy surfaces.
6
0
Share

Does the Binyue have a 4-cylinder engine?

Binyue does not have a 4-cylinder engine. The car is equipped with a 1.0T engine and a 1.5T engine, both of which are three-cylinder engines. Advantages of three-cylinder engines: 1. Lighter weight; 2. Easier to arrange electric motors; 3. More fuel-efficient. Binyue is an SUV under Geely Auto. The car has a length, width, and height of 4330mm, 1800mm, and 1609mm respectively, with a wheelbase of 2600mm. In terms of appearance, the car adopts the brand's family design language, featuring a youthful, stylish, and powerful overall shape. The new front grille is paired with an angular front bumper design, and the sport version also includes red interior trim strips, highlighting individuality while enhancing the sporty atmosphere.
4
5
Share

What is the appropriate tire pressure for a car?

Appropriate car tire pressure conditions are: 1. The front tire pressure should be between 2.2 to 2.3 bar when unloaded, and between 2.4 to 2.5 bar when fully loaded; 2. The rear tire pressure should be between 2.4 to 2.5 bar when unloaded, and between 2.6 to 2.8 bar when fully loaded. Different tire models may have slight variations in the recommended pressure range, and the standard tire pressure for the vehicle is usually indicated by the manufacturer. Tire pressure can also change with temperature. In high temperatures or during summer, it is advisable to reduce the tire pressure by 0.1 to 0.2 bar. Conversely, in very low temperatures, such as during winter, the tire pressure should be increased by 0.1 to 0.2 bar.
15
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.