What are the differences between the Lamando 230 and 280?

When will the National VI emission standard be implemented in Hunan Province?

Hunan Province will implement the National VI emission standard from July 1, 2019, in accordance with the national unified deployment. The National VI emission standard, which is an upgraded version of the current National V emission standard, imposes more stringent limits on the following pollutant emissions: 1. CO (Carbon Monoxide); 2. THC (Total Hydrocarbons); 3. NMHC (Non-Methane Hydrocarbons); 4. NOX (Nitrogen Oxides); 5. PM (Particulate Matter); 6. PN (Particle Number).

3

2

Share

What to Do When the Fuel Pump is Noisy?

When the fuel pump produces a loud humming noise, it is mainly due to an issue with the gasoline pump. It is recommended to replace the gasoline pump. Below is some information about the gasoline pump: 1. The function of the gasoline pump is to draw gasoline from the fuel tank and deliver it through the pipeline and gasoline filter to the float chamber of the carburetor. 2. It is precisely because of the gasoline pump that the fuel tank can be placed at the rear of the vehicle, far from the engine, and below the engine. Extended Content: To ensure the long-term durability of the generator, the following precautions should be taken: 1. Before installing the fuel transfer pump in the generator set, check whether the model and specifications are correct, and remove the anti-rust oil. The thickness of the selected gasket should be appropriate. To avoid the piston being stuck or not operating properly, prevent the gasket from being too thin or too thick. When tightening the bolts, apply uniform torque to prevent damage to the fuel pump. 2. There is a rubber sealing device between the hand pump piston and the hand pump body on the fuel transfer pump. Do not disassemble it arbitrarily. If the rubber ring is found to be damaged, replace it promptly. 3. The coarse filter screen inside the fuel transfer pump joint is extremely prone to clogging due to debris such as cotton fluff. Regularly inspect and clean it. If the filter screen is damaged, it must be repaired or replaced immediately. 4. Ensure that all sealing gaskets on the generator set's fuel transfer pump are intact. The plastic sealing rings should not be disassembled too many times and should be replaced periodically.

11

0

Share

What is the tire model of the Cruze?

The Cruze uses Continental ContiMAXContact-MC5 tires with the specification 225/45-R17. Below is an introduction about tire pressure: 1. Introduction: Tire pressure, strictly speaking, refers to the air pressure inside the tire. The level of tire pressure plays a crucial role in the performance and power of the car, affecting driving safety. 2. Hazards of excessive tire pressure: The friction and adhesion of the tire will decrease, affecting braking performance; it can cause steering wheel vibration and deviation, reducing driving comfort. 3. Hazards of insufficient tire pressure: The friction coefficient with the road surface increases, leading to higher fuel consumption.

4

Share

What are the differences between Maybach and Mercedes-Benz S?

The differences between Maybach and Mercedes-Benz S are as follows: 1. Dimensions: The Maybach has a wheelbase of 3365 mm, with length, width, and height measuring 5466 mm, 1899 mm, and 1500 mm respectively. The Mercedes-Benz S has a wheelbase of 3165 mm, with length, width, and height measuring 5259 mm, 1899 mm, and 1497 mm respectively. 2. Powertrain: The Maybach is equipped with three engines: a 3.0-liter turbocharged engine, a 4.0-liter turbocharged engine, and a 6.0-liter turbocharged engine. The Mercedes-Benz S-Class comes with two engines: a low-power version of the 3.0-liter turbocharged engine and a high-power version of the 3.0-liter turbocharged engine.

13

2

Share

How to Operate an Automatic Transmission at a Red Light?

The correct method for operating an automatic transmission at a red light is: 1. For short waits at a red light, keep the transmission in D (Drive) and hold the brake. 2. For waits longer than 20 seconds, it is recommended to shift to N (Neutral). On flat roads, the parking brake is not necessary, but it should be engaged on slopes. 3. It is not advisable to shift to P (Park) at a red light, as a strong rear-end collision could potentially damage the parking pawl and gear. Additional Information: 1. An automatic transmission eliminates the need for the driver to manually shift gears, as the vehicle automatically selects the appropriate gear based on speed and traffic conditions. 2. Typically, an automatic transmission has six gear positions, arranged from top to bottom as: P (Park), R (Reverse), N (Neutral), D (Drive), S (Sport), and L (Low).

20

0

Share

Where is the Wuling Hongguang Wiper Relay Located?

Wuling Hongguang wiper relay is placed in the control cabinet or control box. Below is the relevant information: 1. Introduction: As a control device, the relay is connected in the circuit to form two control systems: the control system (also known as the input circuit) and the controlled system (also known as the output circuit). 2. Relay Contacts: You can trace along the circuit to find it. Relays generally have several main contacts, plus two coil contacts, similar to contactors. The main contacts are connected to the controlled system, while the coil contacts are connected to the control system. However, the contacts of a relay are usually visible.

18

4

Share

What are the differences between the Lamando 230 and 280?

When will the National VI emission standard be implemented in Hunan Province?

What to Do When the Fuel Pump is Noisy?

What is the tire model of the Cruze?

What are the differences between Maybach and Mercedes-Benz S?

How to Operate an Automatic Transmission at a Red Light?

Where is the Wuling Hongguang Wiper Relay Located?

What is the battery model of the Geely Emgrand?

How Many Types of Car Air Conditioning Are There?

How long after window tinting can you not roll down the windows?

Can a car tire with cracks on the side still be used?